New Economic Concept of Synergy of CO2 Geological Storage and Enhanced Oil Recovery in E6 Structure Offshore Latvia

Author(s):  
K. Shogenov ◽  
A. Shogenova
Author(s):  
Suguru Uemura ◽  
Ryoto Kataoka ◽  
Shohji Tsushima ◽  
Shuichiro Hirai

The CO2 Geological storage is considered as an effective technology for reducing the emissions of CO2 into the atmosphere. CO2 storage is a technically feasible and effective method for CO2 mitigation because it is based on enhanced oil recovery technology, and storage sites hold significant potential. Currently, field tests for CO2 geological storage are proceeding in many parts of the world. However, the behavior of injected CO2 is still not completely understood. The CO2 storage potential and risk of leakage from reservoirs must be accurately estimated to realize practicable CO2 storage. For this reason, laboratory-scale experimental analysis of the behavior of CO2 injected in sandstone are an important issues. In this study, CO2 distribution and its behavior in sandstone were observed by micro-focus X-ray computed tomography (CT). The X-ray CT can fluoroscope the CO2 in the porous media and reconstruct a three-dimensional CO2 distribution image. A sample was kept under high pressure conditions in a cylindrical pressure vessel and filled with CO2 saturated water. Pressure in the vessel was kept at 7.5 MPa, which is the same condition as a saline aquifer at 750 m depth. Liquid or supercritical CO2 was injected from the end face of water saturated samples. Temperature conditions were set to 20 or 40°C according to the experimental objectives of the CO2 phase. In the experimental results, CO2 distribution in the silica-packed bed and sandstone was clearly visualized with high spatial resolution compared to its diameter. The possibility of improvement in storage technology discussed.


2020 ◽  
pp. 014459872092707 ◽  
Author(s):  
Jinhyung Cho ◽  
Moon S Jeong ◽  
Young W Lee ◽  
Hye S Lee ◽  
Kun S Lee

This study proposes economic evaluation of CO2 geological storage with enhanced oil recovery. The procedures consider capital expenditures and operating costs of infrastructures and revenues from oil recovery and carbon tax credits. Extensive CO2 geological storage with enhanced oil recovery simulations was conducted to determine the most promising scenario among cases, where miscibility was controlled by the addition of liquefied petroleum gas. The addition of liquefied petroleum gas into a CO2 injection stream can accelerate reduction of oil viscosity, interfacial tension, and oil density, which cause improved displacement efficiency. The larger was the amount of liquefied petroleum gas injected, the greater was the miscibility due to minimum miscibility pressure reduction, resulting in higher oil recovery and less CO2 sequestration. Although liquefied petroleum gas addition enhances the performance of CO2 enhanced oil recovery, economic analysis should be conducted for CO2 geological storage with enhanced oil recovery due to the higher price of liquefied petroleum gas than that of CO2. Net present value decreased from liquefied petroleum gas mole fraction of 0–2% and started to increase from mole fraction 2–13% due to the miscibility effect. Then, net present value started to decrease, because the purchasing and injecting prices of the required liquefied petroleum gas exceeded that of the oil produced. Economic evaluation showed that addition of 13% liquefied petroleum gas was the most promising scenario, with a net present value of 91 MM$. Thus, we confirmed an optimum liquefied petroleum gas concentration in the CO2 geological storage with enhanced oil recovery process.


Author(s):  
A. A. Kazakov ◽  
V. V. Chelepov ◽  
R. G. Ramazanov

The features of evaluation of the effectiveness of flow deflection technologies of enhanced oil recovery methods. It is shown that the effect of zeroing component intensification of fluid withdrawal leads to an overestimation of the effect of flow deflection technology (PRP). Used in oil companies practice PRP efficiency calculation, which consists in calculating the effect on each production well responsive to subsequent summation effects, leads to the selective taking into account only the positive components of PRP effect. Negative constituents — not taken into account and it brings overestimate over to overstating of efficiency. On actual examples the groundless overstating and understating of efficiency is shown overestimate at calculations on applied in petroleum companies by a calculation.


Author(s):  
Jianlong Xiu ◽  
Tianyuan Wang ◽  
Ying Guo ◽  
Qingfeng Cui ◽  
Lixin Huang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document