The present work combines experimental measurements and unsteady, three-dimensional computational fluid dynamics predictions to gain further insight into the complex flow-field within an automotive turbocharger centrifugal compressor. Flow separation from the suction surface of the main impeller blades first occurs in the mid-flow range, resulting in local flow reversal near the periphery, with the severity increasing with decreasing flow rate. This flow reversal improves leading-edge incidence over the remainder of the annulus, due to (a) reduction of cross-sectional area of forward flow, which increases the axial velocity, and (b) prewhirl in the direction of impeller rotation, as a portion of the tangential velocity of the reversed flow is maintained when it mixes with the core flow and transitions to the forward direction. As the compressor operating point enters the region where the slope of the constant speed compressor characteristic (pressure ratio versus mass flow rate) becomes positive, rotating stall cells appear near the shroud side diffuser wall. The angular propagation speed of the diffuser rotating stall cells is approximately 20% of the shaft speed, generating pressure fluctuations near 20% and 50% of the shaft frequency, which were also experimentally observed. For the present compressor and rotational speed, flow losses associated with diffuser rotating stall are likely the key contributor to increasing the slope of the constant speed compressor performance curve to a positive value, promoting the conditions required for surge instabilities. The present mild surge predictions agree well with the measurements, reproducing the amplitude and period of compressor outlet pressure fluctuations.
Erratum to “Computational Fluid Dynamics Study on Attainable Flow Rate in a Lamella Settler by Increasing Inclined Plates” [J. Water Environ. Technol., Vol. 17, No. 2, pp. 76–88, 2019]
