scholarly journals Structural Characterization of SiF4, SiH4 and H2 Hot-Wire-Grown Microcrystalline Silicon Thin Films with Large Grains

2001 ◽  
Vol 664 ◽  
Author(s):  
J. J. Gutierrez ◽  
C. E. Inglefield ◽  
C. P. An ◽  
M. C. DeLong ◽  
P. C. Taylor ◽  
...  

ABSTRACTIn this paper, we present a comprehensive study of microcrystalline silicon thin film samples deposited by a novel growth process intended to maximize their grain size and crystal volume fraction. Using Atomic Force Microscopy, Raman spectroscopy, and x ray diffraction the structural properties of these samples were characterized qualitatively and quantitatively. Samples were grown using a Hot-Wire Chemical Vapor Deposition process with or without a post-growth hot-wire annealing treatment. During Hot-Wire Chemical Vapor Deposition, SiF4 is used along with SiH4 and H2 to grow the thin films. After growth, some samples received an annealing treatment with only SiF4 and H2 present. These samples were compared to each other in order to determine the deposition conditions that maximize grain size. Large microcrystalline grains were found to be aggregates of much smaller crystallites whose size is nearly independent of deposition type and post-annealing treatment. Thin films deposited using the deposition process with SiF4 partial flow rate of 2 sccm and post-growth annealing treatment had the largest aggregate grains ∼.5 µm and relatively high crystal volume fraction.

1999 ◽  
Vol 557 ◽  
Author(s):  
D. Peiró ◽  
C. Voz ◽  
J. Bertomeu ◽  
J. Andreu ◽  
E. Martínez ◽  
...  

AbstractHydrogenated microcrystalline silicon films have been obtained by hot-wire chemical vapor deposition (HWCVD) in a silane and hydrogen mixture at low pressure (<5 × 10-2 mbar). The structure of the samples and the residual stress were characterised by X- ray diffraction (XRD). Raman spectroscopy was used to estimate the volume fraction of the crystalline phase, which is in the range of 86 % to 98%. The stress values range between 150 and -140 MPa. The mechanical properties were studied by nanoindentation. Unlike monocrystalline wafers, there is no evidence of abrupt changes in the force-penetration plot, which have been attributed to a pressure-induced phase transition. The hardness was 12.5 GPa for the best samples, which is close to that obtained for silicon wafers.


2000 ◽  
Vol 360 (1-2) ◽  
pp. 205-212 ◽  
Author(s):  
M. Zhu ◽  
X. Guo ◽  
G. Chen ◽  
H. Han ◽  
M. He ◽  
...  

2000 ◽  
Vol 609 ◽  
Author(s):  
Takashi Itoh ◽  
Noriyuki Yamana ◽  
Hiroki Inouchi ◽  
Norimitsu Yoshida ◽  
Hidekuni Harada ◽  
...  

ABSTRACTHydrogenated microcrystalline silicon (μc-Si:H) films are prepared by hot-wire assisted plasma enhanced chemical vapor deposition, which controls the hydrogen radical density by filament temperatures, Tf, without changing other conditions. The effect of hydrogen radical on the properties of incorporated hydrogen into μc-Si:H films is studied using infrared absorption and gas effusion spectroscopies. The hydrogen concentration decreases with increasing Tf. The crystalline volume fraction, Xc, increases with Tf and shows a peak at Tf of 1850 °C. Integrated intensities of the modes near 2000 and 2100 cm-1 decrease with increasing Tf. Integrated intensity of the mode near 880 cm-1 shows almost same tendency of Xc. The effect of hydrogen radical on the properties of incorporated hydrogen into μc-Si:H films is discussed.


1995 ◽  
Vol 377 ◽  
Author(s):  
P. Brogueira ◽  
V. Chu ◽  
J. P. Conde

ABSTRACTThe conductivity and the structural properties of thin films deposited by Hot-Wire Chemical Vapor Deposition (HW-CVD) from silane and hydrogen at a substrate temperature of 220 °C are shown to be strongly dependent on the filament temperature, Tfil, and process pressure, p. Amorphous silicon films are obtained at low pressures, p < 3 × 10−2Torr, for Tfil ∼ 1900 °C and FH2 = FSiH4. At this TfilJU, high deposition rates are observed, both with and without hydrogen dilution, and no silicon was deposited on the filaments. At Tfil ∼ 1500 °C, a transition from a-Si:H for p > 0.3 Torr to microcrystalline silicon (μc-Si:H) for p < 0.1 Torr occurs. In this temperature regime, silicon growth on the filaments is observed. /ic-Si:H growth both without hydrogen dilution and also in very thin films (∼ 0.05 μm) is achieved. Raman and X-Ray spectra give typical grain sizes of 10 – 20 nm, with a crystalline fraction higher than 50%. For both, Tju ∼ 1500 °C, p > 0.3 Torr and Tfil ∼ 1900 °C and p ∼ 2.7 × 10−2Torr, an increase of the crystalline fraction from 0 to ∼ 30% is observed when the hydrogen dilution, FH2/FSiH4, increases from 1 to > 4.


2006 ◽  
Vol 501 (1-2) ◽  
pp. 133-136 ◽  
Author(s):  
Jean-Eric Bourée ◽  
Sandesh R. Jadkar ◽  
Samir Kasouit ◽  
Régis Vanderhaghen

Sign in / Sign up

Export Citation Format

Share Document