scholarly journals Parametric Study of a Lunar Base Power Systems

Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1141
Author(s):  
Marcin Kaczmarzyk ◽  
Michał Musiał

Due to the extreme cost of cargo transportation from Earth to the lunar surface, future lunar base subsystems are required to be rigorously optimized in terms of mass reduction. The purpose of this paper was to identify and evaluate the influence of key parameters of proposed lunar base power systems, as well as of the lunar environment on the total power system mass. Nine different power systems were studied as combinations of two power sources and three energy storage technologies. Power system architecture, total power demand of the base, its power management strategy, solar array structure type, Selenographic latitude and solar illumination conditions were nominated as the primary parameters for this study. Total power system mass calculations were performed for more than 200 combinations of these parameters, including three separate case studies. The total mass calculated for each combination included a power source, an energy storage unit, temperature control and the balance of system. For the wide range of studied parameters, hybrid power systems that combine solar and nuclear power were found to be the most advantageous solutions in terms of mass reduction.

2021 ◽  
Vol 12 (1) ◽  
pp. 34-49
Author(s):  
Xiong Pu ◽  
Zhong Lin Wang

Recent progresses and future prospects on nanogenerator-based self-charging power systems (SCPSs) are discussed with this perspective.


Energies ◽  
2021 ◽  
Vol 14 (3) ◽  
pp. 737
Author(s):  
Michał Kosmecki ◽  
Robert Rink ◽  
Anna Wakszyńska ◽  
Roberto Ciavarella ◽  
Marialaura Di Somma ◽  
...  

Along with the increasing share of non-synchronous power sources, the inertia of power systems is being reduced, which can give rise to frequency containment problems should an outage of a generator or a power infeed happen. Low system inertia is eventually unavoidable, thus power system operators need to be prepared for this condition. This paper addresses the problem of low inertia in the power system from two different perspectives. At a system level, it proposes an operation planning methodology, which utilises a combination of power flow and dynamic simulation for calculation of existing inertia and, if need be, synthetic inertia (SI) to fulfil the security criterion of adequate rate of change of frequency (RoCoF). On a device level, it introduces a new concept for active power controller, which can be applied virtually to any power source with sufficient response time to create synthetic inertia. The methodology is demonstrated for a 24 h planning period, for which it proves to be effective. The performance of SI controller activated in a battery energy storage system (BESS) is positively validated using a real-time digital simulator (RTDS). Both proposals can effectively contribute to facilitating the operation of low inertia power systems.


2018 ◽  
Vol 8 (9) ◽  
pp. 1453 ◽  
Author(s):  
Huanan Liu ◽  
Dezhi Li ◽  
Yuting Liu ◽  
Mingyu Dong ◽  
Xiangnan Liu ◽  
...  

With the rapid development of industry, more fossil energy is consumed to generate electricity, which increases carbon emissions and aggravates the burden of environmental protection. To reduce carbon emissions, traditional centralized power generation networks are transforming into distributed renewable generation systems. However, the deployment of distributed generation systems can affect power system economy and stability. In this paper, under different time scales, system economy, stability, carbon emissions, and renewable energy fluctuation are comprehensively considered to optimize battery and super-capacitor installation capacity for an off-grid power system. After that, based on the genetic algorithm, this paper shows the optimal system operation strategy under the condition of the theoretical best energy storage capacity. Finally, the theoretical best capacity is tested under different renewable energy volatility rates. The simulation results show that by properly sizing the storage system’s capacity, although the average daily costs of the system can increase by 10%, the system’s carbon emissions also reduce by 42%. Additionally, the system peak valley gap reduces by 23.3%, and the renewable energy output’s fluctuation range and system loss of load probability are successfully limited in an allowable range. Lastly, it has less influence on the theoretical best energy storage capacity if the renewable energy volatility rate can be limited to within 10%.


2021 ◽  
Vol 11 (18) ◽  
pp. 8484
Author(s):  
Seok-Ho Song ◽  
Jin-Young Heo ◽  
Jeong-Ik Lee

A nuclear power plant is one of the power sources that shares a large portion of base-load. However, as the proportion of renewable energy increases, nuclear power plants will be required to generate power more flexibly due to the intermittency of the renewable energy sources. This paper reviews a layout thermally integrating the liquid air energy storage system with a nuclear power plant. To evaluate the performance realistically while optimizing the layout, operating nuclear power plant conditions are used. After revisiting the analysis, the optimized performance of the proposed system is predicted to achieve 59.96% of the round-trip efficiency. However, it is further shown that external environmental conditions could deteriorate the performance. For the design of liquid air energy storage-nuclear power plant integrated systems, both the steam properties of the linked plants and external factors should be considered.


Author(s):  
Claudia Lucia De Pascalis ◽  
Stephanie Stockar

Abstract Cogeneration is a well-known and cost effective solution for generating power and heat within the same plant, leading to improved overall efficiency and reduced generation cost. Combined heating and power systems can facilitate the penetration of renewable energy sources in medium size applications through the integration of electric and thermal energy storage units. Due to the complexity of the plant as well as significantly variability in power demand and generation, the design and operation of such systems requires a systematic co-optimization of plant and controller for guaranteeing near optimal performance. In this scenario, this paper presents a physics-based parametric modeling approach for the characterization of the main components of a 1MW combined heating and power system that includes renewable sources, electric and thermal storage devices. To demonstrate the model flexibility and potential benefits achieved by an optimal sizing, the system energy management is optimized using Dynamic Programming. The operational costs for different configurations are compared showing that an optimization of the energy management strategy in conjunction with an improved system sizing lead to more than 6% of reduction in the operational cost.


Inventions ◽  
2019 ◽  
Vol 4 (3) ◽  
pp. 38 ◽  
Author(s):  
Bouzounierakis ◽  
Katsigiannis ◽  
Fiorentzis ◽  
Karapidakis

Greece has a large number of islands that are isolated from the main interconnected Greek power system; however, a majority of them are to be interconnected in the mainland grid over the next decade. A large number of these islands present a significant amount of wind and solar potential. The nature of load demand and renewable production is stochastic; thus, the operation of such isolated power systems can be improved significantly by the installation of a large-scale energy storage system. The role of storage is to compensate for the long and short-term imbalances between power generation and load demand. Pumped hydro storage (PHS) systems represent one of the most mature technologies for large-scale energy storage. However, their advantages have not been proven in practice for cases of medium and small-sized isolated insular systems. Regarding Greece, which contains a large number of isolated insular systems, a PHS system in the island of Ikaria started its test operation in 2019, whereas in Europe only one PHS system operates in El Hierro (Canary Islands). This paper studies the effect of installing a wind-PHS hybrid power station in the operation of the insular power system of Samos, Greece, according to the latest regulatory framework. The implemented analysis uses real hourly data for a whole year, and examines the effects of such an installation considering investors’ and power system operators’ viewpoints. More specifically, the economic viability of this project under different billing scenarios is compared, and its impact on the insular power system operation for various PHS sizes is examined.


Energies ◽  
2019 ◽  
Vol 13 (1) ◽  
pp. 92 ◽  
Author(s):  
Antonio T. Alexandridis

In stability studies, the response of a system enforced by external, known or unknown, inputs is of great importance. Although such an analysis is quite easy for linear systems, it becomes a cumbersome task when nonlinearities exist in the system model. Nevertheless, most of the real-world systems are externally enforced nonlinear systems with nonzero equilibriums. Representative examples in this category include power systems, where studies on stability and convergence to equilibrium constitute crucial objectives. Driven by this need, the aim of the present work is twofold: First, to substantially complete the theoretical infrastructure by establishing globally valid sufficient conditions for externally enforced nonlinear systems that converge to nonzero equilibriums and, second, to deploy an efficient method easily applicable on practical problems as it is analyzed in detail on a typical power system example. To that end, in the theoretical first part of the paper, a rigorous nonlinear analysis is developed. Particularly, starting from the well-established nonlinear systems theory based on Lyapunov techniques and on the input-to-state stability (ISS) notion, it is proven after a systematic and lengthy analysis that ISS can also guarantee convergence to nonzero equilibrium. Two theorems and two corollaries are established to provide the sufficient conditions. As shown in the paper, the main stability and convergence objectives for externally enforced systems are fulfilled if simple exponential or asymptotic converging conditions can be proven for the unforced system. Then, global or local convergence is established, respectively, while for the latter case, a novel method based on a distance-like measure for determining the region of attraction (RoA) is proposed. The theoretical results are examined on classic power system generation nonlinear models. The power system examples are suitably selected in order to effectively demonstrate the proposed method as a stability analysis tool and to validate all the particular steps, especially that of evaluating the RoA. The examined system results clearly verify the theoretical part, indicating a rather wide range of applications in power systems.


Energies ◽  
2019 ◽  
Vol 12 (7) ◽  
pp. 1195 ◽  
Author(s):  
Mei Wu ◽  
Yu-Qing Bao ◽  
Gang Chen ◽  
Jinlong Zhang ◽  
Beibei Wang ◽  
...  

The stability problem of the power system becomes increasingly important for the penetration of renewable energy resources (RESs). The inclusion of electric vehicles (EVs) in a power system can not only promote the consumption of RESs, but also provide energy for the power grid if necessary. As a mobile energy storage unit (MESU), EVs should pay more attention to the service life of their batteries during operation. A hierarchical distributed control strategy was proposed in this paper for mobile energy storage clusters (MESCs) considering the life loss of each EV’s battery. This strategy was divided into a two-layer control structure. Firstly, numerous EVs were divided into different clusters according to their regional relationships. The lower layer adopted a distributed collaborative control approach for allocating energy among EVs in the cluster. Under this condition, an aggregate EVs response model was established and the characteristic of the MESC was analyzed. Secondly, the upper layer applied the multi-agent consensus algorithm to achieve the optimal allocation among different clusters. Therefore, the control strategy realized the two-way communication of energy between EVs and the power grid, and ensured the optimal economical dispatch for the mobile energy storage system (MESS). Finally, the simulation of testing examples verified the effectiveness of the proposed strategy.


Sign in / Sign up

Export Citation Format

Share Document