Attenuation of earthquake ground motion in Japan including deep focus events

1995 ◽  
Vol 85 (5) ◽  
pp. 1343-1358
Author(s):  
Gilbert L. Molas ◽  
Fumio Yamazaki
Keyword(s):  
Ground Motion ◽  
Peak Ground Acceleration ◽  
Soil Classification ◽  
Peak Ground Velocity ◽  
Earthquake Ground Motion ◽  
Ground Acceleration ◽  
Attenuation Relations ◽  
Distance Dependence ◽  
Recording Station ◽  
Deep Focus

Abstract New attenuation equations for peak ground acceleration and velocity for Japan are developed. The equations are derived using extensive data recorded by the new JMA-87-type accelerometers, which do not require instrumental corrections that the older SMAC-type accelerometers do. Earthquakes with depths up to 200 km are used to make the equation applicable to subduction zone regions, which are common in Japan. Effects of depth and local site on the attenuation are considered simultaneously with the distance dependence and magnitude dependence using a two-stage regression procedure to separate the magnitude dependence from the distance dependence. Since the resulting normal equations become singular, an iterative partial regression algorithm is proposed. It is found that for the same magnitude and distance, peak ground motion increases as depth increases. The variation of the station coefficients with respect to the corresponding soil-type classification is quite wide. The station coefficients for the peak ground acceleration are found to be weakly correlated with the general soil classification, while a stronger correlation was found for the peak ground velocity. The resulting attenuation relations are given by log10PGA=0.206+0.477MJ−log10r−0.00144r−0.00144r+0.00311h+cia,log10PGV=−1.769+0.628MJ−log10r−0.00130r−0.00144r+0.00222h+civ, where PGA (cm/sec2) and PGV (cm/sec) are the larger of the peak accelerations and velocities from two horizontal components, MJ is the JMA magnitude, r is the closest distance to the fault rupture, h is the depth, and ci is the station coefficient of the recording station. The mean of the coefficients of the JMA stations is given by ci = 0.

Relationships between ground motion parameters and damaged buildings for 2016 Mw 6.4 Meinong, Taiwan Earthquake

2020 ◽  
Author(s):  
Guan-Yi Song ◽  
Yih-Min Wu
Keyword(s):  
Ground Motion ◽  
Peak Ground Acceleration ◽  
Hazard Analysis ◽  
Assessment System ◽  
Peak Ground Velocity ◽  
Current Status ◽  
Ground Acceleration ◽  
Ground Motion Parameters ◽  
Motion Parameters ◽  
Seismic Damage Assessment

<p>The relationships between ground motion parameters (including peak ground acceleration, PGA; peak ground velocity, PGV) and building damages are crucial to estimate the possible seismic losses for future destructive earthquakes. One such relationship had been established based on the 1999 Chi-Chi earthquake (Mw=7.6). Since 2010, a new assessment system of seismic damaged buildings had been adopted in Taiwan. Damaged buildings are now classified into two categories, yellow-tagged buildings are amendable and red-tagged buildings may need to rebuild. Our main goal is to renew the relationship to better reflect the current status in Taiwan, both in the buildings and assessment system. 2016 Meinong earthquake (Mw=6.4) caused the most damaging buildings in Taiwan since 1999 Chi-Chi earthquake. It’s an opportunity to combine ground motion data with building assessments for the new regression relationship. From the results, we find out that in the Meinong earthquake, the PGA seems to possess a higher correlation to the building damages, contrary to the previous studies. Further investigation suggests that it may be due to the biased sample size to the damaged buildings, that is, most of the damaged buildings tend to be lower.</p><p>Keywords: Hazard analysis, Peak ground acceleration, Peak ground velocity, Seismic damage assessment</p>

Probabilistic assessment of earthquake-induced sliding displacements of natural slopes

2009 ◽  
Vol 42 (1) ◽  
pp. 18-27 ◽  
Author(s):  
Ellen M. Rathje ◽  
Gokhan Saygili
Keyword(s):  
Ground Motion ◽  
Peak Ground Acceleration ◽  
Earthquake Magnitude ◽  
Motion Parameter ◽  
Peak Ground Velocity ◽  
Vector Model ◽  
Probabilistic Framework ◽  
Ground Acceleration ◽  
Ground Motion Parameter ◽  
Natural Slopes

The evaluation of earthquake-induced landslides in natural slopes is often based on an estimate of the permanent sliding displacement due to earthquake shaking. Current procedures for estimating sliding displacement do not rigorously account for the significant uncertainties present in the analysis. This paper presents a probabilistic framework for computing the annual rate of exceedance of different levels of displacement such that a hazard curve for sliding displacement can be developed. The analysis incorporates the uncertainties in the prediction of earthquake ground shaking, in the prediction of sliding displacement, and in the assessment of soil properties. Predictive models for sliding displacement that are appropriate for the probabilistic framework are presented. These models include a scalar model that predicts sliding displacement in terms of a single ground motion parameter (peak ground acceleration) and the earthquake magnitude, as well as a vector model that incorporates two ground motion parameters (peak ground acceleration and peak ground velocity). The addition of a second ground motion parameter results in a significant reduction in the standard deviation of the sliding displacement prediction. Comparisons are made between displacement hazard curves developed from the current scalar and vector models and previously developed scalar models that do not include earthquake magnitude. Additionally, an approximation to the vector hazard assessment is presented and compared with the rigorous vector approach. Finally, the inclusion of the soil property uncertainty is shown to increase the mean hazard at a site.

Effect of Ridge Topography on Earthquake Ground Motion

2012 ◽  
Vol 594-597 ◽  
pp. 1696-1701
Author(s):  
Guo Dong Xu ◽  
Zheng Hua Zhou ◽  
Jing Shan Bo ◽  
Wei Hua Fang
Keyword(s):  
Ground Motion ◽  
Peak Ground Acceleration ◽  
Response Spectrum ◽  
Vertical Direction ◽  
Earthquake Ground Motion ◽  
Topographic Effect ◽  
Ground Acceleration ◽  
Seismic Ground Motion ◽  
Remarkable Effect ◽  
Motion Amplitude

The ridge topography can substantially influence seismic ground motion and, in general, causes the amplification of seismic ground motion amplitude at ridges. Fortunately, sets of three-component accelerogram, obtained by the observation arrays for topographic effect at Zigong Xishan, Jiangyou Doutuan and Qingchuan Sanguo from the great Wenchuan earthquake and its aftershocks, provided basic data for analyzing the effect of ridge topography on seismic ground motion. On the base of these acceleration records, peak ground acceleration and response spectrum ratios are calculated, and examined and compared in order to grasp the effect of ridge topography on ground motion. The findings showed that ridge topography has the remarkable effect on seismic ground motion, in which the amplification characteristics varies depending on the shape of ridge topography, and the amplification effect of the horizontal directions are not similar to the vertical direction, and in some periods are even less than 1.0.

scholarly journals ESTIMATION OF SUBSURFACE STRUCTURE BASED ON MICROTREMOR, BORE HOLE OBSERVATIONS AND STOCHASTIC STRONG GROUND MOTION SIMULATIONS IN PALU CITY, CENTRAL SULAWESI, INDONESIA: A VALIDATION AND SENSITIVITY STUDY ON THE 23 JANUARY 2005 (PALU) EARTHQUAKE

2015 ◽  
Vol 6 (2) ◽  
Author(s):  
Pyi Soe Thein ◽  
Subagyo Pramumijoyo ◽  
Wahyu Wilopo ◽  
Agung Setianto ◽  
Kirbani Sri Brotopuspito ◽  
...  
Keyword(s):  
Ground Motion ◽  
Peak Ground Acceleration ◽  
Strong Ground Motion ◽  
Soil Condition ◽  
Fault System ◽  
Earthquake Ground Motion ◽  
Subsurface Structure ◽  
Ground Acceleration ◽  
Central Sulawesi ◽  
Strong Ground

In this study, we investigated the subsurface structure and strong ground motion parameters for Palu City. One of the major structures in Central Sulawesi is the Palu-Koro Fault system. Several powerful earthquakes have struck along the Palu-Koro Fault during recent years, one of the largest of which was an M 6.3 event that occurred on January 23, 2005 and caused several casualties. Following the event, we conducted a microtremor survey to estimate the shaking intensity distribution during the earthquake. From this survey we produced a map of the peak ground acceleration, velocity and ground shear strain in Palu City. We performed single observations of microtremors at 151 sites in Palu City. The results enabled us to estimate the site-dependent shaking characteristics of earthquake ground motion. We also conducted 8-site microtremor array investigation to gain a representative determination of the soil condition of subsurface structures in Palu. From the dispersion curve of array observations, the central business district of Palu corresponds to relatively soil condition with Vs ≤ 300 m/s, the predominant periods due to horizontal vertical ratios (HVSRs) are in the range of 0.4 to 1.8 s and the resonant frequency are in the range of 0.7 to 3.3 Hz. Three boreholes were throughout the basin especially in Palu area to evaluate the geotechnical properties of subsurface soil layers. The depths are varying from 1 m to 30 m. Strong ground motions of the Palu area were predicted based on the empirical stochastic green’s function method. Peak ground acceleration and peak ground velocity becomes more than 0.04 g and 30 kine in some areas, which causes severe damage for buildings in high probability. Keywords: Palu-Koro fault, microtremor, bore holes, peak ground acceleration and velocity.

Development of Maximum Considered Earthquake Ground Motion Maps

2000 ◽  
Vol 16 (1) ◽  
pp. 21-40 ◽  
Author(s):  
Edgar V. Leyendecker ◽  
R. Joe Hunt ◽  
Arthur D. Frankel ◽  
Kenneth S. Rukstales
Keyword(s):  
Ground Motion ◽  
Seismic Design ◽  
Spectral Response ◽  
Design Procedure ◽  
Peak Ground Velocity ◽  
Earthquake Ground Motion ◽  
Ground Acceleration ◽  
Seismic Safety ◽  
Design Procedures ◽  
Seismic Rehabilitation

The 1997 NEHRP Recommended Provisions for Seismic Regulations for New Buildings use a design procedure that is based on spectral response acceleration rather than the traditional peak ground acceleration, peak ground velocity, or zone factors. The spectral response accelerations are obtained from maps prepared following the recommendations of the Building Seismic Safety Council's (BSSC) Seismic Design Procedures Group (SDPG). The SDPG-recommended maps, the Maximum Considered Earthquake (MCE) Ground Motion Maps, are based on the U.S. Geological Survey (USGS) probabilistic hazard maps with additional modifications incorporating deterministic ground motions in selected areas and the application of engineering judgement. The MCE ground motion maps included with the 1997 NEHRP Provisions also serve as the basis for the ground motion maps used in the seismic design portions of the 2000 International Building Code and the 2000 International Residential Code. Additionally the design maps prepared for the 1997 NEHRP Provisions, combined with selected USGS probabilistic maps, are used with the 1997 NEHRP Guidelines for the Seismic Rehabilitation of Buildings.

Sign in / Sign up

Export Citation Format

Share Document