scholarly journals Fault Diagnosis Algorithm and Protection of Electric Power Systems in an Alternative Distribution System

2020 ◽  
Vol 1 (3) ◽  
pp. 8-16
Author(s):  
Oshin Ola Austin ◽  
Oluwasanmi Alonge ◽  
Ajayi Joseph Adeniyi
Keyword(s):  
Power Systems ◽  
Distribution System ◽  
Short Circuit ◽  
Circuit Breaker ◽  
Research Work ◽  
Short Circuit Current ◽  
Phase System ◽  
Fault Current ◽  
Circuit Breakers ◽  
Protective Devices

In any power systems, protective devices will detect fault conditions and operate circuit breakers in order to disconnect the load from the fault current and limit loss of service due to failure. This fault may involve one or more phases and the ground, or may occur between two or more phases in a three-phase systems. In ground, fault’ or ‘earth fault, current flows into the earth. In a poly-phase system, a fault may affect each of the three phases equally which is a symmetrical fault. If only some phases are affected, the resulting ‘asymmetrical fault’ becomes more complicated to analyze due to the simplifying assumption of equal current magnitude in all the phases being no longer applicable. Therefore, the prospective short circuit current of the fault can be calculated for power systems analysis procedures. This will assist in the choice of protective devices like circuit breakers, current transformers and relays. This research work evaluated and analyzed the occurrence of faults in a distribution system. Fault currents were obtained and the maximum tripping time required for the protective devices to operate were determined. Hence, it was possible to select appropriate relay and circuit breaker for effective operation of a distribution

scholarly journals Impact of Momentary Cessation Voltage Level in Inverter-Based Resources on Increasing the Short Circuit Current

2019 ◽  
Vol 11 (4) ◽  
pp. 1153 ◽  
Author(s):  
Namki Choi ◽  
Bohyun Park ◽  
Hwanhee Cho ◽  
Byongjun Lee
Keyword(s):  
Power Systems ◽  
Short Circuit ◽  
Circuit Breaker ◽  
Short Circuit Current ◽  
Fault Current ◽  
Test Results ◽  
Voltage Level ◽  
Fault Currents ◽  
Current Calculation ◽  
The Impact

This study analyzed the impact of varying the momentary cessation (MC) voltage level on the short circuit current of inverter-based resources (IBRs). To analyze the impact of the IBR MC function on the short circuit current, this paper proposes an advanced IBR model for fault current calculation to reflect its fault characteristics and a scheme for analyzing the influence of MC on the short circuit current. Based on the proposed methods, the authors conducted case studies using planning data from the Korea Electric Power Corporation (KEPCO). The influence of MC was investigated on the IBRs located at the southwest side of the KEPCO systems by screening the fault currents while varying the MC voltage. This paper demonstrates that the minimum MC voltage level needed for the fault current not to exceed the circuit breaker (CB) capacity can be proposed through analyzing the impact of MC voltage level on the short circuit current. The test results based on the proposed scheme showed that the short circuit current to power systems could not violate CB capacity if IBRs adjusted the MC voltage level higher than the lowest MC voltage level.

scholarly journals Design and computational modeling of fault current limiter topologies

2020 ◽  
Author(s):  
Alexandre Bitencourt ◽  
Daniel H. N. Dias ◽  
Bruno W. França ◽  
Felipe Sass ◽  
Guilherme G. Sotelo
Keyword(s):  
Electric Power ◽  
Distributed Generation ◽  
Distribution System ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Economic Feasibility ◽  
Fault Current ◽  
Fault Current Limiter ◽  
Fault Current Limiters ◽  
Current Limiter

The increase in demand for electric power and the insertion of a distributed generation led to the rise of the short-circuit current in substations. Most of these Brazilian substations were designed decades ago, because of that their equipment may not support the new short-circuit current levels. To protect the installed equipment and avoid excessive costs replacing old devices, it is possible to install Fault Current Limiters (FCLs). This document is a report from an R&D project that evaluated FCL topologies considering real parameters in simulation from used equipment, concluding that the selected FCL topologies accomplished their technical objective. However, before implementing these topologies in the distribution system, one should consider the technical and economic feasibility of using semiconductor switching devices.

scholarly journals Active Reduction of Short-Circuit Current in Power Distribution Systems

Energies ◽  
2020 ◽  
Vol 13 (2) ◽  
pp. 334
Author(s):  
Esteban Pulido ◽  
Luis Morán ◽  
Felipe Villarroel ◽  
José Silva
Keyword(s):  
Power Distribution ◽  
Distribution System ◽  
Distribution Systems ◽  
Short Circuit ◽  
Circuit Breaker ◽  
Short Circuit Current ◽  
Power Converter ◽  
Power Distribution Systems ◽  
Power Distribution System ◽  
In Series

In this paper, a new concept of short-circuit current (SCC) reduction for power distribution systems is presented and analyzed. Conventional fault current limiters (FCLs) are connected in series with a circuit breaker (CB) that is required to limit the short-circuit current. Instead, the proposed scheme consisted of the parallel connection of a current-controlled power converter to the same bus intended to reduce the amplitude of the short-circuit current. This power converter was controlled to absorb a percentage of the short-circuit current from the bus to reduce the amplitude of the short-circuit current. The proposed active short-circuit current reduction scheme was implemented with a cascaded H-bridge power converter and tested by simulation in a 13.2 kV industrial power distribution system for three-phase faults, showing the effectiveness of the short-circuit current attenuation in reducing the maximum current requirement in all circuit breakers connected to the same bus. The paper also presents the design characteristics of the power converter and its associated control scheme.

Fault Current Limitation (FCL) and Voltage Dip Improvement Thanks to Distributed Static Series Compensator (DSSC)

2012 ◽  
Vol 260-261 ◽  
pp. 525-531 ◽  
Author(s):  
Salman Badkubi
Keyword(s):  
Power Systems ◽  
Power Flow ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Fault Current ◽  
Additional Function ◽  
Power Flow Control ◽  
Current Limitation ◽  
Fault Currents ◽  
Voltage Dip

This paper presents the comprehensive implementation of Distributed Static Series Compensator (DSSC) to limit the fault currents in power systems. This is the first time that the limitation of fault currents with D-FACTS devices is addressed. DSSC is one of the D-FACTS families whichoperate in a similar manner as Static Synchronous Series Compensator (SSSC) but in smaller size, lower price and more capability. The effectiveness of the DSSC in fault current limitation is investigated through the series voltage effect upon the line. The short circuit current limitation strategy presented here exhibited that besides of the power flow control which is carried out by DSSC; it can also perform this additional function. In the following the potency of the DSSC in reduction of instantaneous voltage dip range during fault current limiting mode is clarified. Furthermore, it is disclosed that with performing more DSSC in the power system, the entire system voltage dip will be improved. In order to validate the claims, computer simulations using PSCAD/EMTDC are exploited.

scholarly journals Probability-Based Customizable Modeling and Simulation of Protective Devices in Power Distribution Systems

Energies ◽  
2021 ◽  
Vol 15 (1) ◽  
pp. 199
Author(s):  
Chengwei Lei ◽  
Weisong Tian
Keyword(s):  
Power Systems ◽  
Power Distribution ◽  
Distribution System ◽  
Distribution Systems ◽  
Short Circuit ◽  
Current Data ◽  
System Level ◽  
Power Distribution Systems ◽  
Power Distribution System ◽  
Protective Devices

Fused contactors and thermal magnetic circuit breakers are commonly applied protective devices in power distribution systems to protect the circuits when short-circuit faults occur. A power distribution system may contain various makes and models of protective devices, as a result, customizable simulation models for protective devices are demanded to effectively conduct system-level reliable analyses. To build the models, thermal energy-based data analysis methodologies are first applied to the protective devices’ physical properties, based on the manufacturer’s time/current data sheet. The models are further enhanced by integrating probability tools to simulate uncertainties in real-world application facts, for example, fortuity, variance, and failure rate. The customizable models are expected to aid the system-level reliability analysis, especially for the microgrid power systems.

scholarly journals Modeling of transformer type fault current limiter in 22kv distribution power system at Ho Chi Minh City

2020 ◽  
Vol 2 (3) ◽  
Author(s):  
Đoàn Tự Do ◽  
Lê Bửu Toàn ◽  
Lê Thị Tịnh Minh
Keyword(s):  
Power System ◽  
Distribution System ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Fault Current ◽  
Fault Current Limiter ◽  
Technical Problems ◽  
High Impedance ◽  
Transformer Type ◽  
Current Limiter

Nowadays, with consecutive development of the power system, not only the scale of the grid is expanded but also many technical problems exist. One of the most important problems is the exceeding short circuit current in the power grid, this value exceeds out of the regulation’s range as well as breaking capacity of the protection devices. In this paper, a fault current limiter (FCL) device is introduced as a solution; it works as a high impedance in short circuit cases and low impedance in normally case. This paper simulates the fault current limiter transformer type in MATLAB/SIMULINK, the effect of FCLT’s parameters to short circuit reduction is given in the results. Application of FCLT in reality network also is presented with markable results of short circuit reduction in Ho Chi Minh Power Corporation‘s distribution system.

scholarly journals A Digital-Controlled SiC-Based Solid State Circuit Breaker with Soft Switch-Off Method for DC Power System

Electronics ◽  
2019 ◽  
Vol 8 (8) ◽  
pp. 837 ◽  
Author(s):  
Qin ◽  
Mo ◽  
Xun ◽  
Zhang ◽  
Dong
Keyword(s):  
Solid State ◽  
Field Effect Transistors ◽  
Cooling System ◽  
Short Circuit ◽  
Circuit Breaker ◽  
Short Circuit Current ◽  
Oxide Semiconductor ◽  
Circuit Breakers ◽  
Solid State Circuit ◽  
Protection Method

Due to the lower on-state resistance, direct current (DC) solid state circuit breakers (SSCBs) based on silicon-carbide (SiC) metal-oxide-semiconductor field-effect transistors (MOSFETs) can reduce on-state losses and the investment of the cooling system when compared to breakers based on silicon (Si) MOSFETs. However, SiC MOSFETs, with smaller die area and higher current density, lead to weaker short-circuit ability, shorter short-circuit withstand time and higher protection requirements. To improve the reliability and short-circuit capability of SiC-based DC solid state circuit breakers, the short-circuit fault mechanisms of Si MOSFETs and SiC MOSFETs are revealed. Combined with the desaturation detection (DESAT), a “soft turn-off” short-circuit protection method based on source parasitic inductor is proposed. When the DESAT protection is activated, the “soft turn-off” method can protect the MOSFET against short-circuit and overcurrent. The proposed SSCB, combined with the flexibility of the DSP, has the μs-scale ultrafast response time to overcurrent detection. Finally, the effectiveness of the proposed method is validated by the experimental platform. The method can reduce the voltage stress of the power device, and it can also suppress the short-circuit current.

A Type of Depth Fault Current Limiter Based on Fast Switch and its Experimental Research

2014 ◽  
Vol 521 ◽  
pp. 213-216
Author(s):  
Li Jun Qin ◽  
Xiao Teng Wu
Keyword(s):  
Power System ◽  
Energy Loss ◽  
Short Circuit ◽  
Circuit Breaker ◽  
Short Circuit Current ◽  
Current Level ◽  
Fault Current ◽  
Fault Current Limiter ◽  
Fault Currents ◽  
Current Limiter

Along with the expansion of power system, the rapid growth of load in power system and large capacity generators continuously going into operation, the increasing of short-circuit current level cause a serious threat to the security of the power system. The contradiction between high fault currents and limited circuit breaker interrupting capacity is prominent, in order to limit high short-circuit current, reduce the energy loss of traditional fault current limiter, and improve the limiting depth, this paper presents an new fault current limiter (FCL), and analysis its ability of limiting short current.

Sign in / Sign up

Export Citation Format

Share Document