scholarly journals Effect of Accelerator on Compressive Strength Development of Class F Fly Ash Concrete

2017 ◽  
Vol 9 (5) ◽  
pp. 3954-3957 ◽  
Author(s):  
I Made Alit Karyawan Salain
2018 ◽  
Vol 70 (11) ◽  
pp. 541-557 ◽  
Author(s):  
Gollapalli S. Vijaya Bhaskara ◽  
Kanchi Balaji Rao ◽  
Madambikkattil B. Anoop

2016 ◽  
Vol 872 ◽  
pp. 271-275 ◽  
Author(s):  
Mochamad Solikin

This paper presents a research to produce high strength concrete incorporated with fly ash as cement replacement up to 50% (high volume fly ash concrete) by using local material. The research is conducted by testing the strength development of high volume fly ash concrete at the age of 14 days, 28 days and 56 days. As a control mix, the compressive strength of Ordinary Portland Cement (OPC) concrete without fly ash is used. Both concrete mixtures use low w/c. consequently, they lead to the use of 1 % superplasticizer to reach sufficient workability in the process of casting. The specimens are concrete cubes with the dimension of 15 cm x15 cm x 15 cm. The totals of 24 cubes of HVFA concrete and OPC concrete are used as specimens of testing. The compressive strength design of concrete is 45 MPa and the slump design is ± 10 cm. The result shows that the compressive strengths of OPC concrete at the age of 14 days, 28 days, and 56 days are 38 MPa, 40 MPa, and 42 MPa. Whereas the compressive strength of HVFA concrete in the same age of immersing sequence are 29 MPa, 39 MPa, and 42 MPa. The result indicates that HVFA concrete can reach the similar compressive strength as that of normal concrete especially at the age of 56 days by deploying low water cement ratio.


2017 ◽  
Vol 744 ◽  
pp. 131-135 ◽  
Author(s):  
Muhammad Zahid ◽  
Nasir Shafiq ◽  
Mohd Fadhil Nuruddin ◽  
Ehsan Nikbakht ◽  
Asif Jalal

This article aims to investigate the compressive strength variation by the addition of metakaolin as a substitute of fly ash in the fly ash based geopolymer mortar. Five, ten and fifteen percent by weight of fly ash was replaced by highly reactive metakaolin. Two type of fly ashes namely, ASTM class F and ASTM class C were used as a base material for the synthesis of geopolymer mortar. Eight molar sodium hydroxide solution mixed with sodium silicate solution was used as alkaline activator. For optimum geopolymerization, mortar was cured at sixty degree Celsius for twenty four hours duration. Results show different behavior of metakaolin replacement on compressive strength for two different types of fly ash based geopolymer mortar. Improvement in compressive strength was seen by addition of metakaolin in ASTM class F fly ash based geopolymer. On the other hand compressive strength was decreased abruptly in fly ash class C based geopolymer up to certain replacement level.


2010 ◽  
Vol 150-151 ◽  
pp. 1026-1033 ◽  
Author(s):  
Ming Hui Liu ◽  
Yuan Feng Wang

The effect of fly ash in improving the mechanical properties of concrete is investigated and the existing concrete strength development models are studied. Based on the chemic reactivity properties between fly ash and cement, an appropriate concrete strength model are chosen, and a new model for the fly ash strength factor combing Maturity method is built up and the factors are regressed by existing experimental datum. A total of 24 concretes, including two concretes were produced with two partial fly ash replacement ratios (23.7%, 32.7%). The cubic samples produced from ash fly concrete were demoulded after a day, and cured at standard temperature ( in GB/T 50081-2002) with 100% relative humidity until 28 days, then cured in water. The compressive strength tests were carried out on the cubic specimens at different ages. The compressive strength with time was evaluated by using the new predicted model. It was found that the calculated results by new method are fit the experimental data well.


Sign in / Sign up

Export Citation Format

Share Document