scholarly journals The Effect of Hydrogen Production Rate of the via Different Preparation of Co-Based Catalyst with Sodium Borohydride

Catalysts ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 528
Author(s):  
Jyun-Lin Lai ◽  
Win-Jet Luo ◽  
Yean-Der Kuan ◽  
Pai-Jun Zhang

This study processed the water vapor entrained in the NaBH4 hydrogen production reaction inside the primary hydrogen production tank through the secondary hydrogen production tank, in order to increase total hydrogen production. γ-Al2O3 was used as the carrier for the hydrolytic hydrogen production reaction in the primary hydrogen production tank. The reaction was chelated with metal catalyst Co2+ at different concentrations to produce the catalyst. Next, the adopted catalyst concentration and different catalyst bed temperatures were tested. The secondary hydrogen production tank was tested using NaBH4 powder and multiple NaBH4+ Co2+ mixed powders at different ratios. The powder was refined by ball milling with different steel ball ratios to enlarge the contact area between the water vapor and powder. The ball milling results from carriers at different concentrations, different catalyst bed temperatures, NaBH4+ Co2+ mixed powders in different ratios and different steel ball ratios were discussed as the hydrogen production rate and hydrogen production in relation to the hydrolytic hydrogen production reaction. The experimental results show that the hydrolytic hydrogen production reaction is good when 45 wt% Co2+/γ-Al2O3 catalyst is placed in the primary hydrogen production tank at a catalyst bed temperature of 55 °C. When the NaBH4+ Co2+ mixed powder in a ratio of 7:3 and steel balls in a ratio of 1:4 were placed in the secondary hydrogen production tank for 2 h of ball milling, the hydrogen production increased favorably. The hydrogen storage can be increased effectively without wasting the water vapor entrained in the hydrolytic hydrogen production reaction, and the water vapor effect on back-end storage can be reduced.

2021 ◽  
Vol 71 (1) ◽  
Author(s):  
Jiang-Yu Ye ◽  
Yue Pan ◽  
Yong Wang ◽  
Yi-Chao Wang

Abstract Purpose This study utilized the principle that the bacteriorhodopsin (BR) produced by Halobacterium salinarum could increase the hydrogen production of Rhodobacter sphaeroides. H. salinarum are co-cultured with R. sphaeroides to determine the impact of purple membrane fragments (PM) on R. sphaeroides and improve its hydrogen production capacity. Methods In this study, low-salinity in 14 % NaCl domesticates H salinarum. Then, 0–160 nmol of different concentration gradient groups of bacteriorhodopsin (BR) and R. sphaeroides was co-cultivated, and the hydrogen production and pH are measured; then, R. sphaeroides and immobilized BR of different concentrations are used to produce hydrogen to detect the amount of hydrogen. Two-chamber microbial hydrogen production system with proton exchange membrane-assisted proton flow was established, and the system was operated. As additional electricity added under 0.3 V, the hydrogen production rate increased with voltages in the coupled system. Results H salinarum can still grow well after low salt in 14% NaCl domestication. When the BR concentration is 80 nmol, the highest hydrogen production reached 217 mL per hour. Both immobilized PC (packed cells) and immobilized PM (purple membrane) of H. salinarum could promote hydrogen production of R. sphaeroides to some extent. The highest production of hydrogen was obtained by the coupled system with 40 nmol BR of immobilized PC, which increased from 127 to 232 mL, and the maximum H2 production rate was 18.2 mL−1 h−1 L culture. In the 192 h experiment time, when the potential is 0.3 V, the hydrogen production amount can reach 920 mL, which is 50.3% higher than the control group. Conclusions The stability of the system greatly improved after PC was immobilized, and the time for hydrogen production of R. sphaeroides significantly extended on same condition. As additional electricity added under 0.3 V, the hydrogen production rate increased with voltages in the coupled system. These results are helpful to build a hydrogen production-coupled system by nitrogenase of R. sphaeroides and proton pump of H. salinarum. Graphical abstract


2015 ◽  
Vol 98 ◽  
pp. 383-389 ◽  
Author(s):  
Chiung-Yi Cheng ◽  
Kuang-Li Cheng ◽  
Terng-Jou Wan ◽  
Wei-Nung Kuo ◽  
Feng-Jen Chu ◽  
...  

2007 ◽  
Vol 121-123 ◽  
pp. 191-194
Author(s):  
Wan Li Gu ◽  
Liu Feng

An Al-5vol%Ti3SiC2 nanocomposite has been prepared by ball milling technique. Steel ball, agate ball and zirconia ball were selected during the ball milling process and then the microstructure evolution of the powder mixture was investigated. The homogenous fine mixed powder can be obtained with zirconia ball, whereas the conglomeration will be formed in the case of steel ball and agate ball. The bulk Al/Ti3SiC2 nanocomposite was fabricated by hot pressing technique. The effects of the particle size and agglomerate state of Ti3SiC2, as well as the microstructure of Al/Ti3SiC2 nanocomposite were studied by SEM and TEM. It was found that the nanosized Ti3SiC2 particle could be obtained during the ball milling process and distributed in aluminium homogenously.


Nanoscale ◽  
2017 ◽  
Vol 9 (43) ◽  
pp. 17029-17036 ◽  
Author(s):  
Arka Saha ◽  
Apurba Sinhamahapatra ◽  
Tong-Hyun Kang ◽  
Subhash C. Ghosh ◽  
Jong-Sung Yu ◽  
...  

An efficient ‘noble metal free’ hydrogenated MoS2 QD-TiO2 heterojunction photocatalyst with a superior hydrogen production rate of 3.1 mmol g−1 h−1 is reported.


2014 ◽  
Vol 50 (14) ◽  
pp. 1731-1734 ◽  
Author(s):  
Zheng Wang ◽  
Jungang Hou ◽  
Chao Yang ◽  
Shuqiang Jiao ◽  
Hongmin Zhu

Three-dimensional MoS2–CdS–γ-TaON hollow nanostructures as novel photocatalysts were firstly synthesized via a facile hydrothermal method and they exhibit a high photocatalytic hydrogen production rate without a noble metal.


Author(s):  
Alicia Keow ◽  
Zheng Chen

Abstract Proton exchange membrane (PEM) electrolyzers with the ability to produce gases at a pressure suitable for direct metal hydride storage are desirable because they do not require the use of compressors and other auxiliary components. Direct storage into metal hydride cylinders is made feasible when the pressure and flow rate of hydrogen is controlled. The nonlinear dynamics of the PEM electrolyzer change with temperature and pressure, both of which change with the hydrogen production rate, and are thus difficult to estimate. Therefore, a model-free, relay-feedback, auto-tuning approach is used to tune a proportional integral (PI) controller. This allows for the determination of the voltage supply to the electrolyzer by tracking the current set-point and correlating it to the hydrogen production rate. A gain scheduling approach is used to record the tuned controller’s parameters at different set-points, minimizing the frequency of tuning the device. A self-assessment test is used to determine situations where the auto-tuner should activate to update the PI parameters, thus, allowing for the system to operate without supervision. The auto-tuning PI control is successfully tested with a PEM electrolyzer setup. Experimental results showed that an auto-tuner can tune the controller parameters and produce favorable transient behaviors, allowing for a degree of adaptability for variations in system set-points.


Catalysts ◽  
2020 ◽  
Vol 10 (4) ◽  
pp. 451 ◽  
Author(s):  
Jai-Houng Leu ◽  
Ay Su ◽  
Jung-Kang Sun ◽  
Zhen-Ming Huang

The research in this study focused on the operating parameters for a high efficiency hydrogen production rate system, with the aim to design a hydrolysis of the NaBH4 hydrogen production module for lightweight and efficient hydrogen production and conversion. The experiment used a reactor, where the reaction volume was about 12 mL. The parameters on the feed rate of the NaBH4 solution and the catalyst loading for the hydrogen production rate and conversion efficiency were investigated. The catalyst is sufficient to allow the release of hydrogen in the 1 g/min solution, but the efficiency of hydrogen production at high flow rates has been shown to be low in previous studies. Therefore, the aim is to increase the catalyst to improve the reaction efficiency in this study. The results show that at the high temperature reaction condition, solid NaBO2 will not generate on the catalyst surface to influence the hydrogen production rate when using the five pcs catalyst. When the reaction temperature was 108 °C, the average hydrogen production rate was 1.72 L/min, and the conversion efficiency was 91.2%.


Sign in / Sign up

Export Citation Format

Share Document