scholarly journals SYNCHRONOUS OSCILLATIONS IN VAN DER POL GENERATOR WITH MODULATED NATURAL FREQUENCY

2015 ◽  
Vol 20 (4) ◽  
pp. 340-347
Author(s):  
A. Yu. Nimets ◽  
◽  
D. M. Vavriv ◽  
2013 ◽  
Vol 726 ◽  
pp. 624-655 ◽  
Author(s):  
Larry K. B. Li ◽  
Matthew P. Juniper

AbstractThe ability of hydrodynamically self-excited jets to lock into strong external forcing is well known. Their dynamics before lock-in and the specific bifurcations through which they lock in, however, are less well known. In this experimental study, we acoustically force a low-density jet around its natural global frequency. We examine its response leading up to lock-in and compare this to that of a forced van der Pol oscillator. We find that, when forced at increasing amplitudes, the jet undergoes a sequence of two nonlinear transitions: (i) from periodicity to ${ \mathbb{T} }^{2} $ quasiperiodicity via a torus-birth bifurcation; and then (ii) from ${ \mathbb{T} }^{2} $ quasiperiodicity to 1:1 lock-in via either a saddle-node bifurcation with frequency pulling, if the forcing and natural frequencies are close together, or a torus-death bifurcation without frequency pulling, but with a gradual suppression of the natural mode, if the two frequencies are far apart. We also find that the jet locks in most readily when forced close to its natural frequency, but that the details contain two asymmetries: the jet (i) locks in more readily and (ii) oscillates more strongly when it is forced below its natural frequency than when it is forced above it. Except for the second asymmetry, all of these transitions, bifurcations and dynamics are accurately reproduced by the forced van der Pol oscillator. This shows that this complex (infinite-dimensional) forced self-excited jet can be modelled reasonably well as a simple (three-dimensional) forced self-excited oscillator. This result adds to the growing evidence that open self-excited flows behave essentially like low-dimensional nonlinear dynamical systems. It also strengthens the universality of such flows, raising the possibility that more of them, including some industrially relevant flames, can be similarly modelled.


1999 ◽  
Vol 09 (11) ◽  
pp. 2197-2202 ◽  
Author(s):  
JULYAN H. E. CARTWRIGHT ◽  
VÍCTOR M. EGUÍLUZ ◽  
EMILIO HERNÁNDEZ-GARCÍA ◽  
ORESTE PIRO

The Burridge–Knopoff model of earthquake faults with viscous friction is equivalent to a van der Pol–FitzHugh–Nagumo model for excitable media with elastic coupling. The lubricated creep–slip friction law we use in Burridge–Knopoff model describes the frictional sliding dynamics of a range of real materials. Low-dimensional structures including synchronous oscillations and propagating fronts are dominant, in agreement with the results of laboratory friction experiments. Here we explore the dynamics of fronts in elastic excitable media.


2012 ◽  
Vol 11 (02) ◽  
pp. 1250002 ◽  
Author(s):  
X. Y. LI ◽  
J. H. YANG ◽  
X. B. LIU

The phenomenon of coherence resonance (CR) in a delayed noisy Van der Pol system with supercritical Hopf bifurcation, which is influenced by a recycled noise, is numerically studied. Different from the traditional CR theory, in this paper, the characteristics of CR is affected by the time delay in the input noise. Namely, the CR is weakened or enhanced by the time delay feedback. Moreover, we find that several characteristics of this particular system vary periodically and its period has some certain relation with the natural frequency. By using the results given by the paper, we can control the noise-induced motion by modulating the time delay in noise.


Author(s):  
Hiroshi Yabuno ◽  
Masaharu Kuroda ◽  
Takashi Someya ◽  
Masahiro Ohta ◽  
Ryohei Kokawa

We propose a van der Pol type self-excited micro-cantilever probe for AFM (atomic force microscope). Because the response frequency of self-excited oscillators is its natural frequency, the equivalent natural frequency depending on the atomic force is easily measured from detecting the response frequency of the self-excited micro-cantilever probe. While the amplitude of the linear self-excited oscillator grows with time, it can be kept very small by the nonlinear effect as van ver Pol oscillator. Therefore, if the micro-cantilever probe has the same dynamics as that of van Pol oscillator, the contact of the micro-cantilever to the material surface is prohibited and non-contact mode AFM is realized. In the present study, we design a van der Pol type micro-cantilever for the application to the practical AFM system.


2021 ◽  
Vol 24 (3) ◽  
pp. 56-62
Author(s):  
Valery V. Zaitsev ◽  
Alexander V. Karlov

Results of numerical simulation of self-oscillations synchronization process in two-cascade ring generator van der Pol by harmonic signal are presented. Studies were carried out within the framework of the DT- model of the dynamic system. The model was developed on the basis of the principle of compliance within the framework of the method of slowly changing amplitudes of characteristics of a discrete system with characteristics of an analog prototype. Shortened equations for complex oscillation amplitudes in generator stages are obtained. It was found that in an autonomous system there is an effect of bistability of amplitudes. In the synchronization mode with an external harmonic signal, solutions of shortened equations made it possible to calculate amplitude-frequency and phase-frequency characteristics of synchronous oscillations. It is shown that transitions between bistable states are observed in the synchronous oscillation holding band. Differences of frequency characteristics of synchronization of classical and two-stage oscillators van der Pol were analyzed.


2014 ◽  
Vol 59 (9) ◽  
pp. 932-938
Author(s):  
V.A. Danylenko ◽  
◽  
S.I. Skurativskyi ◽  
I.A. Skurativska ◽  
◽  
...  

2020 ◽  
Vol 15 (1) ◽  
pp. 37-44
Author(s):  
El Mehdi Echebba ◽  
Hasnae Boubel ◽  
Oumnia Elmrabet ◽  
Mohamed Rougui

Abstract In this paper, an evaluation was tried for the impact of structural design on structural response. Several situations are foreseen as the possibilities of changing the distribution of the structural elements (sails, columns, etc.), the width of the structure and the number of floors indicates the adapted type of bracing for a given structure by referring only to its Geometric dimensions. This was done by studying the effect of the technical design of the building on the natural frequency of the structure with the study of the influence of the distribution of the structural elements on the seismic response of the building, taking into account of the requirements of the Moroccan earthquake regulations 2000/2011 and using the ANSYS APDL and Robot Structural Analysis software.


Author(s):  
Masanori MATSUSHITA ◽  
Nobukatsu OKUIZUMI ◽  
Yasutaka SATOU ◽  
Osamu MORI ◽  
Takashi IWASA ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document