Performance Analysis of Acoustic Receiving Devices Functioning in a Car Cabin Based on Computer Modeling of a Sound Field

2004 ◽  
Vol 31 (3) ◽  
pp. 267-283
Author(s):  
V. B. Galanenko ◽  
A. Ya. Kalyuzhny ◽  
A. A. Kovtonyuk
Keyword(s):  
Performance Analysis ◽  
Computer Modeling ◽  
Sound Field

Quantifying Non-Linearity in Early Decay Curves of Measured and Computer-Modeled Room Impulse Responses of a Highly Non-Diffuse Room Exhibiting Flutter Echo

2020 ◽  
Author(s):  
Heather L. Lai ◽  
Brian Hamilton
Keyword(s):  
Linear Regression ◽  
Computer Modeling ◽  
Impulse Response ◽  
Decay Curve ◽  
Sound Field ◽  
Energy Decay ◽  
Room Acoustics ◽  
Reverberation Time ◽  
Sound Fields ◽  
Regression Curves

Abstract This paper investigates the use of two room acoustics metrics designed to evaluate the degree to which the linearity assumptions of the energy density curves are valid. The study focuses on measured and computer-modeled energy density curves derived from the room impulse response of a space exhibiting a highly non-diffuse sound field due to flutter echo. In conjunction with acoustical remediation, room impulse response measurements were taken before and after the installation of the acoustical panels. A very dramatic decrease in the reverberation time was experienced due to the addition of the acoustical panels. The two non-linearity metrics used in this study are the non-linearity parameter and the curvature. These metrics are calculated from the energy decay curves computed per octave band, based on the definitions presented in ISO 3382-2. The non-linearity parameter quantifies the deviation of the EDC from a straight line fit used to generated T20 and T30 reverberation times. Where the reverberation times are calculated based on a linear regression of the data relating to either −5 to −25 dB for T20 or −5 to −35 dB for T30 reverberation time calculations. This deviation is quantified using the correlation coefficient between the energy decay curve and the linear regression for the specified data. In order to graphically demonstrate these non-linearity metrics, the energy decay curves are plotted along with the linear regression curves for the T20 and T30 reverberation time for both the measured data and two different room acoustics computer-modeling techniques, geometric acoustics modeling and finite-difference wave-based modeling. The intent of plotting these curves together is to demonstrate the relationship between these metrics and the energy decay curve, and to evaluate their use for quantifying degree of non-linearity in non-diffuse sound fields. Observations of these graphical representations are used to evaluate the accuracy of reverberation time estimations in non-diffuse environments, and to evaluate the use of these non-linearity parameters for comparison of different computer-modeling techniques or room configurations. Using these techniques, the non-linearity parameter based on both T20 and T30 linear regression curves and the curvature parameter were calculated over 250–4000 Hz octave bands for the measured and computer-modeled room impulse response curves at two different locations and two different room configurations. Observations of these calculated results are used to evaluate the consistency of these metrics, and the application of these metrics to quantifying the degree of non-linearity of the energy decay curve derived from a non-diffuse sound field. These calculated values are also used to evaluate the differences in the degree of diffusivity between the measured and computer-modeled room impulse response. Acoustical computer modeling is often based on geometrical acoustics using ray-tracing and image-source algorithms, however, in non-diffuse sound fields, wave based methods are often able to better model the characteristic sound wave patterns that are developed. It is of interest to study whether these improvements in the wave based computer-modeling are also reflected in the non-linearity parameter calculations. The results showed that these metrics provide an effective criteria for identifying non-linearity in the energy decay curve, however for highly non-diffuse sound fields, the resulting values were found to be very sensitive to fluctuations in the energy decay curves and therefore, contain inconsistencies due to these differences.

scholarly journals Performance analysis of the rolling equipment using computer modeling

2018 ◽  
Vol 411 ◽  
pp. 012081
Author(s):  
A R Fastykovskiy ◽  
V N Peretyatko ◽  
V V Evstifeev ◽  
O Yu Efimov
Keyword(s):  
Performance Analysis ◽  
Computer Modeling ◽  
Rolling Equipment

Acoustic Performance Analysis of Impedance Compound Muffler with Aluminum Foam

2011 ◽  
Vol 279 ◽  
pp. 253-257
Author(s):  
Huai Qian Bao ◽  
Chang Tian Wang ◽  
Jun Li
Keyword(s):  
Performance Analysis ◽  
Boundary Conditions ◽  
Noise Reduction ◽  
Frequency Band ◽  
High Frequency ◽  
Aluminum Foam ◽  
Sound Field ◽  
Acoustic Properties ◽  
Acoustic Performance ◽  
The Common

The common reactive muffler has poor acoustic properties in high frequency, so aluminum foam is applied to the reactive muffler and the impendence compound muffler is designed. The acoustic performance of the muffler is analyzed; the interior sound field of the muffler is modeled and meshed in the ANSYS, then they are imported into SYSNOISE, and imposed reasonable boundary conditions to carry out the analysis of acoustic performance of the muffler. The results show that, compared to reactive muffler, the muffler with aluminum foam has a higher amount of noise reduction and a wider frequency band in middle and high frequency.

scholarly journals VITRUVIUS ON THE VALUE OF MUSIC FOR ENHANCING THE ARCHITECTURE OF THE ANTIQUE THEATER’S AUDIENCE SPACE. Part 1

2020 ◽  
pp. 10-10
Author(s):  
Yuriy I. Isakov
Keyword(s):  
Computer Modeling ◽  
Sound Field ◽  
Acoustic Parameters ◽  
Standard Algorithm ◽  
Modeling Methods ◽  
Ancient Theater ◽  
Published Research

Vitruvius' legacy points to the importance of music in architecture for enhancing the acoustics of ancient theaters. In particular, he described in detail the sounding vessels, or ηχεια – “echea”, the effectiveness of which has not been proven. The effect of “echeas” on the acoustic parameters of a small classical Greek theater is investigated using computer modeling methods. The theater models developed take into account Vitruvius' recommendations and published research and measurements of ancient theater acoustic parameters reconstructed in our time. The descriptions of Vitruvius and the musical theories of Aristoxenus and Pythagoras were considered when developing the “echeas” models. Using the standard algorithm of the EASE4.4 program, the parameters of a small theater were calculated and the C50, C80, STI acoustic parameters of the theater’s sound field were found to benefit from the “echeas” or sounding vessels.

Decay of Temporary Threshold Shift in Noise

1973 ◽  
Vol 16 (2) ◽  
pp. 267-270 ◽  
Author(s):  
John H. Mills ◽  
Seija A. Talo ◽  
Gloria S. Gordon
Keyword(s):  
Sound Field ◽  
Threshold Shift ◽  
Temporary Threshold Shift ◽  
Octave Band ◽  
Band Noise ◽  
Lower Asymptote

Groups of monaural chinchillas trained in behavioral audiometry were exposed in a diffuse sound field to an octave-band noise centered at 4.0 k Hz. The growth of temporary threshold shift (TTS) at 5.7 k Hz from zero to an asymptote (TTS ∞ ) required about 24 hours, and the growth of TTS at 5.7 k Hz from an asymptote to a higher asymptote, about 12–24 hours. TTS ∞ can be described by the equation TTS ∞ = 1.6(SPL-A) where A = 47. These results are consistent with those previously reported in this journal by Carder and Miller and Mills and Talo. Whereas the decay of TTS ∞ to zero required about three days, the decay of TTS ∞ to a lower TTS ∞ required about three to seven days. The decay of TTS ∞ in noise, therefore, appears to require slightly more time than the decay of TTS ∞ in the quiet. However, for a given level of noise, the magnitude of TTS ∞ is the same regardless of whether the TTS asymptote is approached from zero, from a lower asymptote, or from a higher asymptote.

Modified Earpieces and CROS for High Frequency Hearing Losses

1968 ◽  
Vol 11 (1) ◽  
pp. 204-218 ◽  
Author(s):  
Elizabeth Dodds ◽  
Earl Harford
Keyword(s):  
Hearing Loss ◽  
Hearing Aids ◽  
High Frequency ◽  
Hearing Aid ◽  
Sound Field ◽  
Intensity Level ◽  
Test Results ◽  
High Frequency Hearing Loss ◽  
Increased Sensitivity ◽  
Difficult Cases

Persons with a high frequency hearing loss are difficult cases for whom to find suitable amplification. We have experienced some success with this problem in our Hearing Clinics using a specially designed earmold with a hearing aid. Thirty-five cases with high frequency hearing losses were selected from our clinical files for analysis of test results using standard, vented, and open earpieces. A statistical analysis of test results revealed that PB scores in sound field, using an average conversational intensity level (70 dB SPL), were enhanced when utilizing any one of the three earmolds. This result was due undoubtedly to increased sensitivity provided by the hearing aid. Only the open earmold used with a CROS hearing aid resulted in a significant improvement in discrimination when compared with the group’s unaided PB score under earphones or when comparing inter-earmold scores. These findings suggest that the inclusion of the open earmold with a CROS aid in the audiologist’s armamentarium should increase his flexibility in selecting hearing aids for persons with a high frequency hearing loss.

Sign in / Sign up

Export Citation Format

Share Document