scholarly journals Synthesis of Semicrystalline Long Chain Aliphatic Polyesters by ADMET Copolymerization of Dianhydro-D-glucityl bis(undec-10-enoate) with 1,9-Decadiene and Tandem Hydrogenation

Catalysts ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 1098
Author(s):  
Mika Kojima ◽  
Mohamed Mehawed Abdellatif ◽  
Kotohiro Nomura
Keyword(s):  
Melting Temperature ◽  
Molar Ratio ◽  
Acyclic Diene Metathesis ◽  
Aliphatic Polyesters ◽  
Unsaturated Polyesters ◽  
Diene Metathesis ◽  
Optimized Conditions ◽  
Long Chain

Acyclic diene metathesis (ADMET) copolymerization of dianhydro-D-glucityl bis(undec-10-enoate) (M1) with 1,9-decadiene (DCD) using ruthenium-carbene catalyst, RuCl2(IMesH2)(CH-2-OiPr-C6H4) [IMesH2 = 1,3-bis(2,4,6-trimethylphenyl)imidazolin-2-ylidene, HG2], afforded unsaturated polyesters (Mn = 9300–23,400) under the optimized conditions. Subsequent tandem hydrogenation (H2 1.0 MPa, 50 °C) with the addition of a small amount of Al2O3 resulted in the saturated polymers having a melting temperature of 71.7–107.6 °C, depending on the molar ratio of M1 and DCD.

Acyclic diene metathesis (ADMET) polymerization: the synthesis of unsaturated polyesters

1992 ◽  
Vol 25 (15) ◽  
pp. 3862-3867 ◽  
Author(s):  
J. T. Patton ◽  
J. M. Boncella ◽  
K. B. Wagener
Keyword(s):  
Acyclic Diene Metathesis ◽  
Unsaturated Polyesters ◽  
Admet Polymerization ◽  
Diene Metathesis

scholarly journals Renewable Aliphatic Polyesters from Fatty Dienes by Acyclic Diene Metathesis Polycondensation

2020 ◽  
Vol 97 (5) ◽  
pp. 517-530 ◽  
Author(s):  
Bryan R. Moser ◽  
Karl E. Vermillion ◽  
Benetria N. Banks ◽  
Kenneth M. Doll
Keyword(s):  
Acyclic Diene Metathesis ◽  
Aliphatic Polyesters ◽  
Diene Metathesis

scholarly journals Optimizing Chitin Depolymerization by Lysozyme to Long-Chain Oligosaccharides

Marine Drugs ◽  
2021 ◽  
Vol 19 (6) ◽  
pp. 320
Author(s):  
Arnaud Masselin ◽  
Antoine Rousseau ◽  
Stéphanie Pradeau ◽  
Laure Fort ◽  
Rodolphe Gueret ◽  
...  
Keyword(s):  
Time Course ◽  
Water Soluble ◽  
Organic Fertilizers ◽  
Symbiotic Associations ◽  
Egg White Lysozyme ◽  
Hen Egg White ◽  
Ecological Transition ◽  
Optimized Conditions ◽  
Hydrolysis Of ◽  
Long Chain

Chitin oligosaccharides (COs) hold high promise as organic fertilizers in the ongoing agro-ecological transition. Short- and long-chain COs can contribute to the establishment of symbiotic associations between plants and microorganisms, facilitating the uptake of soil nutrients by host plants. Long-chain COs trigger plant innate immunity. A fine investigation of these different signaling pathways requires improving the access to high-purity COs. Here, we used the response surface methodology to optimize the production of COs by enzymatic hydrolysis of water-soluble chitin (WSC) with hen egg-white lysozyme. The influence of WSC concentration, its acetylation degree, and the reaction time course were modelled using a Box–Behnken design. Under optimized conditions, water-soluble COs up to the nonasaccharide were formed in 51% yield and purified to homogeneity. This straightforward approach opens new avenues to determine the complex roles of COs in plants.

A novel separation method of the valuable components for activated clay production wastewater

2021 ◽  
Vol 19 (1) ◽  
pp. 530-540
Author(s):  
Lvshan Zhou ◽  
Tongjiang Peng ◽  
Hongjuan Sun ◽  
Dong Fu ◽  
Chuan Lai
Keyword(s):  
Aluminum Phosphate ◽  
Iron Phosphate ◽  
Acid Sites ◽  
Precipitation Method ◽  
Molar Ratio ◽  
Precipitation Process ◽  
Iron Aluminum ◽  
Phosphorus Iron ◽  
Optimized Conditions ◽  
Acidic Wastewater

Abstract The acidic wastewater produced by the wet production of activated clay contains valuable components such as iron and aluminum. The precipitation method was successfully introduced to separate iron and aluminum from the activated clay production wastewater step by step, which can not only recover the valuable components, but also avoid environmental pollution. In the separation process, gypsum, iron aluminum phosphate, alumina, and sodium sulfate were prepared, and the phase compositions of separation products were analyzed by XRD and IR. The main influencing factors in the separation of iron and aluminum components were studied by single factor experiment. The results show that at the optimized conditions, phosphorus/iron molar ratio 6.0, the system pH 3.0, the reaction temperature 343 K, and the reaction time 90 min, the iron(iii) ion in the system can form a sodium-containing aluminum iron phosphate double salt, and the filtrate after separating Fe3+ and part of Al3+ can meet the requirements for forming high-purity Al2O3. During the phosphate precipitation process, the hypothesis should be correct that Al3+ reacts with PO 4 3 − {\text{PO}}_{4}^{3-} to form an AlPO4 skeleton, Fe3+ isomorphically replaces Al3+ in the [AlO4] tetrahedron, and adsorption occurs simultaneously, with Na+ occupying the terminal acid sites, P(Al)–OH.

scholarly journals Synthesis and Characterization of Partially Renewable Oleic Acid-Based Ionomers for Proton Exchange Membranes

Polymers ◽  
2020 ◽  
Vol 13 (1) ◽  
pp. 130
Author(s):  
Carlos Corona-García ◽  
Alejandro Onchi ◽  
Arlette A. Santiago ◽  
Araceli Martínez ◽  
Daniella Esperanza Pacheco-Catalán ◽  
...  
Keyword(s):  
Oleic Acid ◽  
Proton Conductivity ◽  
Electrochemical Impedance ◽  
Proton Exchange Membranes ◽  
Proton Exchange ◽  
Molar Ratio ◽  
Aromatic Diamines ◽  
Chemical Structures ◽  
Long Chain

The future availability of synthetic polymers is compromised due to the continuous depletion of fossil reserves; thus, the quest for sustainable and eco-friendly specialty polymers is of the utmost importance to ensure our lifestyle. In this regard, this study reports on the use of oleic acid as a renewable source to develop new ionomers intended for proton exchange membranes. Firstly, the cross-metathesis of oleic acid was conducted to yield a renewable and unsaturated long-chain aliphatic dicarboxylic acid, which was further subjected to polycondensation reactions with two aromatic diamines, 4,4′-(hexafluoroisopropylidene)bis(p-phenyleneoxy)dianiline and 4,4′-diamino-2,2′-stilbenedisulfonic acid, as comonomers for the synthesis of a series of partially renewable aromatic-aliphatic polyamides with an increasing degree of sulfonation (DS). The polymer chemical structures were confirmed by Fourier transform infrared (FTIR) and nuclear magnetic resonance (1H, 13C, and 19F NMR) spectroscopy, which revealed that the DS was effectively tailored by adjusting the feed molar ratio of the diamines. Next, we performed a study involving the ion exchange capacity, the water uptake, and the proton conductivity in membranes prepared from these partially renewable long-chain polyamides, along with a thorough characterization of the thermomechanical and physical properties. The highest value of the proton conductivity determined by electrochemical impedance spectroscopy (EIS) was found to be 1.55 mS cm−1 at 30 °C after activation of the polymer membrane.

Sign in / Sign up

Export Citation Format

Share Document