scholarly journals Component Analysis of Particulate Matter Emitted from Marine Diesel Engines - Application to Air Quality Simulation

2017 ◽  
Vol 52 (6) ◽  
pp. 778-787
Author(s):  
Atsuto Ohashi ◽  
Hideyuki Shirota ◽  
Mayuko Nakamura ◽  
Akiko Masuda
Keyword(s):  
Particulate Matter ◽  
Air Quality ◽  
Diesel Engines ◽  
Component Analysis ◽  
Marine Diesel

scholarly journals Particulate Matter Emission Reduction from Marine Diesel Engines by Electrohydrodynamic Methods

2019 ◽  
Vol 26 (3) ◽  
pp. 203-210
Author(s):  
Arkadiusz T. Sobczyk ◽  
Anatol Jaworek ◽  
Artur Marchewicz ◽  
Andrzej Krupa ◽  
Tadeusz Czech ◽  
...  
Keyword(s):  
Particulate Matter ◽  
Diesel Engines ◽  
Electrostatic Precipitator ◽  
Collection Efficiency ◽  
Health Impact ◽  
Power Generators ◽  
Sulphur Oxide ◽  
Particulate Matter Emission ◽  
Global Environmental Problems ◽  
Marine Diesel

Abstract Particulate matter (PM) and gaseous compounds (SO2, NOx, VOC) emitted by diesel engines causes serious global environmental problems and health impact. Despite numerous evidences about the harmfulness of diesel particles, the PM emission by diesel engines used by ships, cars, agricultural machines, or power generators is still unregulated, and the efficient removal of PM from diesel exhausts is still the major technological challenge. In order to comply with the International Maritime Organization regulation, the NOx emission is reduced by using selected catalytic reactor, and sulphur oxide emission has been reduced by using fuels of low sulphur content. However, both of those measures cannot be used for the reduction of PM emission produced during combustion of marine fuels. The lack of appropriate regulations results from insufficiently developed technology, which could remove those particles from exhaust gases. Conventional scrubbers currently available on the market remove only sulphur oxide with required collection efficiency, but the collection efficiency for PM2.5 is below 50%. The article discusses the technical means used for the removal of PM from marine diesel engines via applying electrohydrodynamic methods, in particular electrostatic agglomeration, as a method of nanoparticles coagulation to larger agglomerates, which could operate in two-stage electrostatic precipitation systems, and electrostatic scrubbers, which remove particles by electrically charged water droplets. The experimental results were obtained for a 2-stroke 73 kW diesel engine fuelled with marine gas oil (MGO). The agglomerator allowed increasing the collection efficiency from diesel exhausts for PM2.5 particles by about 12%, compared to electrostatic precipitator operating without agglomerator, and the total mass collection efficiency was above 74%. The collection efficiency of electrostatic scrubber was higher than 95wt.%. The advantage of using the electrostatic scrubber is that it can also reduce the SO2 emission by more than 90%, when HFO is used.

scholarly journals The impact of measures to reduce ambient air PM<sub>10</sub> concentrations originating from road dust, evaluated for a street canyon in Helsinki

2019 ◽  
Vol 19 (17) ◽  
pp. 11199-11212 ◽  
Author(s):  
Ana Stojiljkovic ◽  
Mari Kauhaniemi ◽  
Jaakko Kukkonen ◽  
Kaarle Kupiainen ◽  
Ari Karppinen ◽  
...  
Keyword(s):  
Particulate Matter ◽  
Air Quality ◽  
Street Canyon ◽  
Dust Emission ◽  
Road Dust ◽  
Ambient Air ◽  
Air Quality Measurements ◽  
Emission Models ◽  
The Impact ◽  
Quality Measurements

Abstract. We have numerically evaluated how effective selected potential measures would be for reducing the impact of road dust on ambient air particulate matter (PM10). The selected measures included a reduction of the use of studded tyres on light-duty vehicles and a reduction of the use of salt or sand for traction control. We have evaluated these measures for a street canyon located in central Helsinki for four years (2007–2009 and 2014). Air quality measurements were conducted in the street canyon for two years, 2009 and 2014. Two road dust emission models, NORTRIP (NOn-exhaust Road TRaffic Induced Particle emissions) and FORE (Forecasting Of Road dust Emissions), were applied in combination with the Operational Street Pollution Model (OSPM), a street canyon dispersion model, to compute the street increments of PM10 (i.e. the fraction of PM10 concentration originating from traffic emissions at the street level) within the street canyon. The predicted concentrations were compared with the air quality measurements. Both road dust emission models reproduced the seasonal variability of the PM10 concentrations fairly well but under-predicted the annual mean values. It was found that the largest reductions of concentrations could potentially be achieved by reducing the fraction of vehicles that use studded tyres. For instance, a 30 % decrease in the number of vehicles using studded tyres would result in an average decrease in the non-exhaust street increment of PM10 from 10 % to 22 %, depending on the model used and the year considered. Modelled contributions of traction sand and salt to the annual mean non-exhaust street increment of PM10 ranged from 4 % to 20 % for the traction sand and from 0.1 % to 4 % for the traction salt. The results presented here can be used to support the development of optimal strategies for reducing high springtime particulate matter concentrations originating from road dust.

scholarly journals Spatial Analysis (Measurements at Heights of 10 m and 20 m above Ground Level) of the Concentrations of Particulate Matter (PM10, PM2.5, and PM1.0) and Gaseous Pollutants (H2S) on the University Campus: A Case Study

Atmosphere ◽  
2021 ◽  
Vol 12 (1) ◽  
pp. 62
Author(s):  
Robert Cichowicz ◽  
Maciej Dobrzański
Keyword(s):  
Spatial Distribution ◽  
Hydrogen Sulfide ◽  
Particulate Matter ◽  
Air Quality ◽  
Spatial Analysis ◽  
Ground Level ◽  
Leeward Side ◽  
High Concentration ◽  
Above Ground Level ◽  
High Concentrations

Spatial analysis of the distribution of particulate matter PM10, PM2.5, PM1.0, and hydrogen sulfide (H2S) gas pollution was performed in the area around a university library building. The reasons for the subject matter were reports related to the perceptible odor characteristic of hydrogen sulfide and a general poor assessment of air quality by employees and students. Due to the area of analysis, it was decided to perform measurements at two heights, 10 m and 20 m above ground level, using measuring equipment attached to a DJI Matrice 600 unmanned aerial vehicle (UAV). The aim of the measurements was air quality assessment and investigate the convergence of the theory of air flow around the building with the spatial distribution of air pollutants. Considerable differences of up to 63% were observed in the concentrations of pollutants measured around the building, especially between opposite sides, depending on the direction of the wind. To explain these differences, the theory of aerodynamics was applied to visualize the probable airflow in the direction of the wind. A strong convergence was observed between the aerodynamic model and the spatial distribution of pollutants. This was evidenced by the high concentrations of dust in the areas of strong turbulence at the edges of the building and on the leeward side. The accumulation of pollutants was also clearly noticeable in these locations. A high concentration of H2S was recorded around the library building on the side of the car park. On the other hand, the air turbulence around the building dispersed the gas pollution, causing the concentration of H2S to drop on the leeward side. It was confirmed that in some analyzed areas the permissible concentration of H2S was exceeded.

scholarly journals The Diamond League athletic series: does the air quality sparkle?

2021 ◽  
Author(s):  
James R. Hodgson ◽  
Lee Chapman ◽  
Francis D. Pope
Keyword(s):  
Particulate Matter ◽  
Air Quality ◽  
Performance Metrics ◽  
Urban Air Pollution ◽  
Quality Data ◽  
Performance Variation ◽  
Short And Long Term ◽  
Respiratory Conditions ◽  
Race Performance

AbstractUrban air pollution can have negative short- and long-term impacts on health, including cardiovascular, neurological, immune system and developmental damage. The irritant qualities of pollutants such as ozone (O3), nitrogen dioxide (NO2) and particulate matter (PM) can cause respiratory and cardiovascular distress, which can be heightened during physical activity and particularly so for those with respiratory conditions such as asthma. Previously, research has only examined marathon run outcomes or running under laboratory settings. This study focuses on elite 5-km athletes performing in international events at nine locations. Local meteorological and air quality data are used in conjunction with race performance metrics from the Diamond League Athletics series to determine the extent to which elite competitors are influenced during maximal sustained efforts in real-world conditions. The findings from this study suggest that local meteorological variables (temperature, wind speed and relative humidity) and air quality (ozone and particulate matter) have an impact on athletic performance. Variation between finishing times at different race locations can also be explained by the local meteorology and air quality conditions seen during races.

scholarly journals Spatial and Temporal Characteristics of Environmental Air Quality and Its Relationship with Seasonal Climatic Conditions in Eastern China during 2015–2018

2021 ◽  
Vol 18 (9) ◽  
pp. 4524
Author(s):  
Zhiyuan Wang ◽  
Xiaoyi Shi ◽  
Chunhua Pan ◽  
Sisi Wang
Keyword(s):  
Particulate Matter ◽  
Air Quality ◽  
Air Pollutants ◽  
Large Scale ◽  
Asian Summer Monsoon ◽  
Eastern China ◽  
Climatic Conditions ◽  
Uniform Structure ◽  
Concentration Limit ◽  
Environmental Air

Exploring the relationship between environmental air quality (EAQ) and climatic conditions on a large scale can help better understand the main distribution characteristics and the mechanisms of EAQ in China, which is significant for the implementation of policies of joint prevention and control of regional air pollution. In this study, we used the concentrations of six conventional air pollutants, i.e., carbon monoxide (CO), sulfur dioxide (SO2), nitrogen dioxide (NO2), fine particulate matter (PM2.5), coarse particulate matter (PM10), and ozone (O3), derived from about 1300 monitoring sites in eastern China (EC) from January 2015 to December 2018. Exploiting the grading concentration limit (GB3095-2012) of various pollutants in China, we also calculated the monthly average air quality index (AQI) in EC. The results show that, generally, the EAQ has improved in all seasons in EC from 2015 to 2018. In particular, the concentrations of conventional air pollutants, such as CO, SO2, and NO2, have been decreasing year by year. However, the concentrations of particulate matter, such as PM2.5 and PM10, have changed little, and the O3 concentration increased from 2015 to 2018. Empirical mode decomposition (EOF) was used to analyze the major patterns of AQI in EC. The first mode (EOF1) was characterized by a uniform structure in AQI over EC. These phenomena are due to the precipitation variability associated with the East Asian summer monsoon (EASM), referred to as the “summer–winter” pattern. The second EOF mode (EOF2) showed that the AQI over EC is a north–south dipole pattern, which is bound by the Qinling Mountains and Huaihe River (about 35° N). The EOF2 is mainly caused by seasonal variations of the mixed concentration of PM2.5 and O3. Associated with EOF2, the Mongolia–Siberian High influences the AQI variation over northern EC by dominating the low-level winds (10 m and 850 hPa) in autumn and winter, and precipitation affects the AQI variation over southern EC in spring and summer.

Sign in / Sign up

Export Citation Format

Share Document