scholarly journals Parameter Optimization of Segmental Multicluster Fractured Horizontal Wells in Extremely Rich Gas Condensate Shale Reservoirs

2021 ◽  
Vol 9 ◽  
Author(s):  
Wei Zhipeng ◽  
Wang Jinwei ◽  
Liu Rumin ◽  
Wang Tao ◽  
Han Guannan
Keyword(s):  
Shale Gas ◽  
Horizontal Well ◽  
Production Capacity ◽  
Horizontal Wells ◽  
Distribution Patterns ◽  
Gas Condensate ◽  
Fracture Permeability ◽  
Mesh Density ◽  
Fractured Horizontal Wells ◽  
Half Length

For economic and efficient development of extremely high-condensate shale gas reservoirs, a numerical model of segmental multicluster fractured horizontal well was established considering the effect of condensate and desorption, and the optimization of fracturing segments, fracturing clusters, half-length of main fracture, fracture permeability, fracture mesh density, and fracture distribution patterns were studied. It is indicated that the horizontal well whose design length is 2,700 m performs best when it has 43 fracturing segments with three clusters in each segment and the fracture permeability is 300 mD. The production capacity of horizontal wells is positively linearly correlated with the half-length of fractures. Increasing fracture half-length would be an effective way to produce condensate oil near wellbore. An effective fractured area can be constructed to remarkably improve productivity when the half-length of the fracture is 50 m and the number of secondary fractures is four in each segment. On the basis of reasonable fracture parameters, the staggered type distribution pattern is beneficial to the efficient development of shale gas-condensate reservoirs because of its large reconstruction volume, far pressure wave, small fracture interference, and small precipitation range of condensate.

scholarly journals A Mathematical Pressure Transient Analysis Model for Multiple Fractured Horizontal Wells in Shale Gas Reservoirs

Geofluids ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-16 ◽  
Author(s):  
Yan Zeng ◽  
Qing Wang ◽  
Zhengfu Ning ◽  
Hongliang Sun
Keyword(s):  
Shale Gas ◽  
Gas Flow ◽  
Horizontal Wells ◽  
Analysis Model ◽  
Fracture Permeability ◽  
Gas Reservoirs ◽  
Apparent Permeability ◽  
Matrix Permeability ◽  
Fractured Horizontal Wells ◽  
Half Length

Multistage fractured horizontal wells (MFHWs) have become the main technology for shale gas exploration. However, the existing models have neglected the percolation mechanism in nanopores of organic matter and failed to consider the differences among the reservoir properties in different areas. On that account, in this study, a modified apparent permeability model was proposed describing gas flow in shale gas reservoirs by integrating bulk gas flow in nanopores and gas desorption from nanopores. The apparent permeability was introduced into the macroseepage model to establish a dynamic pressure analysis model for MFHWs dual-porosity formations. The Laplace transformation and the regular perturbation method were used to obtain an analytical solution. The influences of fracture half-length, fracture permeability, Langmuir volume, matrix radius, matrix permeability, and induced fracture permeability on pressure and production were discussed. Results show that fracture half-length, fracture permeability, and induced fracture permeability exert a significant influence on production. A larger Langmuir volume results in a smaller pressure and pressure derivative. An increase in matrix permeability increases the production rate. Besides, this model fits the actual field data relatively well. It has a reliable theoretical foundation and can preferably describe the dynamic changes of pressure in the exploration process.

Evaluating the Performance of Horizontal Multi-Frac Wells in a Depleted Gas Condensate Reservoir in Sultanate of Oman

2022 ◽  
Author(s):  
Josef R. Shaoul ◽  
Jason Park ◽  
Andrew Boucher ◽  
Inna Tkachuk ◽  
Cornelis Veeken ◽  
...  
Keyword(s):  
Horizontal Well ◽  
Horizontal Wells ◽  
Gas Condensate ◽  
Integrated Analysis ◽  
Single Fracture ◽  
Reservoir Pressure ◽  
Well Test ◽  
Vertical Wells ◽  
Fracture Conductivity ◽  
Half Length

Abstract The Saih Rawl gas condensate field has been producing for 20 years from multiple fractured vertical wells covering a very thick gross interval with varying reservoir permeability. After many years of production, the remaining reserves are mainly in the lowest permeability upper units. A pilot program using horizontal multi-frac wells was started in 2015, and five wells were drilled, stimulated and tested over a four-year period. The number of stages per horizontal well ranged from 6 to 14, but in all cases production was much less than expected based on the number of stages and the production from offset vertical wells producing from the same reservoir units with a single fracture. The scope of this paper is to describe the work that was performed to understand the reason for the lower than expected performance of the horizontal wells, how to improve the performance, and the implementation of those ideas in two additional horizontal wells completed in 2020. The study workflow was to perform an integrated analysis of fracturing, production and well test data, in order to history match all available data with a consistent reservoir description (permeability and fracture properties). Fracturing data included diagnostic injections (breakdown, step-rate test and minifrac) and main fracture treatments, where net pressure matching was performed. After closure analysis (ACA) was not possible in most cases due to low reservoir pressure and absence of downhole gauges. Post-fracture well test and production matching was performed using 3D reservoir simulation models including local grid refinement to capture fracture dimensions and conductivity. Based on simulation results, the effective propped fracture half-length seen in the post-frac production was extremely small, on the order of tens of meters, in some of the wells. In other wells, the effective fracture half-length was consistent with the created propped half-length, but the fracture conductivity was extremely small (finite conductivity fracture). The problems with the propped fractures appear to be related to a combination of poor proppant pack cleanup, low proppant concentration and small proppant diameter, compounded by low reservoir pressure which has a negative impact on proppant regained permeability after fracturing with crosslinked gel. Key conclusions from this study are that 1) using the same fracture design in a horizontal well with transverse fractures will not give the same result as in a vertical well in the same reservoir, 2) the effect of depletion on proppant pack cleanup in high temperature tight gas reservoirs appears to be very strong, requiring an adjustment in fracture design and proppant selection to achieve reasonable fracture conductivity, and 3) achieving sufficient effective propped length and height is key to economic production.

Pressure and rate transient modeling of multi fractured horizontal wells in shale gas condensate reservoirs

2020 ◽  
Vol 185 ◽  
pp. 106566
Author(s):  
Sadegh Dahim ◽  
Amin Taghavinejad ◽  
Milad Razghandi ◽  
Hamed Rahimi Rigi ◽  
Kianoosh Moeini ◽  
...  
Keyword(s):  
Shale Gas ◽  
Horizontal Wells ◽  
Gas Condensate ◽  
Gas Condensate Reservoirs ◽  
Transient Modeling ◽  
Fractured Horizontal Wells

The Interpretation Technique of Rate Transient Analysis Data in Fractured Horizontal Wells

2021 ◽  
Author(s):  
Ruslan Rubikovich Urazov ◽  
Alfred Yadgarovich Davletbaev ◽  
Alexey Igorevich Sinitskiy ◽  
Ilnur Anifovich Zarafutdinov ◽  
Artur Khamitovich Nuriev ◽  
...  
Keyword(s):  
Hydraulic Fracturing ◽  
Transient Analysis ◽  
Horizontal Well ◽  
Horizontal Wells ◽  
Data Interpretation ◽  
Analysis Data ◽  
Well Logging ◽  
Rate Transient Analysis ◽  
Fractured Horizontal Well ◽  
Fractured Horizontal Wells

Abstract This research presents a modified approach to the data interpretation of Rate Transient Analysis (RTA) in hydraulically fractured horizontal well. The results of testing of data interpretation technique taking account of the flow allocation in the borehole according to the well logging and to the injection tests outcomes while carrying out hydraulic fracturing are given. In the course of the interpretation of the field data the parameters of each fracture of hydraulic fracturing were selected with control for results of well logging (WL) by defining the fluid influx in the borehole.

Sign in / Sign up

Export Citation Format

Share Document