MATHEMATICAL MODELING OF A COLUMN PURIFICATION OF WASTE INCINERATION EXHAUST GASES

Author(s):  
Wellington Balmant ◽  
Ericson Dilay ◽  
Dhyogo Miléo Taher ◽  
André Mariano ◽  
José Viriato Coelho Vargas
2021 ◽  
Vol 93 (6s) ◽  
pp. 217-223
Author(s):  
Hristo Hristov ◽  
◽  
Ivailo Bakalov ◽  
Bogdan Shopov ◽  
Dobromir Yovkov ◽  
...  

The idea of this publication is to show how mathematical modeling presents dependence of CO2 in the exhaust gases. Using quadratic function obtained results are with good approximation. The future below to hydrogen about marine uses. Mathematical modeling is the best way to show how we can make an experiment with small database and that with mathematical function we receive a full picture of problem that we research with data which can’t receive with real experiment.


2020 ◽  
Vol 3 (156) ◽  
pp. 62-68
Author(s):  
A. Polivyanchuk

The work is devoted to solving an urgent scientific and practical task – establishing mathematical models that describe the effect of operating modes of diesel engines on the content in the exhaust gases of a dangerous pollutant – particulate matter (PM). The purpose of the work was to create and study the accuracy and practical suitability of the calculation method estimating concentrations and emissions with exhaust gases PM by means of mathematical modeling of the influence on them of parameters that determine steady state and unsteady diesel operation modes. The studies were carried out on the basis of the motor stand of a 4ChN12/14 autotractor diesel equipped with a partial-flow system for diluting EG with air – MKT-2 microtunnels. Measurements mass and vol-ume concentrations – cpt (g/kg) and Cpt (g/mn3), mass – PTmass (g/h) and specific – PTp (g/kWh) PM emissions was carried out by the gravimetric method with errors of ± 3 .. 10% in accordance with the requirements of regulatory documents – ISO8178 standard, UNECE Rules R-49, R-96, etc. As parameters which determine the mode of opera-tion of the diesel engine, were considered: during the study steady-state modes – the number of revolutions of the engine crankshaft (n, min-1) and the load (L,%); in the study of unsteady modes – the parameters n and L and the rate of change over time – Δn/Δt and ΔL/Δt. A dependence has been established for indirectly determining the mass concentration of PM in the exhaust gases at steady and unsteady diesel operating modes, which are charac-terized by a duration of 10 ... 30 s and ranges of vari-ation of the parameters n, L, Δn/Δt and ΔL/Δt, given in di-mensionless form: 0.4 ... 0.8, 0.3 ... 1.0, -0.2 ... 0.2 and -0.35 ... 0.35, respectively. The deviation of the calculated and experimental data when using this dependence is ± 0.005-0.006 g/kg, which is comparable with the sensitivity limit of MKT-2. Keywords: diesel, exhaust gases, particulate matter, concentration, test mode, mathematical model, accuracy.


Author(s):  
Matias Nicolas Muñoz ◽  
JOSÉ VIRIATO COELHO VARGAS ◽  
Wellington Balmant ◽  
Luiz Rigatti ◽  
Iago Costa ◽  
...  

2015 ◽  
Vol 46 (S 01) ◽  
Author(s):  
R. Lampe ◽  
N. Botkin ◽  
V. Turova ◽  
T. Blumenstein ◽  
A. Alves-Pinto

Sign in / Sign up

Export Citation Format

Share Document