Effect of Active Camber on Rotor Noise, Power and Hub Vibration

2021 ◽  
Author(s):  
Sumeet Kumar ◽  
Dominik Komp ◽  
Manfred Hajek ◽  
Juergen Rauleder
Keyword(s):  
Noise Power ◽  
Rotor Noise

Ultimate resolution and information in electron microscopy

1991 ◽  
Vol 49 ◽  
pp. 496-497
Author(s):  
D. Van Dyck
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Transfer Function ◽  
Information Transfer ◽  
Communication Channel ◽  
Structural Information ◽  
Information Rate ◽  
Noise Power ◽  
Signal Power ◽  
Imaging Device

An (electron) microscope can be considered as a communication channel that transfers structural information between an object and an observer. In electron microscopy this information is carried by electrons. According to the theory of Shannon the maximal information rate (or capacity) of a communication channel is given by C = B log2 (1 + S/N) bits/sec., where B is the band width, and S and N the average signal power, respectively noise power at the output. We will now apply to study the information transfer in an electron microscope. For simplicity we will assume the object and the image to be onedimensional (the results can straightforwardly be generalized). An imaging device can be characterized by its transfer function, which describes the magnitude with which a spatial frequency g is transferred through the device, n is the noise. Usually, the resolution of the instrument ᑭ is defined from the cut-off 1/ᑭ beyond which no spadal information is transferred.

Analysis of photographic emulsions for High-Voltage Electron Microscopy

1993 ◽  
Vol 51 ◽  
pp. 452-453 ◽  
Author(s):  
James R. Kremer ◽  
Paul S. Furcinitti ◽  
Eileen O’Toole ◽  
J. Richard McIntosh
Keyword(s):  
Electron Microscope ◽  
Optical Density ◽  
High Voltage ◽  
Noise Power ◽  
Limited Information ◽  
Modulation Transfer ◽  
Transmission Microscopy ◽  
High Voltage Electron Microscopy ◽  
Voltage Range ◽  
Voltage Electron

Characteristics of electron microscope film emulsions, such as the speed, the modulation transfer function, and the exposure dependence of the noise power spectrum, have been studied for electron energies (80-100keV) used in conventional transmission microscopy. However, limited information is available for electron energies in the intermediate to high voltage range, 300-1000keV. Furthermore, emulsion characteristics, such as optical density versus exposure, for new or improved emulsions are usually only quoted by film manufacturers for 80keV electrons. The need for further film emulsion studies at higher voltages becomes apparent when searching for a film to record low dose images of radiation sensitive biological specimens in the frozen hydrated state. Here, we report the optical density, speed and relative resolution of a few of the more popular electron microscope films after exposure to 1MeV electrons.Three electron microscope films, Kodak S0-163, Kodak 4489, and Agfa Scientia 23D56 were tested with a JEOLJEM-1000 electron microscope operating at an accelerating voltage of 1000keV.

Object Detection Using an Ideal Observer Model

2020 ◽  
Vol 2020 (16) ◽  
pp. 41-1-41-7
Author(s):  
Orit Skorka ◽  
Paul J. Kane
Keyword(s):  
Object Detection ◽  
Matched Filter ◽  
Image Sensors ◽  
Ideal Observer ◽  
Noise Power ◽  
Relative Evaluation ◽  
Detection And Identification ◽  
Cross Correlation Analysis ◽  
Observer Model ◽  
The Ideal

Many of the metrics developed for informational imaging are useful in automotive imaging, since many of the tasks – for example, object detection and identification – are similar. This work discusses sensor characterization parameters for the Ideal Observer SNR model, and elaborates on the noise power spectrum. It presents cross-correlation analysis results for matched-filter detection of a tribar pattern in sets of resolution target images that were captured with three image sensors over a range of illumination levels. Lastly, the work compares the crosscorrelation data to predictions made by the Ideal Observer Model and demonstrates good agreement between the two methods on relative evaluation of detection capabilities.

scholarly journals Study on Time Reversal Maximum Ratio Combining in Underwater Acoustic Communications

2021 ◽  
Vol 11 (4) ◽  
pp. 1509
Author(s):  
Anbang Zhao ◽  
Caigao Zeng ◽  
Juan Hui ◽  
Keren Wang ◽  
Kaiyu Tang
Keyword(s):  
Time Reversal ◽  
Signal To Noise Ratio ◽  
Spatial Diversity ◽  
Single Element ◽  
Noise Power ◽  
Theoretical Derivation ◽  
Underwater Acoustic ◽  
Maximum Ratio Combining ◽  
Weight Coefficients ◽  
Output Snr

Time reversal (TR) can achieve temporal and spatial focusing by exploiting spatial diversity in complex underwater environments with significant multipath. This property makes TR useful for underwater acoustic (UWA) communications. Conventional TR is realized by performing equal gain combining (EGC) on the single element TR output signals of each element of the vertical receive array (VRA). However, in the actual environment, the signal-to-noise ratio (SNR) and the received noise power of each element are different, which leads to the reduction of the focusing gain. This paper proposes a time reversal maximum ratio combining (TR-MRC) method to process the received signals of the VRA, so that a higher output SNR can be obtained. The theoretical derivation of the TR-MRC weight coefficients indicates that the weight coefficients are only related to the input noise power of each element, and are not affected by the multipath structure. The correctness of the derivation is demonstrated with the experimental data of the long-range UWA communications conducted in the South China Sea. In addition, the experimental results illustrate that compared to the conventional TR, TR-MRC can provide better performance in terms of output SNR and bit error rate (BER) in UWA communications.

scholarly journals Robustness against Chirp Signal Interference of On-Board Vehicle Geodetic and Low-Cost GNSS Receivers

Sensors ◽  
2021 ◽  
Vol 21 (16) ◽  
pp. 5257
Author(s):  
Franc Dimc ◽  
Polona Pavlovčič-Prešeren ◽  
Matej Bažec
Keyword(s):  
Interference Mitigation ◽  
Low Cost ◽  
Density Ratio ◽  
Autonomous Driving ◽  
Signal Interference ◽  
Noise Power ◽  
Reference Base ◽  
Noise Power Spectral Density ◽  
Processing Abilities ◽  
Gnss Receivers

Robust autonomous driving, as long as it relies on satellite-based positioning, requires carrier-phase-based algorithms, among other types of data sources, to obtain precise and true positions, which is also primarily true for the use of GNSS geodetic receivers, but also increasingly true for mass-market devices. The experiment was conducted under line-of-sight conditions on a straight road during a period of no traffic. The receivers were positioned on the roof of a car travelling at low speed in the presence of a static jammer, while kinematic relative positioning was performed with the static reference base receiver. Interference mitigation techniques in the GNSS receivers used, which were unknown to the authors, were compared using (a) the observed carrier-to-noise power spectral density ratio as an indication of the receivers’ ability to improve signal quality, and (b) the post-processed position solutions based on RINEX-formatted data. The observed carrier-to-noise density generally exerts the expected dependencies and leaves space for comparisons of applied processing abilities in the receivers, while conclusions on the output data results comparison are limited due to the non-synchronized clocks of the receivers. According to our current and previous results, none of the GNSS receivers used in the experiments employs an effective type of complete mitigation technique adapted to the chirp jammer.

scholarly journals Noise power spectral density scaled SNR response estimation with restricted range search for sound source localisation using unmanned aerial vehicles

2020 ◽  
Vol 2020 (1) ◽  
Author(s):  
Benjamin Yen ◽  
Yusuke Hioka
Keyword(s):  
Spectral Density ◽  
Noise Reduction ◽  
Power Spectral Density ◽  
Sound Source ◽  
Processing Algorithm ◽  
Post Processing ◽  
Time Frequency ◽  
Distance Error ◽  
Rotor Noise ◽  
Power Spectral

Abstract A method to locate sound sources using an audio recording system mounted on an unmanned aerial vehicle (UAV) is proposed. The method introduces extension algorithms to apply on top of a baseline approach, which performs localisation by estimating the peak signal-to-noise ratio (SNR) response in the time-frequency and angular spectra with the time difference of arrival information. The proposed extensions include a noise reduction and a post-processing algorithm to address the challenges in a UAV setting. The noise reduction algorithm reduces influences of UAV rotor noise on localisation performance, by scaling the SNR response using power spectral density of the UAV rotor noise, estimated using a denoising autoencoder. For the source tracking problem, an angular spectral range restricted peak search and link post-processing algorithm is also proposed to filter out incorrect location estimates along the localisation path. Experimental results show the proposed extensions yielded improvements in locating the target sound source correctly, with a 0.0064–0.175 decrease in mean haversine distance error across various UAV operating scenarios. The proposed method also shows a reduction in unexpected location estimations, with a 0.0037–0.185 decrease in the 0.75 quartile haversine distance error.

scholarly journals On Asymptotic Efficiency of the M2M4 Signal-to-Noise Estimator for Deterministic Complex Sinusoids

Sensors ◽  
2021 ◽  
Vol 21 (15) ◽  
pp. 4950
Author(s):  
Gianmarco Romano
Keyword(s):  
Covariance Matrix ◽  
Gaussian Noise ◽  
Asymptotic Efficiency ◽  
Noise Power ◽  
Finite Sample ◽  
Signal To Noise ◽  
Numerical Examples ◽  
Unknown Phase ◽  
The Moment ◽  
Asymptotically Efficient

The moment-based M2M4 signal-to-noise (SNR) estimator was proposed for a complex sinusoidal signal with a deterministic but unknown phase corrupted by additive Gaussian noise by Sekhar and Sreenivas. The authors studied its performances only through numerical examples and concluded that the proposed estimator is asymptotically efficient and exhibits finite sample super-efficiency for some combinations of signal and noise power. In this paper, we derive the analytical asymptotic performances of the proposed M2M4 SNR estimator, and we show that, contrary to what it has been concluded by Sekhar and Sreenivas, the proposed estimator is neither (asymptotically) efficient nor super-efficient. We also show that when dealing with deterministic signals, the covariance matrix needed to derive asymptotic performances must be explicitly derived as its known general form for random signals cannot be extended to deterministic signals. Numerical examples are provided whose results confirm the analytical findings.

Sign in / Sign up

Export Citation Format

Share Document