Faculty Opinions recommendation of Surveillance strategies for sarcoma: results of a survey of members of the musculoskeletal tumor society.

Author(s):  
Stefan Bielack
2020 ◽  
Vol 10 (4) ◽  
pp. 278
Author(s):  
Andrea Angelini ◽  
Cesare Tiengo ◽  
Regina Sonda ◽  
Antonio Berizzi ◽  
Franco Bassetto ◽  
...  

Background and Objectives. Wide surgical resection is a relevant factor for local control in sarcomas. Plastic surgery is mandatory in demanding reconstructions. We analyzed patients treated by a multidisciplinary team to evaluate indications and surgical approaches, complications and therapeutic/functional outcomes. Methods. We analyzed 161 patients (86 males (53%), mean age 56 years) from 2006 to 2017. Patients were treated for their primary tumor (120, 75.5%) or after unplanned excision/recurrence (41, 25.5%). Sites included lower limbs (36.6%), upper limbs (19.2%), head/neck (21.1%), trunk (14.9%) and pelvis (8.1%). Orthoplasty has been considered for flaps (54), skin grafts (42), wide excisions (40) and other procedures (25). Results. At a mean follow-up of 5.3 years (range 2–10.5), patients continuously showed no evidence of disease (NED) in 130 cases (80.7%), were alive with disease (AWD) in 10 cases (6.2%) and were dead with disease (DWD) in 21 cases (13.0%). Overall, 62 patients (38.5%) developed a complication (56 minor (90.3%) and 6 major (9.7%)). Flap loss occurred in 5/48 patients (10.4%). The mean Musculoskeletal Tumor Society (MSTS) and Toronto Extremity Salvage Score (TESS) was 74.8 ± 14 and 79.1 ± 13, respectively. Conclusions. Orthoplasty is a combined approach effective in management of sarcoma patients, maximizing adequate surgical resection, limb salvaging and functional recovery. One-stage reconstructions are technically feasible and are not associated with increased risk of complications.


Author(s):  
Alex Guedes ◽  
Marcelo Bragança dos Reis Oliveira ◽  
Flávia Martins Costa ◽  
Adelina Sanches de Melo

ResumoOs sarcomas ósseos e das partes moles consistem em grupo heterogêneo de neoplasias malignas de origem mesenquimal que podem ocorrer em qualquer faixa etária. O estadiamento preciso destas lesões determina as melhores estratégias terapêuticas e estimativas de prognóstico. Dois sistemas de estadiamento são os mais frequentemente empregados no manejo destas neoplasias: o sistema proposto pelo grupo da Universidade da Flórida, liderado pelo Dr. William F. Enneking (1980), adotado pela Musculoskeletal Tumor Society (MSTS) e o sistema desenvolvido pela American Joint Committee on Cancer (AJCC) (1977) que se encontra em sua 8a edição (2017). O presente artigo busca atualizar o leitor a respeito do estadiamento dos sarcomas ósseos e das partes moles que acometem o sistema musculoesquelético.


Metals ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 707
Author(s):  
Jong-Woong Park ◽  
Hyun-Guy Kang ◽  
June-Hyuk Kim ◽  
Han-Soo Kim

In orthopedic oncology, revisional surgery due to mechanical failure or local recurrence is not uncommon following limb salvage surgery using an endoprosthesis. However, due to the lack of clinical experience in limb salvage surgery using 3D-printed custom-made implants, there have been no reports of revision limb salvage surgery using a 3D-printed implant. Herein, we present two cases of representative revision limb salvage surgeries that utilized another 3D-printed custom-made implant while retaining the previous 3D-printed custom-made implant. A 3D-printed connector implant was used to connect the previous 3D-printed implant to the proximal ulna of a 40-year-old man and to the femur of a 69-year-old woman. The connector bodies for the two junctions of the previous implant and the remaining host bone were designed for the most functional position or angle by twisting or tilting. Using the previous 3D-printed implant as a taper, the 3D-printed connector was used to encase the outside of the previous implant. The gap between the previous implant and the new one was subsequently filled with bone cement. For both the upper and lower extremities, the 3D-printed connector showed stable reconstruction and excellent functional outcomes (Musculoskeletal Tumor Society scores of 87% and 100%, respectively) in the short-term follow-up. To retain the previous 3D-printed implant during revision limb salvage surgery, an additional 3D-printed implant may be a feasible surgical option.


2021 ◽  
Vol 10 (5) ◽  
pp. 1056
Author(s):  
Giovanni Beltrami ◽  
Gabriele Ristori ◽  
Anna Maria Nucci ◽  
Alberto Galeotti ◽  
Angela Tamburini ◽  
...  

Recently, custom-made 3D-printed prostheses have been introduced for limb salvage surgery in adult patients, but their use has not been described in pediatric patients. A series of 11 pediatric patients (mean age 10.8 years; range 2–13) with skeletal tumors treated with custom-made implants for the reconstruction of bony defects is described. Patients were followed up every 3 months. Functional results were evaluated by the Musculoskeletal Tumor Society Score (MSTS) for upper and lower limbs. The mean follow-up was 25.7 months (range 14–44). Three patients died after a mean of 19.3 months postoperatively—two because of disease progression and the other from a previous malignancy. Three patients experienced complications related to soft tissues. One patient required device removal, debridement, and antibiotic pearls for postoperative infection. Partial osseointegration between grafts and host bone was observed within a mean of 4 months. At the final follow-up, mean MSTS score was 75%. 3D prostheses may yield biological advantages due to possible integration with the host bone and also through the use of vascularized flaps. Further research is warranted.


2021 ◽  
Vol 8 (9) ◽  
pp. 2618
Author(s):  
Ritwika Nandi ◽  
Pinaki Das ◽  
Sujit Narayan Nandi

Background: Juxta articular giant cell tumors around the knee constitute 50-60% of the total cases reported. If the disease is detected at an advanced stage, reconstruction of the joint after tumor excision poses problems and has poor functional outcome. The aim of the study was to determine the functional outcome after resection of juxta-articular giant cell tumors around the knee and its reconstruction with mega prosthetic arthroplasty will be analyzed.Methods: Between January 2017 and March 2021, 14 patients in the age group of 28-48 years (mean=42.85 years) with Campanacci stage three giant cell tumors around the knee were studied (12-distal femur patients, 2-proximal tibia). Patients underwent tumor excision and reconstruction with modular megaprosthesis. They were evaluated post-operatively using the Revised Musculoskeletal Tumor Society Score (MSTS) for lower limb.  Results: All the patients were followed up for 12-44 months (mean=29.5 months), the average knee flexion at 6 months being 116.4 degrees. The mean MSTS at 6, 12, 18 and 24 months are 19.45, 23.23, 26.61 and 28.77 respectively. Complications observed were infection and tumor recurrence.  Conclusions: In advanced cases where tumor excision leaves large bone segment loss, reconstruction with megaprosthesis can give desirable functional outcome.


2020 ◽  
Author(s):  
Hongwei Wu ◽  
Xian'an Li ◽  
Shuo Yang ◽  
Jie Bu ◽  
Xuezheng Xu ◽  
...  

Abstract Background: Surgical resection and reconstruction for low grade bone sarcoma in the metaphysis of the long bone remains challenging. We hypothesize that 3D printing osteotomy guide plate could assist to accurately resect the tumor lesion and save the joint function without higher recurrence rate. Methods: From January 2017 to August 2019, ten patients with low-grade malignant bone tumor in metaphysis of the limbs were treated with hemicortical resection using 3D printing guide plate and biological reconstruction. Results: Four patients were paracorticular osteosarcoma, five cases had highly differentiated chondrosarcoma, and one case was a chondromyxoid fibroma. Two of the cases involved the proximal humerus, while eight cases involved the distal femur. There was neither post-operation infection, internal fixation loosening, nor fracture occurrence in any of the patients. The Musculoskeletal Tumor Society score averaged at 27.1, while the International Society of Limb Salvage imaging score examination averaged 87.8%. Conclusions: Here, we demonstrate that the 3D printing osteotomy guide plate assisted hemicortical bone resection is a beneficial strategy to effectively resect the primary low-grade malignant bone tumors in the metaphysis of long bone and restore excellent joint function.


2020 ◽  
Vol 10 (2) ◽  
pp. 67-71
Author(s):  
Suresh Pandey

Background: Giant Cell Tumor of the bone (GCTB) has got variable outcome after the different methods of surgical treatment depending upon the site and grade of lesion and extent of tumor removal. This retrospective prospective analysis of operatively treated cases of GCTB of different sites aimed to highlight the clinical outcome. Methods: This was a prospective observational study of 18 cases of GCTB; proximal tibia (n=6), distal femur (n=5), distal radius (n=4), proximal femur (n=1), proximal fibula (n=1) and anterior arc of first rib (n=1) treated with different operative management with mean follow up of 53.61 months. Functional outcome with Musculoskeletal Tumor Society Score (MSTS), recurrence and complications were analyzed with at least 24 months of follow up. Results: There were 10 females and 8 males with average age at presentation 27.3 years (range 15-38). Average duration of symptom was 4.72 months. 2 were cases of recurrence previously op­erated and 16 were de novo cases. Mean MSTS was 84.27% with good to excellent result in 88%. There were no non-union, graft failure, metastasis, prosthetic failure or wound infection till at least 24 months of follow up in any of the cases. Conclusions: Extended curettage or reconstruction with auto graft in grade I and II tumor or en­doprosthesis in higher grade or recurrence of GCTB can give good to excellent functional result in majority of the cases.


2019 ◽  
Vol 33 (08) ◽  
pp. 818-824
Author(s):  
Joseph A. Ippolito ◽  
Megan L. Campbell ◽  
Brianna L. Siracuse ◽  
Joseph Benevenia

AbstractFor patients with tumors of the distal femur, options for limb salvage include tumor resection followed by reconstruction. While reconstruction commonly involves a distal femoral replacement, careful selection of patients with tumor involvement limited to a single condyle may be candidates for reconstruction with distal femur hemiarthroplasty. In these procedures, resection spares considerably more native anatomy. Three consecutive patients who underwent resection and reconstruction at the distal femur with custom unicondylar hemiarthroplasty are presented in this case series at a mean follow-up of 45 months (range, 26–78). In two cases, prostheses were utilized as a secondary procedure after failure of initial reconstruction. In one case, the custom prosthesis was utilized as the primary method of reconstruction. Mean Musculoskeletal Tumor Society disease-specific scores were 26.7 (range, 25–28). All patients achieved a return to full weight bearing, activities of daily living, and functional range of motion. In appropriately selected patients with tumors of the distal femur, reconstruction with custom unicondylar hemiarthroplasty provides benefits including optimal function postoperatively via preservation of tumor-free bone and ligamentous structures. Additionally, maintenance of greater bone stock may confer benefits to patients with pathology at a high likelihood for recurrence and need for subsequent procedures.


2020 ◽  
Vol 18 (1) ◽  
Author(s):  
Zhiqiang Zhao ◽  
Qinglin Jin ◽  
Xianbiao Xie ◽  
Yongqian Wang ◽  
Tiao Lin ◽  
...  

Abstract Background At present, amputation was widely adopted for young patients when limb salvage was deemed risky with several surgical strategy such as rotationplasty. However, leg length discrepancies and unfavorable cosmetic results were indispensable complication of this strategy. The purpose of this study was to propose a novel reconstruction strategy and evaluate the early clinical and functional outcomes of the strategy. Methods Plastic lengthening amputation (PLA) has been developed by lengthening the stump to preserve one additional distal joint for fixing the artificial limb well. The surgical technique and postoperative management were documented, and the functional outcomes were compared with those of traditional amputation (TA). Six pairs of patients matched for age, sex, location, pathological type, and final prosthesis underwent individually designed plastic lengthening amputation with vascularized autografts or traditional amputation between January 2005 and December 2007. All patients were followed, and the locomotor index and the musculoskeletal tumor society score (MSTS) were used to describe and quantitatively grade limb functional outcomes after amputation. The complications and functional outcomes of the patients taken two kinds of procedures were compared. Results Twelve patients with osteosarcoma or Ewing’s sarcoma of either the femur or tibia were included in the study. Six patients underwent plastic lengthening amputations, three of whom also underwent vascular anastomosis. Patients were followed for an average of 48.17 months; bone healing required an average of 3.3 months. No local recurrence was found. The average postoperative locomotor index functional score of the affected limb was 32.67 ± 5.89 in the plastic lengthening amputation group while was 19.50 ± 7.87 in the traditional amputation group. The MSTS functional scores were 22.67 ± 1.33 and 24.17 ± 1.45 at 6 and 12 months for patients in PLA group while 17.00 ± 1.549 and 17.83 ± 1.64 at 6 and 12 months for patients in TA group. Conclusions Plastic lengthening amputations with vascularized autografts could preserve the knee joint to improve the function of the amputated limb in selected bone sarcoma patients.


Sign in / Sign up

Export Citation Format

Share Document