scholarly journals Particulate Matter Emission Reduction from Marine Diesel Engines by Electrohydrodynamic Methods

2019 ◽  
Vol 26 (3) ◽  
pp. 203-210
Author(s):  
Arkadiusz T. Sobczyk ◽  
Anatol Jaworek ◽  
Artur Marchewicz ◽  
Andrzej Krupa ◽  
Tadeusz Czech ◽  
...  

Abstract Particulate matter (PM) and gaseous compounds (SO2, NOx, VOC) emitted by diesel engines causes serious global environmental problems and health impact. Despite numerous evidences about the harmfulness of diesel particles, the PM emission by diesel engines used by ships, cars, agricultural machines, or power generators is still unregulated, and the efficient removal of PM from diesel exhausts is still the major technological challenge. In order to comply with the International Maritime Organization regulation, the NOx emission is reduced by using selected catalytic reactor, and sulphur oxide emission has been reduced by using fuels of low sulphur content. However, both of those measures cannot be used for the reduction of PM emission produced during combustion of marine fuels. The lack of appropriate regulations results from insufficiently developed technology, which could remove those particles from exhaust gases. Conventional scrubbers currently available on the market remove only sulphur oxide with required collection efficiency, but the collection efficiency for PM2.5 is below 50%. The article discusses the technical means used for the removal of PM from marine diesel engines via applying electrohydrodynamic methods, in particular electrostatic agglomeration, as a method of nanoparticles coagulation to larger agglomerates, which could operate in two-stage electrostatic precipitation systems, and electrostatic scrubbers, which remove particles by electrically charged water droplets. The experimental results were obtained for a 2-stroke 73 kW diesel engine fuelled with marine gas oil (MGO). The agglomerator allowed increasing the collection efficiency from diesel exhausts for PM2.5 particles by about 12%, compared to electrostatic precipitator operating without agglomerator, and the total mass collection efficiency was above 74%. The collection efficiency of electrostatic scrubber was higher than 95wt.%. The advantage of using the electrostatic scrubber is that it can also reduce the SO2 emission by more than 90%, when HFO is used.

2012 ◽  
Vol 148 (1) ◽  
pp. 48-52
Author(s):  
Andrey POLIVYANCHUK ◽  
Oleg IGNATOV

The paper presents the influence of the conditioning of filters used in the gravimetric measurement of particulate matter emission on the mass of the particles. The influence of the time of filter conditioning on the obtained results as well as the influence of the temperature of the sample before the filtering on the measurement uncertainty have been subjected to analysis. In the further part the influence of the ranges of temperatures of the filter conditioning on the mass of the PM sample have been determined as per the standardization for the tests of diesel engines fitted in passenger vehicles, heavy-duty vehicles and buses (regulation R-83 and R-49 respectively). In the final part recommendations have been formulated that allow a reduction of the measurement error.


2007 ◽  
Vol 42 (2) ◽  
pp. 281-287
Author(s):  
I Made Ariana ◽  
Osami Nishida ◽  
Hirotsugu Fujita ◽  
Wataru Harano ◽  
Megumi Fujio

Author(s):  
Pi-Qiang Tan ◽  
Jia-Xiang Lu ◽  
Kang-Yao Deng

In this study, a phenomenological model, that predicts the particulate matter emission (PM) of diesel engines, has been formulated. The CO-PM model is based on the formation mechanisms of PM and carbon monoxide (CO) of diesel engines. It can predict the emission concentration of PM via the emission concentration of CO. The calculation method of the model is simple and quick. To validate the model, experiments were carried out in two research diesel engines. Comparisons of the model results with the experimental data show good agreement. The model is useful for computer simulations of electronically controlled diesel engines, as well as electronic control unit (ECU) designs for diesel engines.


2017 ◽  
Vol 52 (6) ◽  
pp. 778-787
Author(s):  
Atsuto Ohashi ◽  
Hideyuki Shirota ◽  
Mayuko Nakamura ◽  
Akiko Masuda

Sign in / Sign up

Export Citation Format

Share Document