Surface Cleaning Prior to Formation of Si/SiO2 Interfaces by Remote Plasma-Enhanced Chemical Vapor Deposition (RPECVD)

1992 ◽  
Vol 259 ◽  
Author(s):  
H. H. Lamb ◽  
S. Kalem ◽  
S. Bedge ◽  
T. Yasuda ◽  
Y. Ma ◽  
...  
Keyword(s):  
Chemical Vapor Deposition ◽  
Oxide Layer ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Surface Cleaning ◽  
Ex Situ ◽  
Dangling Bond ◽  
Remote Plasma ◽  
Carbon Contamination

ABSTRACTEx situ UV/O2 cleaning prior to SiO2 deposition by RPECVD results in an SiO2/Si interface with mid-gap Dit values 2-5 times higher than interfaces formed by in situ exposure of HF-etched wafers to plasma-generated atomic O. In situ exposures to plasma-generated atomic H and atomic O are each effective at removing carbon contamination acquired by the UV/O2 cleaned wafers during transfer and introduction to the RPECVD chamber. However, in situ exposure of the photochemical oxide layer to atomic O results in higher mid-gap Dit values, and in situ exposure to atomic H results in creation of dangling bond defects (Pb centers).

Low-temperature Si in-situ cleaning and homoepitaxy by remote plasma-enhanced chemical vapor deposition

1990 ◽  
Author(s):  
Ting-Chen Hsu ◽  
Brian G. Anthony ◽  
Louis H. Breaux ◽  
Rong Z. Qian ◽  
Sanjay K. Banerjee ◽  
...  
Keyword(s):  
Chemical Vapor Deposition ◽  
Low Temperature ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Remote Plasma

Remote Plasma-Enhanced Chemical Vapor Deposition of Epitaxial Silicon on Silicon (100) at 150°C

1989 ◽  
Vol 165 ◽  
Author(s):  
T. Hsu ◽  
B. Anthony ◽  
L. Breaux ◽  
S. Banerjee ◽  
A. Tasch
Keyword(s):  
Chemical Vapor Deposition ◽  
Low Temperature ◽  
Vapor Deposition ◽  
Hydrogen Plasma ◽  
High Vacuum ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Epitaxial Silicon ◽  
Remote Plasma ◽  
Silicon Epitaxy

AbstractLow temperature processing will be an essential requirement for the device sizes, structures, and materials being considered for future integrated circuit applications. In particular, low temperature silicon epitaxy will be required for new devices and technologies utilizing three-dimensional epitaxial structures and silicon-based heterostructures. A novel technique, Remote Plasma-enhanced Chemical Vapor Deposition (RPCVD), has achieved epitaxial silicon films at a temperature as low as 150°C which is believed to be the lowest temperature to date for silicon epitaxy. The process relies on a stringent ex-situ preparation procedure, a controlled wafer loading sequence, and an in-situ remote hydrogen plasma clean of the sample surface, all of which provide a surface free of carbon, oxygen, and other contaminants. The system is constructed using ultra-high vacuum technology (10-10 Torr) to achieve and maintain contaminantion-free surfaces and films. Plasma excitation of argon is used in lieu of thermal energy to provide energetic species that dissociate silane and affect surface chemical processes. Excellent crystallinity is observed from the thin films grown at 150°C using the analytical techniques of Transmission Electron Microscopy (TEM) and Nomarski interference contrast microscopy after defect etching.

Low Temperature Silicon Epitaxial Growth by Plasma Enhanced Chemical Vapor Deposition From SiH4/He/H2

1991 ◽  
Vol 235 ◽  
Author(s):  
Yung-Jen Lin ◽  
Ming-Deng Shieh ◽  
Chiapying Lee ◽  
Tri-Rung Yew
Keyword(s):  
Electron Microscopy ◽  
Chemical Vapor Deposition ◽  
Epitaxial Growth ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Epitaxial Layers ◽  
Cross Sectional ◽  
Transmission Electron

ABSTRACTSilicon epitaxial growth on silicon wafers were investigated by using plasma enhanced chemical vapor deposition from SiH4/He/H2. The epitaxial layers were growm at temperatures of 350°C or lower. The base pressure of the chamber was greater than 2 × 10−5 Torr. Prior to epitaxial growth, the wafer was in-situ cleaned by H2 baking for 30 min. The epi/substrate interface and epitaxial layers were observed by cross-sectional transmission electron microscopy (XTEM). Finally, the influence of the ex-situ and in-situ cleaning processes on the qualities of the interface and epitaxial layers was discussed in detail.

In-Situ Observation of Chemical Vapor Deposition of Thin Sige Films by Optical Reflection Interferometry

1994 ◽  
Vol 375 ◽  
Author(s):  
G. Ritter ◽  
B. Tillack ◽  
M. Weidner ◽  
F. G. Böbel ◽  
B. Hertel
Keyword(s):  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Deposition Process ◽  
Ex Situ ◽  
In Situ Observation ◽  
Optical Reflection ◽  
Initial Stage

AbstractChemical Vapor Deposition of Si1-x Gex – films on Si (100) and of polycrystalline Si1-x Gex, layers on SiO2 – coated substrates have been performed at a pressure of 200 Pa in the temperature range of 500°C – 800°C, correspondingly. To observe the growth process and to characterize the growing thin films at deposition conditions an optical reflection interferometer (PYRITIERS) has been used. Comparing the data obtained at growth temperature with ex- situ measurements by spectroscopic ellipsometry the temperature dependence of optical constants of SiGe films have been evaluated. The reflectivity measurements during the deposition process allow to study the quality of the heteroepitaxial film, even in the initial stage of epitaxial growth.

Low Temperature Silicon Epitaxial Growth by Plasma Enhanced Chemical Vapor Deposition from SiH4/He/H2

1991 ◽  
Vol 236 ◽  
Author(s):  
Yung-Jen Lin ◽  
Ming-Deng Shieh ◽  
Chiapying Lee ◽  
Tri-Rung Yew
Keyword(s):  
Electron Microscopy ◽  
Chemical Vapor Deposition ◽  
Epitaxial Growth ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Epitaxial Layers ◽  
Cross Sectional ◽  
Transmission Electron

AbstractSilicon epitaxial growth on silicon wafers were investigated by using plasma enhanced chemical vapor deposition from SiH4/He/H2. The epitaxial layers were growm at temperatures of 350°C or lower. The base pressure of the chamber was greater than 2 × 10−5 Torr. Prior to epitaxial growth, the wafer was in-situ cleaned by H2 baking for 30 min. The epi/substrate interface and epitaxial layers were observed by cross-sectional transmission electron microscopy (XTEM). Finally, the influence of the ex-situ and in-situ cleaning processes on the qualities of the interface and epitaxial layers was discussed in detail.

scholarly journals In Situ Measurement of Carbon Nanotube Growth Kinetics in a Rapid Thermal Chemical Vapor Deposition Reactor With Multizone Infrared Heating

2020 ◽  
Vol 8 (1) ◽  
Author(s):  
Moataz Abdulhafez ◽  
Jaegeun Lee ◽  
Mostafa Bedewy
Keyword(s):  
Chemical Vapor Deposition ◽  
Carbon Nanotube ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Infrared Heating ◽  
Ex Situ ◽  
Depth Of Field ◽  
Carbon Nanotube Growth ◽  
Nanotube Growth

Abstract Understanding and controlling the growth of vertically aligned carbon nanotube (VACNT) forests by chemical vapor deposition (CVD) is essential for unlocking their potential as candidate materials for next generation energy and mass transport devices. These advances in CNT manufacturing require developing in situ characterization techniques capable of interrogating how CNTs grow, interact, and self-assemble. Here we present a technique for real-time monitoring of VACNT forest height kinetics applied to a unique custom designed rapid thermal processing (RTP) reactor for CVD of VACNTs. While the integration of multiple infrared heating lamps enables creating designed spatiotemporal temperature profiles inside the reactor, they pose challenges for in situ measurements. Hence, our approach relies on contrast-adjusted videography and image processing, combined with calibration using 3D optical microscopy with large depth-of-field. Our work enables reliably measuring VACNT growth rates and catalytic lifetimes, which are not possible to measure using ex situ methods.

Characterization of In Situ P-Type and N-Type Doped Si and GeXSi1−X Films Grown by Low Temperature Remote Plasma Chemical Vapor Deposition

1992 ◽  
Vol 268 ◽  
Author(s):  
S. Thomas ◽  
J. Irby ◽  
D. Kinosky ◽  
R. Qian ◽  
I. Iqbal ◽  
...  
Keyword(s):  
Chemical Vapor Deposition ◽  
Low Temperature ◽  
Vapor Deposition ◽  
Chemical Vapor ◽  
Future Generation ◽  
Doping Profile ◽  
Remote Plasma ◽  
Plasma Chemical Vapor Deposition ◽  
P Type

ABSTRACTLow temperature Si and Si1−xGex epitaxy is one of the major thrusts in the trend towards low temperature Si processing for future generation ULSI circuits and novel Si-based devices. A remote plasma-enhanced chemical vapor deposition (RPCVD) technique has been developed to achieve Si homoepitaxy and Si1−xGex heteroepitaxy at low temperatures (≤450'C). P-type films have been grown by introducing 90 ppm or 5000 ppm B2H6/He into the system during the growth process to achieve in situ electrically active boron doping. A mesa diode structure with minimal thermal budget in the fabrication process has been employed to evaluate the properties of the boron-doped Si and Si1−xGex films grown at 450°C by RPCVD. Leakage current densities are reduced for diodes grown at 14–18 W (40–50 Å/min. growth rates) compared to similar devices grown at 6.6 W (5 Å/min.). N-type films have been grown by the introduction of 50 ppm PH3/He. Secondary ion mass spectroscopy (SIMS) has been employed to analyze the boron and phosphorus incorporation efficiencies and doping profiles under different conditions. Boron and phosphorus doping profile transitions as sharp as 50–100 Å/decade have been achieved. Transmission electron microscopy (TEM) has been used to investigate the microstructure of the B-doped films.

scholarly journals In-situ magnetization measurements and ex-situ morphological analysis of electrodeposited cobalt onto chemical vapor deposition graphene/SiO2/Si

2017 ◽  
Vol 21 ◽  
pp. 16-22 ◽  
Author(s):  
Vinicius C. De Franco ◽  
Gustavo M.B. Castro ◽  
Jeaneth Corredor ◽  
Daniel Mendes ◽  
Joao E. Schmidt
Keyword(s):  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Morphological Analysis ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Magnetization Measurements ◽  
Chemical Vapor Deposition Graphene

Comparing electrical characteristics of in situ and ex situ Al2O3/GaN interfaces formed by metalorganic chemical vapor deposition

2018 ◽  
Vol 11 (4) ◽  
pp. 041002 ◽  
Author(s):  
Silvia H. Chan ◽  
Davide Bisi ◽  
Maher Tahhan ◽  
Chirag Gupta ◽  
Steven P. DenBaars ◽  
...  
Keyword(s):  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
Ex Situ ◽  
Electrical Characteristics ◽  
Metalorganic Chemical
Sign in / Sign up

Export Citation Format

Share Document