Bench Scale and Pilot Scale Experiments on Biological Phosphorus Removal

1985 ◽  
Vol 17 (11-12) ◽  
pp. 287-288 ◽  
Author(s):  
R. Ramadori ◽  
V. Tandoi ◽  
A. Misiti

In connection with studies aimed at developing low-energy wastewater treatment processes considerable interest has been shown in the possibility of removal of phosphorus biologically rather than chemically. The results over one year from bench and pilot scale tests conducted with synthetic and settled domestic wastewaters respectively are reported. The pilot plant was installed in one of the Rome urban wastewater treatment works and consisted of a two stage (anaerobic-aerobic) system. The wastewater was withdrawn downstream from the primary settling tank and conveyed to the anaerobic reactor of the pilot plant. A similar experiment was conducted in a three reactor (two anaerobic and one aerobic) bench scale plant, where a synthetic solution (peptone, sodium acetate and potassium phosphate) was fed under rigorously controlled conditions of temperature, pH and dissolved oxygen. Both bench and pilot scale tests were designed to verify and quantify the biological removal of phosphorus; the performances of both phosphorus removal test scale systems were compared with those from a reference aerobic plant operating under the same conditions. The impact of several parameters on the biological removal of phosphorus were examined. These parameters were: nature of carbonaceous substrate, carbonaceous/phosphorus ratio, sludge age; etc. Considerable care and attention was given to checking phosphorus balances, once the steady state conditions had been obtained. The results can be summarized as follows:-Phosphorus removal was found to be greater in plants with an anaerobic stage than in the reference plants. At pilot scale level this is clearly shown by the plot of the daily phosphate concentration in the effluents. At bench scale it is shown by comparison between P contents in sludges (9.9% vs. 5.0%) and by the fact that, at the end of the experiment, large deposits of inorganic phosphate (mainly of Ca and Mg) were found on the walls of both anaerobic reactors. The unstable operating conditions of the reference plant due to the poor sedimentation characteristics of the sludges leading to uncontrolled losses of biomass meant it was impossible to obtain a reliable mean phosphorus abatement value, which in any case was always well below that found for the P-removal plant.-As reported above, the deficit in the phosphorus balance was due to inorganic phosphate precipitation. In this connection an excellent quantitative agreement was found between the deficit in the balance and the quantity of phosphorus collecting in the anaerobic reactors.-Phosphorus release from the biomass under anaerobic conditions has already been completed in the first anaerobic reactor (where carbonaceous substrate uptake also occurs) and the use of the second anaerobic reactor seems to allow a more complete phosphate precipitation.-Part of the carbonaceous substrate which disappears during the first anaerobic stage is metabolized. In fact, in this reactor, the complete disappearance of organic nitrogen is accompanied by the release of large quantities of ammoniacal nitrogen. Lastly, despite the fact that the values of the main operative parameters, such as hydraulic retention time, sludge age, temperature, pH and dissolved oxygen, were kept rigorously constant, a certain instability was found in the biomass as regards the maintaining of such high phosphorus removal efficiencies over long periods of time. This may be due to the highly variable biological population dynamics.

2012 ◽  
pp. 756-761 ◽  
Author(s):  
Miroslav Hutnan ◽  
Štefan Tóth ◽  
Igor Bodík ◽  
Nina Kolesárová ◽  
Michal Lazor ◽  
...  

The possibility of joint treatment of spent sugar beet pulp and wastewater from a sugar factory was studied in this work. Works focused on processing of spent sugar beet pulp separately or together with other substrates can be found in the literature. In the case of some sugar factories, which have spare capacity in the anaerobic reactor on an anaerobic-aerobic wastewater treatment plant, joint processing of spent sugar beet pulp and wastewater from the sugar factory might be an interesting option. The results of the operation of a pilot plant of an anaerobic reactor with a capacity of 3.5 m3 are discussed. Operation of the pilot plant confirmed the possibility of cofermentation of these materials. The organic loading rate achieved in the anaerobic reactor was higher than 6 kg/(m3·d) (COD), while more than half of the load was provided by spent sugar beet pulp. The addition of sugar beet pulp decreased the concentration of ammonia nitrogen in the anaerobic reactor and it was even necessary to add nitrogen. However, the nitrogen content in sludge water depends on the C:N ratio in the processed sugar beet pulp, therefore this knowledge cannot be generalized. About 1.5 to 2-fold biogas production can be expected from the cofermentation of wastewater with sugar beet pulp in an anaerobic reactor, compared with the biogas production from just wastewater treatment.


1998 ◽  
Vol 151 (1) ◽  
pp. 63-74 ◽  
Author(s):  
S.A. Stern ◽  
B. Krishnakumar ◽  
S.G. Charati ◽  
W.S. Amato ◽  
A.A. Friedman ◽  
...  

2004 ◽  
Vol 49 (4) ◽  
pp. 331-337 ◽  
Author(s):  
L. Bousselmi ◽  
S.-U. Geissen ◽  
H. Schroeder

Based on results from bench-scale flow-film-reactors (FFR) and aerated cascade photoreactors, a solar catalytic pilot plant has been built at the site of a textile factory. This plant has an illuminated surface area of 50 m2 and is designed for the treatment of 1 m3 h-1 of wastewater. The preliminary results are presented and compared with a bench-scale FFR using textile wastewater and dichloroacetic acid. Equivalent degradation kinetics were obtained and it was demonstrated that the solar catalytic technology is able to remove recalcitrant compounds and color. However, on-site optimization is still necessary for wastewater reuse and for an economic application.


2010 ◽  
Vol 43 (6) ◽  
pp. 233-238 ◽  
Author(s):  
Marian Barbu ◽  
George Ifrim ◽  
Sergiu Caraman ◽  
Gabriela Bahrim

2000 ◽  
Vol 41 (10-11) ◽  
pp. 295-301 ◽  
Author(s):  
T. Murakami ◽  
J. Usui ◽  
K. Takamura ◽  
T. Yoshikawa

Pilot plant studies were carried out using actual wastewater to investigate the applicability of a membrane separation activated sludge (MSAS) process to municipal wastewater treatment. A small-scale pilot plant (6.7 m3/day) with immersed flat sheet membrane was operated at the flux of 0.4 m3/m2/day. Continuous operation for 140 days without chemical cleaning was possible. Average Sludge production ratio was about 0.6. No significant difference was observed in the dewaterability between membrane separation activated sludge and conventional activated sludge at the CST test. Large-scale pilot plants (30–70 m3/day) with five types of membrane were also operated. In these plants nitrogen removal by nitrification and denitrification, and phosphorus removal by coagulant addition were carried out. Stable operation with HRT of six hours, flux of 0.4–0.8 m3/m2/day was possible, the average nitrogen and phosphorus removal efficiency being more than 80 and 95%, respectively.


2016 ◽  
Vol 74 (2) ◽  
pp. 438-447 ◽  
Author(s):  
J. Väänänen ◽  
M. Cimbritz ◽  
J. la Cour Jansen

Primary and chemically enhanced primary wastewater treatment with microsieving (disc or drum filtration) was studied at the large pilot scale at seven municipal wastewater treatment plants in Europe. Without chemical dosing, the reduction of suspended solids (SS) was (on average) 50% (20–65%). By introducing chemically enhanced primary treatment and dosing with cationic polymer only, SS removal could be controlled and increased to >80%. A maximum SS removal of >90% was achieved with a chemical dosing of >0.007 mg polymer/mg influent SS and 20 mg Al3+/L or 30 mg Fe3+/L. When comparing sieve pore sizes of 30–40 μm with 100 μm, the effluent SS was comparable, indicating that the larger sieve pore size could be used due to the higher loading capacity for the solids. Phosphorus removal was adjusted with the coagulant dose, and a removal of 95–97% was achieved. Moreover, microsieving offers favourable conditions for automated dosing control due to the low retention time in the filter.


2007 ◽  
Vol 55 (11) ◽  
pp. 65-71 ◽  
Author(s):  
R.K.X. Bastos ◽  
E.N. Rios ◽  
F.L. Dornelas ◽  
F.A.L. Assunção ◽  
L.E. Nascimento

Ammonia and phosphorus removal were evaluated over four years monitoring of an experimental wastewater treatment plant in Brazil: initially a UASB reactor (real scale) + three shallow polishing ponds (pilot scale), afterwards a UASB + submerged aerated biofilter (BF) (real scale) + the same pond series. Shallow ponds (h < 0.90m) provided considerable ammonia removal, but phosphorus removal was somewhat poorer. An equation was derived for the estimation of ammonia pond effluent, based on the same assumptions of the well known Pano and Middlebrooks model. According to the experimental data, an effluent suitable for aquaculture should be achieved with retention time of 25 days.


2021 ◽  
Vol 2021 ◽  
pp. 1-8
Author(s):  
Minh-Trung Dao ◽  
Vo-Chau-Ngan Nguyen ◽  
Thanh-Nha Tran ◽  
Xuan-Du Nguyen ◽  
Duc-Thuong Vo ◽  
...  

Plant-derived coagulants have exhibited a good potential in wastewater treatment due to their “green” characteristics, high coagulating-flocculating activity, cost-effectiveness, and biodegradability. Nevertheless, research studies have focused mainly on bench-scale experiments; pilot-scale and full-scale simulations are still limited. Herein, we firstly report a pilot-scale study of real domestic textile wastewater treatment using Cassia fistula coagulant. The material characterizations using Fourier-transform infrared spectroscopy (FTIR), scanning electron microscope (SEM), and dynamic light scattering (DLS) revealed that the natural gum extracted from C. fistula seed possessed a rough and irregular surface containing a high molecular weight galactomannan. The bench-scale investigation was initially conducted to determine the optimal pollutant concentration, initial pH, and coagulant dosage in the coagulation-flocculation process. The pilot-scale study revealed that C. fistula coagulant is an effective material for real textile wastewater treatment, showing percentage removal of 93.83% at a volume of 30 L and a coagulant dosage of 1.17 mg·L−1. Coagulation-flocculation using C. fistula seed gum could be an efficient primary wastewater treatment prior to membrane or biological methods to meet Vietnamese environmental standards. The main mechanisms of textile wastewater treatment involve adsorption/bridging interactions via hydrogen bonding and electrostatic attraction between negatively charged carboxylate groups of the coagulant and positively charged pollutants.


Sign in / Sign up

Export Citation Format

Share Document