Fused Coupler Optical Switch Using a Photochromic Material

1991 ◽  
Vol 244 ◽  
Author(s):  
Yuji Kobayashi ◽  
Toshifumi Hosoya ◽  
Tsuyoshi Nonaka ◽  
Yasuo Matsuda

ABSTRACTAn optical switch based on a single-mode fused coupler has been fabricated. The switch is worked by light induced refractive index change of an organic photochromic compound as cladding material in the coupling region. The splitting ratio of optical output at 1.3 μ m wavelength light can change 44.5%. The optical loss in the switch is less than 0.4

1990 ◽  
Vol 29 (3) ◽  
pp. 191 ◽  
Author(s):  
Takeshi Kato ◽  
Hiroaki Inoue ◽  
Yasushi Takahashi ◽  
Koji K. Ishida

2020 ◽  
Vol 41 (2) ◽  
pp. 145-151 ◽  
Author(s):  
Zaineb Gharsallah ◽  
Monia Najjar ◽  
Vijay Janyani

AbstractIn this work, an optical switch based on electro-optic effect is reported. We used defect mode in two-dimensional photonic crystal made of Lithium Niobate. Under an applied voltage of 3 V, a refractive index change of −0.0702 is obtained which has led to a transmittance contrast about 60% for the ON state and a high extinction ratio of about 20 dB. Moreover, Slow light structure performance is investigated to optimize proposed optic switch. Due to elliptic shape of holes, the applied voltage is decreased to 0.5 V. Also, a refractive index change decrease around −0.0481, a transmittance contrast increase 65 %, and an extinction ratio increase by 5 dB have been observed. We used plan wave expansion and finite difference time domain methods to analyze the structures performances. It is seen that a defect mode shift about 40 nm and a switching length of 6.48 μm are obtained with drive voltage of 3 V for simple structure and only 0.5 V for slow light structure.


2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Guangzhong Ma ◽  
Runli Liang ◽  
Zijian Wan ◽  
Shaopeng Wang

AbstractQuantification of molecular interactions on a surface is typically achieved via label-free techniques such as surface plasmon resonance (SPR). The sensitivity of SPR originates from the characteristic that the SPR angle is sensitive to the surface refractive index change. Analogously, in another interfacial optical phenomenon, total internal reflection, the critical angle is also refractive index dependent. Therefore, surface refractive index change can also be quantified by measuring the reflectivity near the critical angle. Based on this concept, we develop a method called critical angle reflection (CAR) imaging to quantify molecular interactions on glass surface. CAR imaging can be performed on SPR imaging setups. Through a side-by-side comparison, we show that CAR is capable of most molecular interaction measurements that SPR performs, including proteins, nucleic acids and cell-based detections. In addition, we show that CAR can detect small molecule bindings and intracellular signals beyond SPR sensing range. CAR exhibits several distinct characteristics, including tunable sensitivity and dynamic range, deeper vertical sensing range, fluorescence compatibility, broader wavelength and polarization of light selection, and glass surface chemistry. We anticipate CAR can expand SPR′s capability in small molecule detection, whole cell-based detection, simultaneous fluorescence imaging, and broader conjugation chemistry.


2017 ◽  
Vol 26 (02) ◽  
pp. 1750025 ◽  
Author(s):  
M. K. Biswas ◽  
P. K. Das ◽  
E. Hoque ◽  
S. M. Sharafuddin ◽  
S. K. Das ◽  
...  

The present work studies the optical nonlinearity exhibited by the material (for Continuous Wave (CW) laser or long pulse) due to the change in thermal properties of the material on illumination. Thermal lens (TL) technique has been used to measure the refractive index change due to the formation of TL along with other thermo-optic properties of the material in solution. A CW Ar-ion laser has been used as light source and the laser beam was chopped at 25[Formula: see text]Hz frequency to obtain 12[Formula: see text]ms pulse to observe the formation of the TL within the sample. The [Formula: see text] value have been calculated by the TL technique for Benzene, Toluene and Dimethylaniline (DMA) in toluene and Benzene. The [Formula: see text] value is found to be in the order of 10[Formula: see text] to 10[Formula: see text][Formula: see text]cm2[Formula: see text]W[Formula: see text].


Sign in / Sign up

Export Citation Format

Share Document