The Impact of a Gain-Sharing Cost-Reflective Tariff on Waste Management Cost Under Incentive Regulation

2020 ◽  
Author(s):  
Giacomo Di Foggia ◽  
Massimo Beccarello
2021 ◽  
Author(s):  
Giacomo Di Foggia ◽  
Massimo Beccarello

In many European countries, waste tariff systems are being updated to take account of the consolidation of circular economy objectives. We forecast the impact of a gain-sharing cost-reflective tariff on waste management sustainability. The cost-reflective tariff generates an economic surplus for society, while meeting environmental goals. Based on empirical data we developed two scenarios. The baseline scenario formalizes the current Italian tariff scheme, while the intervention scenario includes users' response to a gainsharing policy. By optimizing the tariff structure, society would benefit from a surplus that could be reached setting an asymmetric regulation based on current waste management efficiency level. Our results will potentially be a basis for directing waste management policy as per tariff design


Author(s):  
Emilda Emilda

The limitations of waste management in the Cipayung Landfill (TPA) causing a buildup of garbage up to more than 30 meters. This condition has a health impact on people in Cipayung Village. This study aims to analyze the impact of waste management at Cipayung Landfill on public health in Cipayung Village, Depok City. The research is descriptive qualitative. Data obtained by purposive sampling. Data was collected by interviews, observation and documentation. Based on interviews with 30 respondents, it was found that the most common diseases were diarrhea, then other types of stomach ailments, subsequent itching on the skin and coughing. This is presumably because the environmental conditions in the form of unhealthy air and water and clean and healthy living behaviors (PHBS) have not become the habit of the people. The results indicated that there were no respondents who had implemented all of these criteria. In general respondents have implemented  3 criteria, namely maintaining hair hygiene, maintaining skin cleanliness, and maintaining hand hygiene. While maintaining clean water storage is the most often overlooked behavior. To minimize this health impact, improvements in waste management in Cipayung landfill are needed along with continuous socialization and education to develop PHBS habits and the importance of maintaining a clean environment.


2021 ◽  
Vol 108 (Supplement_2) ◽  
Author(s):  
C Luney ◽  
C Little

Abstract Introduction Audit of waste management in an elective orthopaedic complex was interrupted due Covid-19 pandemic. We investigated the impact of the enforced changes on theatre waste due to Covid-19. Method Over a 1week period data on waste bag availability and number of bags of each category of waste per surgical case in an elective theatre complex was collated; this was compared to waste generated during Covid-19 pandemic. Results Prior to Covid-19 only clinical waste bins were available in many non-dominant clinical areas providing evidence of inappropriate routine disposal of domestic/recyclable waste. Pre-Covid-19 a mean of 6waste bags were used per surgical case (3.7yellow clinical bags, 1.3black domestic bags, 0.4clear recycling bags), with Covid-19 changes to waste management practice the mean number of waste bags used per case increased to 11 (9 orange contaminated bags, 0.5black, 0.3clear bags). Conclusions Clinical waste management has a significant economic and environmental impact. Covid-19 has led to nearly all waste being deemed to be contaminated and so requiring incineration, with increased volumes of waste generated per case through widespread adoption of PPE. This has increased cost and reduced the ability to recycle non-contaminated waste.


Author(s):  
Huan Lin ◽  
Tai-Wei Lan ◽  
Min-Tsang Chang ◽  
Wuu-Kune Cheng

The “Nuclear Materials and Radioactive Waste Management Act” (NMRWMA) in Taiwan has been in use since 2002. To promote further administrative efficiency and improve regulatory capacity, an amendment of the act has been initiated by the Atomic Energy Council (AEC). It is now being reviewed by outside experts and related communities so as to include the best understanding of risk management factors. For the future decommissioning challenges of nuclear facilities, the act is also being amended to comply with the regulatory requirements of the decommissioning mandates. Currently the Taiwan government is conducting government reorganization, and AEC will be reformed but will remain as an independent regulatory body. AEC will then be capable of improving the regulatory capacity for facilitating licensing and inspection, ensuring operational safety, environmental protection and public involvement, and giving a more flexible administrative discretion, such as expending the margin of penalty. The amendment is also required to provide a formal legal basis for the Nuclear Backend Fund, and to mandate the waste producers to take responsibility for any final debt repayment. In addition, this amendment promotes measures to prevent accidents or emergencies concerning radioactive materials and facilities and procedures to reduce the impact and effect of any unexpected events. Furthermore, this amendment intends to implement the concept of information transparency and public participation so as to meet the public needs. Finally, radioactive waste final disposal tasks have to be completed by waste producers under the supervision of the AEC.


1997 ◽  
Vol 77 (3) ◽  
pp. 333-344 ◽  
Author(s):  
M. I. Sheppard ◽  
D. E. Elrick ◽  
S. R. Peterson

The nuclear industry uses computer models to calculate and assess the impact of its present and future releases to the environment, both from operating reactors and from existing licensed and planned waste management facilities. We review four soil models varying in complexity that could be useful for environmental impact assessment. The goal of this comparison is to direct the combined use of these models in order to preserve simplicity, yet increase the rigor of Canadian environmental assessment calculations involving soil transport pathways. The four models chosen are: the Soil Chemical Exchange and Migration of Radionuclides (SCEMR1) model; the Baes and Sharp/Preclosure PREAC soil model, both used in Canada's nuclear fuel waste management program; the Convection-Dispersion Equation (CDE) model, commonly used in contaminant transport applications; and the Canadian Standards Association (CSA) derived release limit model used for normal operations at nuclear facilities. We discuss how each model operates, its timestep and depth increment options and the limitations of each of the models. Major model assumptions are discussed and the performance of these models is compared quantitatively for a scenario involving surface deposition or irrigation. A sensitivity analysis of the CDE model illustrates the influence of the important model parameters: the amount of infiltrating water, V; the hydrodynamic dispersion coefficient, D; and the soil retention or partition coefficient, Kd. The important parameters in the other models are also identified. This work shows we need tested, robust, mechanistic unsaturated soil models with easily understood and measurable inputs, including data for the sensitive or important model parameters for Canada's priority contaminants. Soil scientists need to assist industry and its regulators by recommending a selection of models and supporting them with the provision of validation data to ensure high-quality environmental risk assessments are carried out in Canada. Key words: Soil transport models, environmental impact assessments, model structure, complexity and performance, radionuclides 137Cs, 90Sr, 129I


EXTRAPOLASI ◽  
2020 ◽  
Vol 17 (2) ◽  
pp. 1-10
Author(s):  
Michella Beatrix ◽  
Nurul Rochmah ◽  
Gede Sarya ◽  
Pebru Dwijayanto

AbstractLarge and small scale construction projects have waste that cannot be predicted in advance, even the amount cannot be predicted directly, whether it is in large or small amounts. The existence of waste can have a significant impact that can affect construction costs. Waste can have both negative and positive impacts. Good waste management will have a positive impact on the company in terms of cost, even time, and quality, but if the waste that occurs cannot be handled or managed properly it will harm the company in terms of cost, time, and even in terms of quality. In this case, the party that always gets the impact of the waste is the contractor.This study focuses on mitigating the occurrence of waste that is how to minimize it. Thisstudy uses the distribution of questionnaires to the contractor in Surabaya. The results of this study are 5 item indicators on how to minimize the highest ranking. The 5 items are Updating material requirements, Mixing, transporting, and placing concrete at the right time, Increasing the competence and expertise of labor, Provision of good and adequate material/warehouse storage facilities, and accurate material measurement.  Abstrak Proyek konstruksi dalam skala besar maupun kecil, memiliki waste yang tidak dapat diprediksi sebelumnya, bahkan jumlahnya pun tidak dapat diprediksi secara langsung, apakah itu dalam jumlah besar ataupun jumlah yang kecil. Adanya waste dapat memberikan dampak yang signifikan yang dapat mempengaruhi biaya konstruksi. Pada dasarnya waste dapat memberikan dampak negatif maupun positif. Pengelolaan waste yang baik akan memberikan dampak positif bagi perusahaan dalam segi biaya, bahkan waktu dan mutu, namun apabila waste yang terjadi tidak dapat diatasi atau dikelola dengan baik maka akan memberikan dampak negatif bagi perusahaan dalam segi biaya, waktu bahkan dalam hal mutu. Dalam hal ini pihak yang selalu mendapatkan dampak dari adanya waste adalah pihak kontraktorPenelitian ini memfokuskan pada faktor penanggulangan terjadinya waste yaitu cara meminimalisirnya. Penelitian ini menggunakan penyebaran kuisioner kepada pihak kontraktor di Surabaya. Hasil dari penelitian ini adalah 5 item indicator cara meminimalisir yang memiliki ranking tertinggi. 5 item tersebut adalah Updating kebutuhan material, Mencampur, mengangkut dan menempatkan beton pada waktu yang tepat, Meningkatkan kompetensi dan keahlian tenaga kerja, Penyediaan fasilitas penyimpanan material/gudang yang baik dan memadai, dan Pengukuran bahan yang akurat.


Economies ◽  
2018 ◽  
Vol 6 (4) ◽  
pp. 54 ◽  
Author(s):  
Hanke Ndau ◽  
Elizabeth Tilley

Insufficient staff, inappropriate collection vehicles, limited operating budgets and growing, hard to reach populations mean that solid waste management remains limited in most developing countries; Malawi is no exception. We estimated the willingness to pay (WTP) for two hypothetical solid waste collection services. Additionally, we tested the impact of the WTP question positioning relative to environmental perceptions on respondents’ WTP. The first scenario involved a five minute walk to a disposal facility; the second scenario involved a 30 min walk. Additionally, the order of the question was randomized within the questionnaire. A WTP value of K1780 was found for the five minute walk scenario when the question was placed first, and K2138 when placed after revealing the respondent’s perceptions on the environment. In the 30 min walk scenario, WTP was K945 when placed first and K1139 when placed after revealing the respondent’s perceptions on the environment. The estimated values indicate that there is both a willingness to pay for solid waste services and that there are at least two options that would be acceptable to the community; a pilot scale implementation would be required to validate the hypothetical values, especially given the dependency on problem framing. Community financing should be considered as a sustainable approach to solid waste management in underserved areas.


Sign in / Sign up

Export Citation Format

Share Document