Electrical Properties of Crystalline and Amorphous Pb(ZrxTi1−x)O3 Thin Films Prepared by the Sol-Gel Technique

1992 ◽  
Vol 271 ◽  
Author(s):  
Yuhuan Xu ◽  
Chih-Hsing Cheng ◽  
Ren Xu ◽  
John D. Mackenzie
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Ferroelectric Properties ◽  
Sol Gel ◽  
Dip Coating ◽  
Metal Substrate ◽  
Pzt Thin Films ◽  
Heat Treated ◽  
Pzt Films ◽  
Gel Technique

ABSTRACTPb(ZrxTi1−x)O3 (PZT) solutions were prepared by reacting lead 2-ethylhexanoate with titanium n-propoxide and zirconium n-propoxide. Films were deposited on several kinds of metal substrate by dip-coating. Crystalline PZT films and amorphous PZT films were heat-treated for 1 hour at 650°C and at 400°C, respectively. Electrical properties including dielectric, pyroelectric and ferroelectric properties of both crystalline and amorphous PZT films were measured and compared. The amorphous PZT thin films exhibited ferroelectric-like behaviors.

EFFECT OF PRE-HEATING TEMPERATURE ON THE CHARACTERISTICS OF PZT THIN FILMS GROWN BY USING A TRIOL SOL–GEL ROUTE

2007 ◽  
Vol 14 (02) ◽  
pp. 229-234
Author(s):  
SARAWUT THOUNTOM ◽  
MANOCH NAKSATA ◽  
KENNETH MACKENZIE ◽  
TAWEE TUNKASIRI
Keyword(s):  
Thin Films ◽  
Lead Zirconate Titanate ◽  
Heating Temperature ◽  
Ferroelectric Properties ◽  
Sol Gel ◽  
Hysteresis Loops ◽  
Lead Zirconate ◽  
Pzt Thin Films ◽  
Pzt Films ◽  
Ferroelectric Hysteresis

Lead zirconate titanate (PZT) films with compositions near the morphotropic phase boundary were fabricated on Pt (111)/ Ti / SiO 2/ Si (100) using the triol sol–gel method. The effect of the pre-heating temperature on the phase transformations, microstructures, electrical properties, and ferroelectric properties of the PZT thin films was investigated. Randomly oriented PZT thin films pre-heated at 400°C for 10 min and annealed at 600°C for 30 min showed well-defined ferroelectric hysteresis loops with a remnant polarization of 26.57 μC/cm2 and a coercive field of 115.42 kV/cm. The dielectric constant and dielectric loss of the PZT films were 621 and 0.0395, respectively. The microstructures of the thin films are dense, crack-free, and homogeneous with fine grains about 15–20 nm in size.

scholarly journals Robust ferroelectricity enhancement of PZT thin films by a homogeneous seed layer

2021 ◽  
Author(s):  
jie jiang ◽  
Lei Liu ◽  
Kuo Ouyang ◽  
Zhouyu Chen ◽  
Shengtao Mo ◽  
...  
Keyword(s):  
Thin Films ◽  
Electrical Properties ◽  
Remanent Polarization ◽  
Perovskite Phase ◽  
Ferroelectric Properties ◽  
Sol Gel ◽  
Pzt Thin Films ◽  
Large Dielectric Constant ◽  
Sol Gel Process ◽  
A New Technique

Abstract With its excellent ferroelectric properties such as large dielectric constant and large remanent polarization, PZT thin films are extensively used in micro-sensors and other devices. In this study, the sol-gel process was used to fabricate Pb(Zr0.52Ti0.48)O3 thin films with Pb(ZrxTi1−x)O3 seed islands. The experimental consequences demonstrate that all the Pb(Zr0.52Ti0.48)O3 thin films with Pb(ZrxTi1−x)O3 seeds show pure perovskite phase with no other impurity phases, and the electrical properties of Pb(Zr0.52Ti0.48)O3 thin films modified by Pb(ZrxTi1−x)O3 seed islands with different Zr/Ti ratios are improved, such as remanent polarization increased, dielectric properties increased, coercive electric field decreased, leakage current density decreased, etc. In particular, the electrical properties of the Pb(Zr0.52Ti0.48)O3 thin films with Pb(ZrxTi1−x)O3 seed islands are the most optimal when the x is 0.52. This paper provides a new technique for optimizing the electrical properties of PZT thin films, which is of great significance for breaking through the bottleneck of the development of ferroelectric memory.

The Characterization and Electrical Properties of DOPED PZT Thin Films Prepared by Sol-Gel Processing

1994 ◽  
Vol 361 ◽  
Author(s):  
Wan In Lee ◽  
J.K. Lee ◽  
Elsub Chung ◽  
C.W. Chung ◽  
I.K. Yoo ◽  
...  
Keyword(s):  
Thin Films ◽  
Grain Size ◽  
Remanent Polarization ◽  
Ferroelectric Properties ◽  
Sol Gel ◽  
Current Level ◽  
Pzt Thin Films ◽  
Sol Gel Process ◽  
Pzt Films ◽  
Gel Processing

ABSTRACTPZT (Zr/Ti = 53/47), PNZT (4% Nb doped PZT), PSZT (2% Sc doped PZT), and PSNZT (1% Sc and 1% Nb doped PZT) thin films were prepared by a sol-gel process. They were characterized by XRD, SEM and TEM. Both crystallographic orientation and grain size of PZT films can be changed by doping. Pt/PZT/Pt capacitors were fabricated for the measurement of ferroelectric properties. By doping with both Sc and Nb, the fatigue performance of the PZT films was considerably improved and the coercive field was decreased, while the remanent polarization was not changed. In addition, the effect of dopants on the leakage current level of PZT films was studied.

Effect of Pb Excess Content on Microstructure and Electrical Properties of Sol Gel Derived PZT Thin Films

1999 ◽  
Vol 596 ◽  
Author(s):  
Zhan-jie Wang ◽  
Ryutaro Maeda ◽  
Kaoru Kikuchi
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Lead Zirconate Titanate ◽  
Perovskite Phase ◽  
Ferroelectric Properties ◽  
Sol Gel ◽  
Lead Zirconate ◽  
Pzt Thin Films ◽  
Starting Solution ◽  
Pzt Films

AbstractLead zirconate titanate (PZT) thin films were fabricated by a three-step heat-treatment process which involves the addition of -10, 0 and 10 mol% excess Pb to the starting solution and spin coating onto Pt/Ti/SiO2/Si substrates. Crystalline phases as well as preferred orientations in PZT films were investigated by X-ray diffraction analysis (XRD). The microstructure and composition of the films were studied by scanning electron microscopy (SEM), transmission electron microscopy (TEM) and electron probe microanalysis (EPMA), respectively. The well-crystallized perovskite phase and the (100) preferred orientation were obtained by adding 10% excess Pb to the starting solution. It was found that PZT films to which 10% excess Pb was added had better electric properties. The remanent polarization and the coercive field of this film were 34.8 μC/cm2 and 41.7 kV/cm, while the dielectric constant and loss values measured at 1 kHz were approximately 1600 and 0.04, respectively. Dielectric and ferroelectric properties were correlated to the microstructure of the films.

The Effect of RuO2/Pt Hybrid Bottom Electrode Structure on The Microstructure and Ferroelectric Properties of Sol-Gel Derived PZT Thin Films

1997 ◽  
Vol 493 ◽  
Author(s):  
Seung-Hyun Kim ◽  
J. G. Hong ◽  
J. C. Gunter ◽  
H. Y. Lee ◽  
S. K. Streiffer ◽  
...  
Keyword(s):  
Thin Films ◽  
Leakage Current ◽  
Bottom Electrode ◽  
Ferroelectric Properties ◽  
Sol Gel ◽  
Chemical Solution ◽  
Electrode Structure ◽  
Solution Deposition ◽  
Pzt Thin Films ◽  
Chemical Solution Deposition Method

ABSTRACTFerroelectric PZT thin films on thin RuO2 (10, 30, 50nm)/Pt hybrid bottom electrodes were successfully prepared by using a modified chemical solution deposition method. It was observed that the use of a lOnm RuO2Pt bottom electrode reduced leakage current, and gave more reliable capacitors with good microstructure compare to the use of thicker RuO2/Pt bottom electrodes. Typical P-E hysteresis behavior was observed even at an applied voltage of 3V, demonstrating greatly improved remanence and coercivity. Fatigue and breakdown characteristics, measured at 5V, showed stable behavior, and only below 13-15% degradation was observed up to 1010 cycles. Thicker RuO2 layers resulted in high leakage current density due to conducting lead ruthenate or PZT pyrochlore-ruthenate and a rosette-type microstructure.

Preparation and characterization of V2O5 doped SiO2-TiO2 thin films

2012 ◽  
Vol 2 (1) ◽  
Author(s):  
Marek Nocuń ◽  
Sławomir Kwaśny
Keyword(s):  
Thin Films ◽  
Band Gap ◽  
Photoelectron Spectroscopy ◽  
Sol Gel ◽  
Dip Coating ◽  
Band Gap Energy ◽  
Tio2 Thin Films ◽  
Glass Substrates ◽  
Gel Technique

AbstractIn our investigation, V doped SiO2/TiO2 thin films were prepared on glass substrates by dip coating sol-gel technique. Chemical composition of the samples was studied by X-ray photoelectron spectroscopy (XPS). Transmittance of the samples was characterized using UV-VIS spectrophotometry. Subsequently band-gap energy (Eg) was estimated for these films. Powders obtained from sols were characterized by FTIR spectroscopy. It was found that vanadium decreases optical band gap of SSiO2/TiO2 films.

Low-temperature preparation of highly (111) oriented PZT thin films by a modified sol–gel technique

2000 ◽  
Vol 208 (1-4) ◽  
pp. 541-545 ◽  
Author(s):  
X.J Meng ◽  
J.G Cheng ◽  
B Li ◽  
S.L Guo ◽  
H.J Ye ◽  
...  
Keyword(s):  
Thin Films ◽  
Low Temperature ◽  
Sol Gel ◽  
Pzt Thin Films ◽  
Low Temperature Preparation ◽  
Gel Technique ◽  
Temperature Preparation

Electrooptic Properties of Pzt thin Films for Image Storage Applications

1991 ◽  
Vol 243 ◽  
Author(s):  
D. Dimos ◽  
R.W. Schwartz
Keyword(s):  
Thin Films ◽  
Sol Gel ◽  
Ferroelectric Films ◽  
Image Storage ◽  
Pzt Thin Films ◽  
Hysteresis Behavior ◽  
Pzt Films ◽  
Induced Changes

AbstractThe photocurrent responses, photo-induced changes in hysteresis behavior, and electrooptic (birefringence) effects of sol-gel derived PZT films have been characterized as part of an effort to evaluate ferroelectric films for image storage and processing applications.

Sign in / Sign up

Export Citation Format

Share Document