scholarly journals Dynamics of Biochar-Silty Clay Interaction Using In-House Fabricated Cyclic Loading Apparatus: A Case Study of Coastal Clay and Novel Peach Biochar from the Qingdao Region of China

2020 ◽  
Vol 12 (7) ◽  
pp. 2599 ◽  
Author(s):  
Junwei Liu ◽  
Suriya Prakash Ganesan ◽  
Xin Li ◽  
Ankit Garg ◽  
Aman Singhal ◽  
...  
Keyword(s):  
Cyclic Loading ◽  
Shear Modulus ◽  
Dynamic Behavior ◽  
Void Ratio ◽  
Water Pressure ◽  
Damping Ratio ◽  
Cyclic Strength ◽  
Silty Clay ◽  
Amended Soils ◽  
Amended Soil

Biochar has been recently investigated as an eco-friendly material in bio-engineered slopes/landfill covers. A majority of recent studies have focused on analyzing water retention behavior while very few have examined dynamic behavior (i.e., cyclic loading due to earthquake, wind, or wave) of biochar amended soil. As far as the authors are aware, there is no study on the dynamic behavior of biochar amended soils. Considering the above mentioned study as a major objective, field excavated soil was collected and mixed with in-house produced biochar from peach endocarps, at three amendment rates (5%, 10%, and 15%). The un-amended bare soil and biochar amended soil were imposed to a cyclic load in a self-designed apparatus and the corresponding stress-strain parameters were measured. Dynamic parameters such as shear modulus and damping ratio were computed and the results were compared between bare and biochar amended soil. Furthermore, the residual cyclic strength of each soil types were correlated with an estimated void ratio to understand the interrelation between dynamic loading responses and biochar amended soils. The major outcomes of this study show that the addition of biochar decreases the void ratio, thereby increasing the shear modulus and residual cyclic strength. However, the modulus and strength values attenuates after 15 cycles due to an increase in pore water pressure. In contrary, at higher amendment rates, Biochar Amended Soils (BAS) forms clay-carbon complex and decreases both shear modulus and residual cyclic strength.

Dynamic Shear Modulus and Damping Ratio of Compacted Silty Clay Subjected to Freeze–Thaw Cycles

2019 ◽  
Vol 31 (10) ◽  
pp. 04019244 ◽  
Author(s):  
Ruxin Jing ◽  
Feng Zhang ◽  
Decheng Feng ◽  
Xueyan Liu ◽  
Athanasios Scarpas
Keyword(s):  
Shear Modulus ◽  
Damping Ratio ◽  
Dynamic Shear Modulus ◽  
Silty Clay ◽  
Dynamic Shear ◽  
Freeze Thaw

Dynamic deformation characteristics of sands and rockfill materials

1993 ◽  
Vol 30 (5) ◽  
pp. 747-757 ◽  
Author(s):  
Nario Yasuda ◽  
Norihisa Matsumoto
Keyword(s):  
Shear Modulus ◽  
Shear Strain ◽  
Simple Shear ◽  
Void Ratio ◽  
Dynamic Deformation ◽  
Damping Ratio ◽  
Intermediate Principal Stress ◽  
Deformation Characteristics ◽  
Confining Stress ◽  
Rockfill Materials

Cyclic torsional simple shear (CTSS) tests and cyclic triaxial (CTX) tests were carried out to investigate the dynamic deformation characteristics of sands and rockfill materials. It was found that the shear modulus and damping ratio can be expressed as a function of shear strain, void ratio, and confining stress. Also the shear modulus in CTSS tests is larger than in CTX tests because of the influence of the intermediate principal stress. When the shear strain is increased, the shear modulus (G) and damping ratio (h) of the rockfill materials were altered at smaller strains than in sands. Key words : sands, rockfill materials, torsional simple shear, shear modulus, damping ratio.

DEGRADATION EFFECT OF SEAWATER ON THE LONG-TERM DYNAMIC BEHAVIOR OF ARTIFICIALLY CEMENTED SAND

2013 ◽  
Vol 07 (04) ◽  
pp. 1350031 ◽  
Author(s):  
BO LI ◽  
YUANQIANG CAI ◽  
XIANGWU ZENG ◽  
LINYOU PAN
Keyword(s):  
Shear Modulus ◽  
Dynamic Behavior ◽  
Tap Water ◽  
Damping Ratio ◽  
Confining Pressure ◽  
Triaxial Tests ◽  
Resonant Column ◽  
Cyclic Triaxial Tests ◽  
Cemented Sand

The dynamic behavior of lightly cemented sand under long-term seawater attack was evaluated in this study. Resonant column and cyclic triaxial tests were employed to investigate the evolution of the shear modulus and damping ratio of cemented sand with respect to soaking period (SP), confining pressure, and cement content (CC). The results of this study show that the cementation of the sand is affected by soaking in seawater to a greater extent than by soaking in tap water. The shear modulus of the cemented sand soaked in seawater was smaller than that of the cemented sand soaked in tap water. The damping ratio increased significantly, as the SP increased and was greater for the cemented sand soaked in seawater than for the cemented sand soaked in tap water. The dynamic behavior of nonhomogenous specimens was examined. Crystallization of salts could be clearly observed and probably explains the evolution of the dynamic behavior of the cemented sand. Finally, the shear modulus was fitted using Rollins' Law [Rollins et al., 1998], which demonstrates that the parameters used in the equation can be reasonably fitted linearly over a range of SPs.

Shear modulus and damping ratio of a clay during undrained cyclic loading

Géotechnique ◽  
2001 ◽  
Vol 51 (5) ◽  
pp. 467-470 ◽  
Author(s):  
S. Teachavorasinskun ◽  
P. Thongchim ◽  
P. Lukkunaprasit
Keyword(s):  
Cyclic Loading ◽  
Shear Modulus ◽  
Damping Ratio

scholarly journals Effect of Sand Fouling on the Dynamic Properties and Volume Change of Gravel During Cyclic Loadings

2020 ◽  
Author(s):  
Meysam Bayat
Keyword(s):  
Shear Modulus ◽  
Shear Strain ◽  
Dynamic Behavior ◽  
Volume Change ◽  
Dynamic Properties ◽  
Damping Ratio ◽  
Confining Pressure ◽  
Triaxial Tests ◽  
Practical Applications ◽  
Large Shear Strain

Understanding the factors that influence the dynamic behavior of granular soils during cyclic loading is critical to infrastructure design. Previous research has lacked quantitative study of the effects of fouling index (FI), mean effective confining pressure, relative density, shear strain level and anisotropic consolidation, especially when the effective vertical stress is lower than the effective horizontal stress on the dynamic behavior of gravelly soils. The objective of the present study was to evaluate the dynamic behavior and volume change of both clean and fouled specimens for practical applications. To this end, cyclic triaxial tests with local strain measurements under both isotropic and anisotropic confining conditions were conducted. It is found that the fouled specimen with 50 % sand (i.e. the specimen which contains 50 % gravel and 50 % sand) has the highest shear modulus at low shear strain levels and the largest volume reduction and damping ratio at large shear strain levels. The results of tests indicate that the effect of fouling index on the shear modulus is reduced at large shear strain levels. Volumetric contraction due to the increase in mean effective confining pressure is more significant at large shear strain levels. The results also indicate that the stiffness of the specimens under anisotropic compression mode are larger than those in extension or isotropic mode.

The Mexico Earthquake of September 19, 1985—General Soil Conditions and Clay Properties in the Valley of Mexico

1988 ◽  
Vol 4 (4) ◽  
pp. 731-752 ◽  
Author(s):  
M. P. Romo ◽  
A. Jaime ◽  
D. Reséndiz
Keyword(s):  
Shear Modulus ◽  
Pore Water Pressure ◽  
Water Pressure ◽  
Damping Ratio ◽  
Free Field ◽  
Elastic Behavior ◽  
Triaxial Tests ◽  
Soil Conditions ◽  
Hyperbolic Model ◽  
Lake Zone

We present and discuss the results of resonant column and cyclic triaxial tests on clay samples obtained from different sites within the Lake zone in the Valley of Mexico. Of particular interest are the nearly elastic behavior and low damping ratio even for shear strain amplitudes as high as 0.3 (%). A hyperbolic model reproduces adequately well the resulting shear modulus vs strain curves. Degradation of shear modulus caused by load repetition is negligible for strains lower than about 1 (%) but increases significantly for higher strains. A power-type expression fits well the modulus degradation vs number of cycles curves. Results from static triaxial tests indicate that for compression stress paths the induced pore water pressure is uniquely related to axial strains. Analyses of ground motions show that one dimensional wave propagation models may be used to predict free field seismic motions in most parts of the Lake zone.

Sign in / Sign up

Export Citation Format

Share Document