scholarly journals Simulation and experimental research on dynamic characteristics of overrunning clutch

2019 ◽  
Vol 21 (3) ◽  
pp. 570-586
Author(s):  
Kegang Zhao ◽  
Yanwei Liu ◽  
Ziyue Lin
Author(s):  
Katsuhide Fujita ◽  
Takashi Saito ◽  
Mitsugu Kaneko

When agricultural machines are operated on pavements, the vibration and noise caused by the interaction between the tire lugs and the road surface are inevitable. In conventional studies, it is considered that the dynamic behavior of a rolling agricultural tire is influenced by the vibration characteristics of the tire. Resonance occurs when the lug excitation frequency of the tire, which is defined as the lug number multiplied by the number of revolutions of the tire, becomes equal to the natural frequency of the tire. In other words, the rolling tire shows large vibrations in the direction of the natural mode corresponding to the natural frequency of the tire. However, in the conventional equipment, the diameter of the drum is smaller than that of the tire. Therefore, the real running condition on the road was not realized by the rolling test using the conventional equipment. In this study, a new equipment is produced to realize the running condition in the rolling test. The dynamic and vibratory characteristics of operating agricultural machine are investigated by using this new equipment. The obtained results are compared to the conventional ones and the influence of the running condition on dynamic characteristics of rolling tire is investigated.


Author(s):  
Leonid Polishchuk ◽  
Leonid Kozlov ◽  
Yuri Burennikov ◽  
Vasil Strutinskiy ◽  
Valerii Kravchuk

The application of adaptive drives in working units of various technological and mobile machines is considered. The results of theoretical and experimental research have proved the effectiveness of their use for improving the dynamic characteristics of machines, reducing unproductive power losses during their operation.


2003 ◽  
Vol 138 (1-3) ◽  
pp. 468-471 ◽  
Author(s):  
Chen Ming ◽  
Sun Fanghong ◽  
Wang Haili ◽  
Yuan Renwei ◽  
Qu Zhenghong ◽  
...  

2012 ◽  
Vol 468-471 ◽  
pp. 807-810 ◽  
Author(s):  
Ping Bai

Due to great pressure difference between inlet and outlet, high-pressure gear pump can cause unbalanced radial force, which results in serious wearing between axle journal of drive shaft and bearing-hole, non-ideal dynamic characteristics, and drop of volumetric efficiency after long run. This paper introduces a new sealing structure. Based on this structure, a high-pressure oil reservoir is installed on the wall of the inner-hole of floating plate for radial support and lubricating, which can effectively reduce shaft wearing and noise, and improve working dynamic characteristics of high-pressure gear pump.


Sign in / Sign up

Export Citation Format

Share Document