Magnetoelastic effect in axial stressed Ni-Zn ferrite material in Rayleigh region

Abstract The paper presents new and original results of investigation on magnetoelastic effect in Ni-Zn ferrite formed into ring core and subjected to the axial stress up to 20 MPa. The core was magnetized with relatively low magnetizing field, corresponding to the so-called Rayleigh region. The obtained results indicate, that there is a significant correlation between applied stress and magnetic properties of the material and the Ni-Zn ferrite can be utilized in development of magnetoelastic sensor of force and stress.

Download Full-text

Influence of starting powder milling on magnetic properties of Mn-Zn ferrite

Processing and Application of Ceramics ◽

10.2298/pac1702160m ◽

2017 ◽

Vol 11 (2) ◽

pp. 160-169 ◽

Cited By ~ 1

Author(s):

Miodrag Milutinov ◽

Maria Nikolic ◽

Snezana Lukovic ◽

Nelu Blaz ◽

Nebojsa Labus ◽

...

Keyword(s):

Magnetic Properties ◽

Empirical Equation ◽

Structural Parameters ◽

Core Loss ◽

Complex Permeability ◽

Frequency Range ◽

X Ray Diffraction ◽

X Ray ◽

The Core ◽

Zn Ferrite

In this paper, the influence of additional sieving and milling of starting industrial Mn-Zn powders on magnetic properties was investigated. The starting powder was milled for 60 minutes, followed by sieving through 325 and 400 meshes. The starting and milled powders were used to fabricate toroid shaped samples sintered at 1200?C for 2 hours. Structural parameters of the fabricated samples were analysed by X-ray diffraction and scanning electron microscopy. Complex permeability, core loss density, and hysteresis were measured using the modified watt-meter method. The complex permeability and hysteresis loop were modelled with a new model proposed in the paper. The core loss density was modelled with the Steinmetz empirical equation. The experimental results and calculations show the significance of the additional milling and sieving process on magnetic properties of Mn-Zn ferrite in the frequency range 0.1-10MHz. These processes increase the relative permeability about 3 times and decrease the core loss 4 times by milling of the starting powder.

Download Full-text

Effect of Temperature on the Dielectric and Magnetic Properties of NiFe2O4@MgFe2O4 and ZnFe2O4@MgFe2O4 Core-Shell

10.21203/rs.3.rs-154061/v2 ◽

2021 ◽

Author(s):

Kheled Roumaih

Keyword(s):

Magnetic Properties ◽

Effective Magnetic Moment ◽

Room Temperature ◽

Mutual Effect ◽

Space Charge Polarization ◽

Effect Of Temperature ◽

Core Shell ◽

Metallic Behavior ◽

The Core ◽

Zn Ferrite

Abstract The core-shell NiFe2O4@MgFe2O4 (NiF@MgF) and ZnFe2O4@MgFe2O4 (ZnF@MgF) are stable nanocomposites. The experimental results showed perfect dielectric and magnetic properties different than their components. The experimental data revealed that the mutual effect between the core and the shell increases the space charge polarization. Also, the samples showed semiconducting-metallic behavior, which varies according to the temperatures and the frequencies. Furthermore, the magnetization M(T) was studied using the Faraday balance method of all samples. The obtained results of M(T) exhibit good magnetic properties of the core-shell samples, particularly the sample ZnF@MgF, where it possesses magnetization higher than the pure ferrite phase (MgFe2O4) and Curie temperature (TCm) higher than the room temperature, and this is new for Zn-ferrite. Besides, the effective magnetic moment (µEff) and the Curie-Weiss constant (θ) were obtained from the magnetic susceptibility χ(T) protocols.

Download Full-text

Magnetic Properties of Fe3O4/CoFe2O4 Composite Nanoparticles with Core/Shell Architecture

Ukrainian Journal of Physics ◽

10.15407/ujpe65.10.904 ◽

2020 ◽

Vol 65 (10) ◽

pp. 904

Author(s):

V. O. Zamorskyi ◽

Ya. M. Lytvynenko ◽

A. M. Pogorily ◽

A. I. Tovstolytkin ◽

S. O. Solopan ◽

...

Keyword(s):

Magnetic Properties ◽

Spinel Ferrite ◽

Composite Nanoparticles ◽

Core Shell ◽

Cofe2o4 Nanoparticles ◽

Core Diameter ◽

The Core ◽

Shell Particles ◽

Interface Parameters ◽

Shell Composite

Magnetic properties of the sets of Fe3O4(core)/CoFe2O4(shell) composite nanoparticles with a core diameter of about 6.3 nm and various shell thicknesses (0, 1.0, and 2.5 nm), as well as the mixtures of Fe3O4 and CoFe2O4 nanoparticles taken in the ratios corresponding to the core/shell material contents in the former case, have been studied. The results of magnetic research showed that the coating of magnetic nanoparticles with a shell gives rise to the appearance of two simultaneous effects: the modification of the core/shell interface parameters and the parameter change in both the nanoparticle’s core and shell themselves. As a result, the core/shell particles acquire new characteristics that are inherent neither to Fe3O4 nor to CoFe2O4. The obtained results open the way to the optimization and adaptation of the parameters of the core/shell spinel-ferrite-based nanoparticles for their application in various technological and biomedical domains.

Download Full-text

Investigation of the Structure and Magnetic Properties of Bulk Amorphous FeCoYB Alloy

Revista de Chimie ◽

10.37358/rc.17.9.5848 ◽

2017 ◽

Vol 68 (9) ◽

pp. 2162-2165 ◽

Cited By ~ 4

Author(s):

Katarzyna Bloch ◽

Mihail Aurel Titu ◽

Andrei Victor Sandu

Keyword(s):

Magnetic Field ◽

Magnetic Properties ◽

Hyperfine Field ◽

Irreversible Processes ◽

Magnetization Process ◽

Casting Method ◽

The Core ◽

Injection Casting ◽

Core Losses ◽

Microstructural Studies

The paper presents the results of structural and microstructural studies for the bulk Fe65Co10Y5B20 and Fe63Co10Y7B20 alloys. All the rods obtained by the injection casting method were fully amorphous. It was found on the basis of analysis of distribution of hyperfine field induction that the samples of Fe65Co10Y5B20 alloy are characterised with greater atomic packing density. Addition of Y to the bulk amorphous Fe65Co10Y5B20 alloy leads to the decrease of the average induction of hyperfine field value. In a strong magnetic field (i.e. greater than 0.4HC), during the magnetization process of the alloys, where irreversible processes take place, the core losses associated with magnetization and de-magnetization were investigated.

Download Full-text

Structural, Morphological and Magnetic Characterization of Sm-substituted Ni-Zn Ferrite

Nanoscience &Nanotechnology-Asia ◽

10.2174/2210681208666181018093813 ◽

2020 ◽

Vol 10 (2) ◽

pp. 152-156 ◽

Cited By ~ 1

Author(s):

Muhammad Hanif bin Zahari ◽

Beh Hoe Guan ◽

Lee Kean Chuan ◽

Afiq Azri bin Zainudin

Keyword(s):

Magnetic Properties ◽

Rare Earth ◽

Saturation Magnetization ◽

Sol Gel ◽

Magnetic Behavior ◽

Rare Earth Ions ◽

Ion Concentration ◽

Zn Ferrite ◽

Auto Combustion ◽

Combustion Technique

Background: Rare earth materials are known for its salient electrical insulation properties with high values of electrical resistivity. It is expected that the substitution of rare earth ions into spinel ferrites could significantly alter its magnetic properties. In this work, the effect of the addition of Samarium ions on the structural, morphological and magnetic properties of Ni0.5Zn0.5SmxFe2-xO4 (x=0.00, 0.02, 0.04, 0.06, 0.08, 0.10) synthesized using sol-gel auto combustion technique was investigated. Methods: A series of Samarium-substituted Ni-Zn ferrite nanoparticles (Ni0.5Zn0.5SmxFe2-xO4 where x=0.00, 0.02, 0.04, 0.06, 0.08, 0.10) were synthesized by sol-gel auto-combustion technique. Structural, morphological and magnetic properties of the samples were examined through X-Ray Diffraction (XRD), Field-Emission Scanning Electron Microscope (FESEM) and Vibrating Sample Magnetometer (VSM) measurements. Results: XRD patterns revealed single-phased samples with spinel cubic structure up to x= 0.04. The average crystallite size of the samples varied in the range of 41.8 – 85.6 nm. The prepared samples exhibited agglomerated particles with larger grain size observed in Sm-substituted Ni-Zn ferrite as compared to the unsubstituted sample. The prepared samples exhibited typical soft magnetic behavior as evidenced by the small coercivity field. The magnetic saturation, Ms values decreased as the Sm3+ concentration increases. Conclusion: The substituted Ni-Zn ferrites form agglomerated particles inching towards more uniform microstructure with each increase in Sm3+ substitution. The saturation magnetization of substituted samples decreases with the increase of samarium ion concentration. The decrease in saturation magnetization can be explained based on weak super exchange interaction between A and B sites. The difference in magnetic properties between the samples despite the slight difference in Sm3+ concentrations suggests that the properties of the NiZnFe2O4 can be ‘tuned’, depending on the present need, through the substitution of Fe3+ with rare earth ions.

Download Full-text