scholarly journals Effects of concentration and solvent composition on the electrical conductivity of sodium bromide in pure water and ethanol-water mixed solvent media

Author(s):  
Ajaya Bhattarai ◽  
Sanjay Neupane

Precise measurements on the conductivity of Sodium Bromide in pure water and ethanol-water mixed solvent media containing 0.10, 0.20, 0.30, 0.40, 0.50 and 0.60 volume fractions of ethanol at room temperature are reported. The concentrations were varied from ~ 0.010 to ~ 0.10 mol.L-1. The results showed a sharp increase in the conductivity with increasing electrolyte concentration. The conductivity of electrolyte decreases with increase in the amount of ethanol.Kathmandu University Journal of Science, Engineering and Technology Vol. 8, No. II, December, 2012, 1-6 DOI: http://dx.doi.org/10.3126/kuset.v8i2.7318 

2013 ◽  
Vol 13 (1) ◽  
pp. 89-93 ◽  
Author(s):  
Ajaya Bhattarai ◽  
Sujit Kumar Shah ◽  
Ashok Kumar Yadav

The accurate measurement of the specific conductivity of cetylpyridinium chloride in pure water and ethanol-water mixed solvent media containing 0.10, 0.20, 0.30 and 0.40 volume fraction of ethanol at room temperature are reported. The concentrations were varied from ~ 0.005 mol l-1 to ~ 0.0002 mol l-1.The conductivity of cetylpyridinium chloride decreases with the increase in the volume fraction of ethanol. The critical micelle concentration of cetylpyridinium chloride increases with the increase in the volume fraction of ethanol. Nepal Journal of Science and Technology Vol. 13, No. 1 (2012) 89-93 DOI: http://dx.doi.org/10.3126/njst.v13i1.7446


2012 ◽  
Vol 12 ◽  
pp. 187-192 ◽  
Author(s):  
Ajaya Bhattarai ◽  
Deepak Sapkota ◽  
Netra P Subedi ◽  
Manoj Khanal ◽  
Tulsi P Niraula

Precise measurements on the conductivity of Sodium nitrate in methanol-water mixed solvent media containing 0.10, 0.20, 0.30 and 0.40 volume fractions of methanol at 308.15, 318.15 and 323.15 K are reported. The concentrations were varied from (0.001 to 0.15) mol.L-1. The results showed a sharp increase in the conductivity with increasing electrolyte concentration. Also, the conductivity of electrolyte increases with increase in temperature whereas the conductivity of electrolyte decreases with increase in the amount of methanol.DOI: http://dx.doi.org/10.3126/njst.v12i0.6498 Nepal Journal of Science and Technology 12 (2011) 187-92 


BIBECHANA ◽  
2012 ◽  
Vol 9 ◽  
pp. 63-68 ◽  
Author(s):  
Ajaya Bhattarai ◽  
Sujit Kumar Shah ◽  
Ashok Kumar Yadav ◽  
Janak Adhikari

The precise measurement of the specific conductivity of sodium deoxycholate in pure water and ethanolwater mixed solvent media containing 0.10 and 0.20 volume fraction of ethanol at 303.15 K are reported. The concentration were varied from ~ 0.01 mol L-1 to ~ 0.0002 mol L-1.The conductivity of sodium deoxycholate decreases with the increase in the volume fraction of ethanol. The critical micelle concentration of sodium deoxycholate increases with the increase in the volume fraction of ethanol. DOI: http://dx.doi.org/10.3126/bibechana.v9i0.7176 BIBECHANA 9 (2013) 63-68


2013 ◽  
Vol 29 ◽  
pp. 5-10
Author(s):  
Tulasi Prasad Niraula ◽  
Sujeet Kumar Chatterjee ◽  
Ajaya Bhattarai

Correction: On 10/01/2014, the first author of this paper was changed from Tulsi Ram Niraula to Tulasi Prasad NiraulaPrecise measurements on conductivity of sodium dodecyl sulphate in presence and in absence of KCl and NaBr in methanol-water mixed solvent media containing 0.1, 0.2, 0.3, and 0.4 volume fractions of methanol at 308.15K are reported. The concentrations were varied from ~ 0.001 to ~ 0.05 mol-1. The results showed a sharp increase in conductivity with increase in concentration of sodium dodecyl sulphate. Also,the conductivity of sodium dodecyl sulphate increases with addition of salts. The conductivity of sodium dodecyl sulphate decreases with increase in amount of methanol. The conductance of sodium dodecyl sulphate is found more in presence of KCl than NaBr in methanol-water mixed solvent media containing 0.1, 0.2, 0.3, and 0.4 volume fractions of methanol. DOI: http://dx.doi.org/10.3126/jncs.v29i0.9230Journal of Nepal Chemical SocietyVol. 29, 2012Page: 5-10Uploaded date : 12/3/2013


BIBECHANA ◽  
2015 ◽  
Vol 13 ◽  
pp. 114-120
Author(s):  
Ajaya Bhattarai ◽  
Kavita Pathak ◽  
Bikash Dev

The properties of anionic-rich and cationic-rich mixtures of dodecyltrimethylammonium bromide (DTAB) and sodium dodecylsulfate (SDS) in pure water and methanol-water mixed solvent media were studied using density measurements at room temperature. The results showed that density increases with increasing concentration of surfactant mixture over the entire concentration range investigated in pure water and in the given mixed solvent media and which are found to decrease with an increase in the volume fraction of methanol in the solvent composition. The critical micelle concentration increases with the increase in volume fraction of methanol for both the anionic-rich (SDS-DTAB) and cationic-rich (DTAB-SDS) systems.BIBECHANA 13 (2016) 114-120


1970 ◽  
Vol 24 ◽  
pp. 24-30 ◽  
Author(s):  
Sujit Kumar Shah ◽  
Ajaya Bhattarai ◽  
Ghanashyam Shrivastav ◽  
Sujeet Kumar Chatterjee

The author Ajay Bhattarai was changed to Ajaya Bhattarai and the author Kumar Chatterjee was changed to Sujeet Kumar ChatterjeePrecise measurements on the density of cetyltrimethylammonium bromide solutions in pure water and in methanol(1) + water (2) mixed solvent media containing 0.10, 0.20 and 0.30 volume fractions of methanol at 308.15, 318.15 and 323.15 K are carried out to calculate the partial molar volumes. The concentrations are varied from 0.3 - 1.0 x 10-1 mol.l-1. The results showed almost constant on the partial molar volumes with increasing surfactant concentration. Also, the partial molar volumes are found to increase with increasing temperature over the entire concentration range investigated in a given mixed solvent medium and these values are found to decrease with increasing methanol content in the solvent composition. Keywords: Mixed solvent; Cetyltrimethylammonium bromide; Surfactan; Partial molarDOI: 10.3126/jncs.v24i0.2383 Journal of Nepal Chemical Society, Vol. 24, 2009 Page: 24-30


BIBECHANA ◽  
2012 ◽  
Vol 9 ◽  
pp. 159-164
Author(s):  
Tulasi Prasad Niraula ◽  
Ajaya Bhattarai ◽  
Sujeet Kumar Chatterjee

Precise measurements on conductivity of sodium dodecyl sulphate in presence and in absence of KBr and NaCl in methanol-water mixed solvent media containing 0.1, 0.2 and 0.4 volume fractions of methanol at 308.15K are reported. The concentrations were varied from ~ 0.001 to ~ 0.03 mol.l-1. The results showed a sharp increase in conductivity with increase in concentration of sodium dodecyl sulphate. Also, the conductivity of sodium dodecyl sulphate increases with addition of salts. The conductivity of sodium dodecyl sulphate decreases with increase in amount of methanol. The conductance of sodium dodecyl sulphate is found more in presence of KBr than NaCl in methanol-water mixed solvent media containing 0.1, 0.2 and 0.4 volume fractions of methanol. DOI: http://dx.doi.org/10.3126/bibechana.v9i0.7191 BIBECHANA 9 (2013) 159-164


BIBECHANA ◽  
2014 ◽  
Vol 11 ◽  
pp. 103-112 ◽  
Author(s):  
Tulasi Prasad Niraula ◽  
Ajaya Bhattarai ◽  
Sujeet Kumar Chatterjee

Careful measurements of surface tension and viscosity of sodium dodecyl sulphate (SDS) in presence and absence of KCl in pure water and methanol-water mixed solvent media containing 0.1, 0.2, 0.3 and 0.4 volume fractions of methanol at 308.15 K are reported. The concentration of KCl is 0.01M. The concentration of SDS varies from 4.86×10-3 to 29.56×10-3 mol.l-1. The critical micelle concentration (cmc) increases with increase in percentage of methanol and decreases with addition of salt. DOI: http://dx.doi.org/10.3126/bibechana.v11i0.10388 BIBECHANA 11(1) (2014) 103-112


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Bijaya B. Karki ◽  
Dipta B. Ghosh ◽  
Shun-ichiro Karato

AbstractWater (H2O) as one of the most abundant fluids present in Earth plays crucial role in the generation and transport of magmas in the interior. Though hydrous silicate melts have been studied extensively, the experimental data are confined to relatively low pressures and the computational results are still rare. Moreover, these studies imply large differences in the way water influences the physical properties of silicate magmas, such as density and electrical conductivity. Here, we investigate the equation of state, speciation, and transport properties of water dissolved in Mg1−xFexSiO3 and Mg2(1−x)Fe2xSiO4 melts (for x = 0 and 0.25) as well as in its bulk (pure) fluid state over the entire mantle pressure regime at 2000–4000 K using first-principles molecular dynamics. The simulation results allow us to constrain the partial molar volume of the water component in melts along with the molar volume of pure water. The predicted volume of silicate melt + water solution is negative at low pressures and becomes almost zero above 15 GPa. Consequently, the hydrous component tends to lower the melt density to similar extent over much of the mantle pressure regime irrespective of composition. Our results also show that hydrogen diffuses fast in silicate melts and enhances the melt electrical conductivity in a way that differs from electrical conduction in the bulk water. The speciation of the water component varies considerably from the bulk water structure as well. Water is dissolved in melts mostly as hydroxyls at low pressure and as –O–H–O–, –O–H–O–H– and other extended species with increasing pressure. On the other hand, the pure water behaves as a molecular fluid below 15 GPa, gradually becoming a dissociated fluid with further compression. On the basis of modeled density and conductivity results, we suggest that partial melts containing a few percent of water may be gravitationally trapped both above and below the upper mantle-transition region. Moreover, such hydrous melts can give rise to detectable electrical conductance by means of electromagnetic sounding observations.


1994 ◽  
Vol 359 ◽  
Author(s):  
Jun Chen ◽  
Haiyan Zhang ◽  
Baoqiong Chen ◽  
Shaoqi Peng ◽  
Ning Ke ◽  
...  

ABSTRACTWe report here the results of our study on the properties of iodine-doped C60 thin films by IR and optical absorption, X-ray diffraction, and electrical conductivity measurements. The results show that there is no apparent structural change in the iodine-doped samples at room temperature in comparison with that of the undoped films. However, in the electrical conductivity measurements, an increase of more that one order of magnitude in the room temperature conductivity has been observed in the iodine-doped samples. In addition, while the conductivity of the undoped films shows thermally activated temperature dependence, the conductivity of the iodine-doped films was found to be constant over a fairly wide temperature range (from 20°C to 70°C) exhibiting a metallic feature.


Sign in / Sign up

Export Citation Format

Share Document