scholarly journals Design and Simulation of Spoon Shaped Antenna using DGS

2019 ◽  
Vol 9 (2) ◽  
pp. 2257-2259
Keyword(s):  
Return Loss ◽  
Antenna Design ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Antenna Structure ◽  
Comparison Results ◽  
Wireless Application ◽  
Cst Microwave Studio

A planer spoon shaped antenna with defected ground structure (DGS) is designed and fabricated for wireless application. The proposed antenna design exhibits 1.6GHz bandwidth, 2.20dBi Avg. Gain and maximum return loss of -24.5dB, which offers better results in wideband application. The Proposed antenna structure is simulated by software CST MWS (CST Microwave Studio) version 2018 and later comparison results are also presented

Bandwidth Enhancement of Rectangular Microstrip Patch Antenna using Defected Ground Structure

2016 ◽  
Vol 3 (2) ◽  
pp. 428 ◽  
Author(s):  
Dawit Fitsum ◽  
Dilip Mali ◽  
Mohammed Ismail
Keyword(s):  
Patch Antenna ◽  
Return Loss ◽  
Ground Plane ◽  
Microstrip Patch Antenna ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Antenna Structure ◽  
Bandwidth Enhancement ◽  
Microstrip Patch ◽  
Rectangular Microstrip Patch Antenna

<p>This paper presents the bandwidth enhancement of a Proximity Coupled Feed Rectangular Microstrip Patch Antenna using a new Defected Ground Structure - an ‘inverted SHA’ shaped slot on the ground plane of the proximity coupled feed rectangular Microstrip patch antenna. The parameters such as Bandwidth, Return loss, VSWR and Radiation efficiency are improved in the proposed antenna than simple proximity coupled feed rectangular Microstrip patch antenna without Defected Ground Structure. A comparison is also shown for the proposed Microstrip patch antenna with the antenna structure without Defected Ground Structure. The proposed antenna resonates in S-band at frequency of 2.4 GHz with bandwidth of 180 MHz. A very good return loss of -47.9223 dB is obtained for the Microstrip patch antenna with an ’inverted SHA’ shaped Defected Ground Structure. Implementing an ‘inverted SHA’ shaped defect in the ground plane of the proximity coupled feed rectangular Microstrip patch antenna results in 5.3% improvement in bandwidth with 16.01% reduction in the overall area of the ground plane as compared to the Microstrip patch antenna without Defected Ground Structure.</p>

scholarly journals Low Profile Frequency Reconfigurable PIFA Antenna using Defected Ground Structure

2017 ◽  
Author(s):  
Pham Trung Minh ◽  
Nguyen Trong Duc ◽  
Phan Xuan Vu ◽  
Nguyen Thanh Chuyen ◽  
Vu Van Yem
Keyword(s):  
Ground Plane ◽  
Antenna Design ◽  
Wireless Devices ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Pin Diodes ◽  
Antenna Structure ◽  
Frequency Bands ◽  
Low Profile ◽  
Two Sides

In this paper, we design and implement a low profile frequency reconfigurable Planar Inverted-F Antenna (PIFA) for WLAN, m-WiMAX and UMTS applications. Dierent from several conventional designs, the air layer in our antenna is removed, while the radiator patches and ground plane are printed on two sides of the same substrate. This makes the antenna structure thin and lightweight. The defected ground structure (DGS) and coplanar sorting-trips are also designed for adjusting lower operating frequencies without increasing the antenna’s size. Three PIN-diodes are used in appropriate positions for accurate switches between frequency bands. Moreover, the three radiator patches’ parameters are optimally selected on all configurations using Genetic Algorithm (GA). Simulation results show that depending on the ON/OFF states of the PIN-diodes, the antenna can operate in three applicable frequency bands, i.e., 2.1 GHz, 2.4 GHz, and 3.5 GHz with the corresponding peak gains of 0.48 dBi, 3.55 dBi, and 4.33 dBi. The antenna occupies an overall size of 63.5x33.5x1.6 mm3, which can be easily fabricated and integrated into small wireless devices. Simulated and measured results are also compared to validate the correctness the antenna design.

scholarly journals Application of Defected Ground Structure to Suppress Out-of-Band Harmonics for WLAN Microstrip Antenna

2015 ◽  
Vol 2015 ◽  
pp. 1-9 ◽  
Author(s):  
Pravin Ratilal Prajapati
Keyword(s):  
Microstrip Antenna ◽  
Wireless Local Area Network ◽  
Local Area Network ◽  
Filter Design ◽  
Stop Band ◽  
Local Area ◽  
Area Network ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Cst Microwave Studio

An application of defected ground structure (DGS) to reduce out-of-band harmonics has been presented. A compact, proximity feed fractal slotted microstrip antenna for wireless local area network (WLAN) applications has been designed. The proposed 3rd iteration reduces antenna size by 43% as compared to rectangular conventional antenna and by introducing H shape DGS, the size of an antenna is further reduced by 3%. The DGS introduces stop band characteristics and suppresses higher harmonics, which are out of the band generated by 1st, 2nd, and 3rd iterations. H shape DGS is etched below the 50 Ω feed line and transmission coefficient parameters (S21) are obtained by CST Microwave Studio software. The values of equivalent L and C model have been extracted using a trial version of the diplexer filter design software. The stop band characteristic of the equivalent LC model also has been simulated by the Advance Digital System software, which gives almost the same response as compared to the simulation of CST Microwave Studio V. 12. The proposed antenna operates from 2.4 GHz to 2.49 GHz, which covers WLAN band and has a gain of 4.46 dB at 2.45 GHz resonance frequency.

scholarly journals A Novel Circular Slotted Microstrip-Fed Patch Antenna with three Triangle Shape Defected Ground Structure for Multiband Applications

2018 ◽  
Vol 7 (3) ◽  
pp. 56-63 ◽  
Author(s):  
A. Jaiswal ◽  
R. K. Sarin ◽  
B. Raj ◽  
S. Sukhija
Keyword(s):  
Patch Antenna ◽  
Return Loss ◽  
Impedance Matching ◽  
Ground Plane ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Resonant Frequencies ◽  
Wireless Applications ◽  
Rectangular Patch ◽  
Miniaturized Antenna

In this paper, a novel circular slotted rectangular patch antenna with three triangle shape Defected Ground Structure (DGS) has been proposed. Radiating patch is made by cutting circular slots of radius 3 mm from the three sides and center of the conventional rectangular patch structure and three triangle shape defects are presented on the ground layer. The size of the proposed antenna is 38 X 25 mm2. Optimization is performed and simulation results have been obtained using Empire XCcel 5.51 software. Thus, a miniaturized antenna is designed which has three impedance bandwidths of 0.957 GHz,  0.779 GHz, 0.665 GHz with resonant frequencies at 3.33 GHz, 6.97 GHz and 8.59 GHz and the corresponding return loss at the three resonant frequencies are -40 dB, -43 dB and -38.71 dB respectively. A prototype is also fabricated and tested. Fine agreement between the measured and simulated results has been obtained. It has been observed that introducing three triangle shape defects on the ground plane results in increased bandwidth, less return loss, good radiation pattern and better impedance matching over the required operating bands which can be used for wireless applications and future 5G applications.

Wideband out-of-phase power dividers with improved isolation performance

2019 ◽  
Vol 11 (08) ◽  
pp. 761-764
Author(s):  
Kaijun Song ◽  
Fei Xia ◽  
Yuxuan Chen ◽  
Yu Zhu ◽  
Jiawei Li ◽  
...  
Keyword(s):  
Return Loss ◽  
Power Divider ◽  
Band Width ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Power Dividers ◽  
Marchand Balun ◽  
Isolation Performance

AbstractA compact wideband out-of-phase power divider (PD) with improved isolation performance is proposed. This divider is formed by connecting an additional stub for isolation to output ports of a traditional Marchand balun with a defected ground structure (DGS) been used. To verify the design, a prototype divider is fabricated and tested. The measured results validate the 53.86% band-width centered at 3.43 GHz with more than 15 dB return loss at all ports, more than 17 dB isolation, respectively.

Dual-Band Proximity Coupled Feed Microstrip Patch Antenna with ‘T’ Slot on the Radiating Patch and ‘Dumbbell’ Shaped Defected Ground Structure

2016 ◽  
Vol 3 (2) ◽  
pp. 435 ◽  
Author(s):  
Dawit Fitsum ◽  
Dilip Mali ◽  
Mohammed Ismail
Keyword(s):  
Patch Antenna ◽  
Return Loss ◽  
Ground Plane ◽  
Microstrip Patch Antenna ◽  
Dual Band ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Wireless Applications ◽  
Microstrip Patch ◽  
Rectangular Microstrip Patch Antenna

<p>This paper presents Dual-Band proximity coupled feed rectangular Microstrip patch antenna with slots on the radiating patch and Defected Ground Structure. Initially a simple proximity coupled feed rectangular Microstrip patch antenna resonating at 2.4 GHz is designed. Etching out a ‘Dumbbell’ shaped defect from the ground plane and ‘T’ shaped slot from the radiating patch of the proximity coupled feed rectangular Microstrip patch antenna, results in a Dual-Band operation, i.e., resonating at 2.4 GHz and 4.5 GHz; with 30.3 % and 18.8% reduction in the overall area of the patch and the ground plane of the reference antenna respectively. The proposed antenna resonates in S-band at frequency of 2.4 GHz with bandwidth of 123.6 MHz and C-band at frequency of 4.5 GHz with bandwidth of 200 MHz, and a very good return loss of -22.1818 dB and -19.0839 dB at resonant frequency of 2.4 GHz and 4.5 GHz respectively is obtained. The proposed antenna is useful for different wireless applications in the S-band and C-band.</p>

A Ku-Band Wideband Power Divider with Defected Ground Structure

2013 ◽  
Vol 385-386 ◽  
pp. 1292-1295
Author(s):  
Xu Han ◽  
Jian Hua Xu
Keyword(s):  
Insertion Loss ◽  
Return Loss ◽  
Ground Plane ◽  
Power Divider ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Power Split ◽  
Equal Power ◽  
Better Than ◽  
Ku Band

A planar power divider operating over the whole Ku-band is presented. The proposed device utilizes a T-microstrip junction combined with defected ground structure and an elliptical patch at the centre of the T-junction. An isolation resistor is connected across the slotted ground plane. The simulated results of the divider show equal power split, insertion loss is less than 0.3dB, return loss of all ports are better than 15dB, and isolation is better than 15dB over the whole Ku-band.

scholarly journals Triangular Cavity Multi-Passband HMSIW Filter Based on Odd-Even Mode Analysis

Electronics ◽  
2021 ◽  
Vol 10 (23) ◽  
pp. 2927
Author(s):  
Luhua Zhang ◽  
Aiting Wu ◽  
Pengquan Zhang ◽  
Zhonghai Zhang
Keyword(s):  
Return Loss ◽  
Resonant Mode ◽  
Mode Analysis ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Dual Mode ◽  
Coupling Path ◽  
Overall Performance ◽  
Better Than ◽  
Good Agreement

This letter proposes a multi-passband half-mode substrate integrated waveguide (HMSIW) filter based on the theory of odd and even mode analysis. The filter adopts a triangular HMSIW cavity cut along the diagonal of the rectangle. By etching two dual-mode resonators, the resonant mode of the HMSIW resonator is coupled with the odd-even mode of the dual-mode resonator to achieve multiple passbands. The defected ground structure (DGS) of the filter can reduce the resonance frequency of the HMSIW cavity without increasing the volume of the HMSIW cavity, making it easier to couple with the odd and even mode frequencies of the resonator. The input and output ports are directly coupled through a microstrip line. In this way, it adds an additional coupling path to the filter, which increases the out-of-band suppression without changing the performance in the passband, and improves the overall performance of the filter. To prove the feasibility of the above method, a multi-passband HMSIW filter was fabricated and tested. The center frequencies of the three passbands of the filter are 2.98 GHz, 4.78 GHz, and 6.62 GHz, respectively. The return loss in the passband is better than −15 dB, and the insertion loss is better than 2 dB. The measured results have a good agreement with the simulation results.

Sign in / Sign up

Export Citation Format

Share Document