scholarly journals Numerical simulation on the emission of NOx from the combustion of natural gas in the sidewall burner

2021 ◽  
pp. 61-61
Author(s):  
Mingyu Wang ◽  
Jing Zhao ◽  
Feihong Guo ◽  
Lingli Zhu ◽  
Dekui Shen ◽  
...  

The NOx produced from industrial facilities is a serious environmental problem in China. In this work, the NOx emission from the combustion of natural gas in the sidewall burner was investigated by using computational fluid dynamics method. To achieve the low-NOx emission, the sidewall burner structure was optimized involving the width of the primary premixed gas outlet, the secondary fuel gas nozzles number and angular spacing. The mixing rate of fuel gas and air could be improved by increasing the width of primary premixed gas outlet, and the lowest NOx emission of 32.8 ppm was achieved at the width of 8 mm. The NOx emission was remarkably reduced with the increasing of nozzles number, where 28.33 ppm of NOx emission and 357.35 ppm of CO were obtained at 4 nozzles. The combustion performance and NOx emission was improved as well as NOx emission was reduced at the angular spacing of 55?, compared to that of 30?, 35?, 40?, 45?, 50? and 60?.

2012 ◽  
Vol 512-515 ◽  
pp. 2135-2142 ◽  
Author(s):  
Yu Peng Wu ◽  
Zhi Yong Wen ◽  
Yue Liang Shen ◽  
Qing Yan Fang ◽  
Cheng Zhang ◽  
...  

A computational fluid dynamics (CFD) model of a 600 MW opposed swirling coal-fired utility boiler has been established. The chemical percolation devolatilization (CPD) model, instead of an empirical method, has been adapted to predict the nitrogen release during the devolatilization. The current CFD model has been validated by comparing the simulated results with the experimental data obtained from the boiler for case study. The validated CFD model is then applied to study the effects of ratio of over fire air (OFA) on the combustion and nitrogen oxides (NOx) emission characteristics. It is found that, with increasing the ratio of OFA, the carbon content in fly ash increases linearly, and the NOx emission reduces largely. The OFA ratio of 30% is optimal for both high burnout of pulverized coal and low NOx emission. The present study provides helpful information for understanding and optimizing the combustion of the studied boiler


2013 ◽  
Vol 387 ◽  
pp. 180-184
Author(s):  
Ya Dong Li ◽  
Hai Hong Mo ◽  
Jun Shen Chen

The numerical simulation analysis on the whole process of the tube immersing is researched, which use computational fluid dynamics method, is based on RNG k~ε turbulence model. The analysis shows that: additional pressure of tube lateral wall depends on the changed flow field cause by tube immersing; through the analysis, it have explored the special position of additional pressure changes in the process of immersing; it also shows some problems should be paid attention, through analysis the stress of special position.


2013 ◽  
Vol 318 ◽  
pp. 371-374
Author(s):  
Chen Fan

There was a conflict between NOx emission and engine power of modified natural gas engine. Influence facters of NOx emission and emission characteristics of existing modified engine were studied. Emission and engine power of natural gas engine modified from gasoline and diesel engine were compared. Then some sugesstion are brought out for designing low NOx emission natural gas engine and promote engine power.


1992 ◽  
Vol 24 (1) ◽  
pp. 1391-1397 ◽  
Author(s):  
M.A. Toqan ◽  
J.M. Beér ◽  
P. Jansohn ◽  
N. Sun ◽  
A. Testa ◽  
...  

2019 ◽  
Vol 58 (31) ◽  
pp. 14323-14332 ◽  
Author(s):  
Juan Sebastian Cornejo Caceres ◽  
Natalia Prieto ◽  
German Gonzalez ◽  
Arlex Chaves-Guerrero

Author(s):  
Takeharu Hasegawa ◽  
Tohru Hisamatsu ◽  
Yasunari Katsuki ◽  
Mikio Sato ◽  
Hiromi Koizumi ◽  
...  

The development of integrated coal gasification combined cycle (IGCC) systems ensures higher thermal efficiency and environmentally sound options for supplying future coal utilizing power generation needs. The Japanese government and electric power industries in Japan promoted research and development of an IGCC system using an air-blown entrained-flow coal gasifier. On the other hand, Europe and the United States are now developing the oxygen-blown IGCC demonstration plants. Gasified coal fuel produced in an oxygen-blown entrained-flow coal gasifier, has a calorific value of 8–13MJ/m3 which is only 1/5–1/3 that of natural gas. However, the flame temperature of medium-Btu gasified coal fuel is higher than that of natural gas and so NOx production from nitrogen fixation is expected to increase significantly. In the oxygen-blown IGCC, a surplus nitrogen produced in the air-separation unit (ASU) is premixed with gasified coal fuel (medium-Btu fuel) and injected into the combustor, to reduce thermal-NOx production and to recover the power used for the ASU. In this case, the power to compress nitrogen increases. Low NOx emission technology which is capable of decreasing the power to compress nitrogen is a significant advance in gas turbine development with an oxygen-blown IGCC system. Analyses confirmed that the thermal efficiency of the plant improved by approximately 0.3 percent (absolute) by means of nitrogen direct injection into the combustor, compared with a case where nitrogen is premixed with gasified coal fuel before injection into the combustor. In this study, based on the fundamental test results using a small diffusion burner and a model combustor, we designed the combustor in which the nitrogen injection nozzles arranged on the burner were combined with the lean combustion technique for low-NOx emission. In this way, we could reduce the high temperature region, where originated the thermal-NOx production, near the burner positively. And then, a combustor with a swirling nitrogen injection function used for a gas turbine, was designed and constructed, and its performance was evaluated under pressurized conditions of actual operations using a simulated gasified coal fuel. From the combustion test results, the thermal-NOx emission decreased under 11ppm (corrected at 16% O2), combustion efficiency was higher than 99.9% at any gas turbine load. Moreover, there was different effects of pressure on thermal-NOx emission in medium-Btu fuel fired combustor from the case of natural gas fired combustor.


Author(s):  
Hiroshi Sato ◽  
Masaaki Mori

This paper describes the development of an ultra-low NOx gas turbine combustor for cogeneration systems. The combustor, called a double swirler staged combustor, utilizes three-staged premixed combustion for low NOx emission. The unique feature of the combustor is its tertiary premix nozzles located downstream of the double swirler premixing nozzles around the combustor liner. Engine output is controlled by simply varying the fuel gas flow, and therefore employs no complex variable geometries for air flow control. Atmospheric combustion tests have demonstrated the superior performance of the combustor. NOx level is maintained at less than 3 ppm (O2=15%) over the range of engine output between 50% and 100%. Assuming the general relationship that NOx emission is proportional to the square root of operating pressure, the NOx level is estimated at less than 9 ppm (O2=15%) at the actual pressure of 0.91 MPa (abs.). Atmospheric tests have also shown high combustion efficiency; more than 99.9% over the range of engine output between 60% and 100%. Emissions of CO and UHC are maintained at 0 and 1 ppm (O2=15%), respectively, at the full engine load.


Author(s):  
Da Wang ◽  
Yanhua Lai ◽  
Hongxia Zhao ◽  
Binguang Jia ◽  
Qiang Wang ◽  
...  

AbstractThe numerical simulation model of forced-air cooling of strawberries in a clamshell and a box was established by using computational fluid dynamics method. The cooling process of the simulation and the experiment results agreed well in different conditions, indicating that the simulation model was validated. The results showed that the 7/8 cooling time was 180 min, 135 min, 108 min and 100 min and the cooling uniformity coefficients were 0.31, 0.22, 0.24, 0.26 when the diameters of B-vent(the vent on the box) were 30 mm, 40 mm, 50 mm, 60 mm, respectively. The 7/8 cooling time decreased and the cooling uniformity coefficient improved, when the shape of C-vent (the vent on the clamshell) changed from round to rectangular. The 7/8 cooling time also deceased and the cooling uniformity coefficient increased, when the area of C-vent with both round and rectangular shapes increased. These results indicate that both B-vent and C-vent had significant effect on reducing the cooling time and the improving cooling uniformity for strawberries, It is suggested that the optimized vent ratio of B-vent (the diameter is 40 mm) and C-vent (15 mm round or 20 mm × 15 mm rectangular) for the current commercial packaged strawberries were 9.4 % and 8.5 %, respectively.


2018 ◽  
Vol 12 (1) ◽  
pp. 517-534 ◽  
Author(s):  
Eivaz Akbarian ◽  
Bahman Najafi ◽  
Mohsen Jafari ◽  
Sina Faizollahzadeh Ardabili ◽  
Shahaboddin Shamshirband ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document