Evaluation of Gas Maturity Parameters from the Hydrous Pyrolysis of Different Source Rocks

Author(s):  
A.A. Ferreira ◽  
A.L.D. Spigolon ◽  
A. Prinzhofer
Energies ◽  
2021 ◽  
Vol 14 (24) ◽  
pp. 8317
Author(s):  
Qiang Cao ◽  
Jiaren Ye ◽  
Yongchao Lu ◽  
Yang Tian ◽  
Jinshui Liu ◽  
...  

Semi-open hydrous pyrolysis experiments on coal-measure source rocks in the Xihu Sag were conducted to investigate the carbon isotope evolution of kerogen, bitumen, generated expelled oil, and gases with increasing thermal maturity. Seven corresponding experiments were conducted at 335 °C, 360 °C, 400 °C, 455 °C, 480 °C, 525 °C, and 575 °C, while other experimental factors, such as the heating time and rate, lithostatic and hydrodynamic pressures, and columnar original samples were kept the same. The results show that the simulated temperatures were positive for the measured vitrinite reflectance (Ro), with a correlation coefficient (R2) of 0.9861. With increasing temperatures, lower maturity, maturity, higher maturity, and post-maturity stages occurred at simulated temperatures (Ts) of 335–360 °C, 360–400 °C, 400–480 °C, and 480–575 °C, respectively. The increasing gas hydrocarbons with increasing temperature reflected the higher gas potential. Moreover, the carbon isotopes of kerogen, bitumen, expelled oil, and gases were associated with increased temperatures; among gases, methane was the most sensitive to maturity. Ignoring the intermediate reaction process, the thermal evolution process can be summarized as kerogen0(original) + bitumen0(original)→kerogenr (residual kerogen) + expelled oil (generated) + bitumenn+r (generated + residual) + C2+(generated + residual) + CH4(generated). Among these, bitumen, expelled oil, and C2-5 acted as reactants and products, whereas kerogen and methane were the reactants and products, respectively. Furthermore, the order of the carbon isotopes during the thermal evolution process was identified as: δ13C1 < 13C2-5 < δ13Cexpelled oil < δ13Cbitumen < δ13Ckerogen. Thus, the reaction and production mechanisms of carbon isotopes can be obtained based on their changing degree and yields in kerogen, bitumen, expelled oil, and gases. Furthermore, combining the analysis of the geochemical characteristics of the Pinghu Formation coal–oil-type gas in actual strata with these pyrolysis experiments, it was identified that this area also had substantial development potential. Therefore, this study provides theoretical support and guidance for the formation mechanism and exploration of oil and gas based on changing carbon isotopes.


2002 ◽  
Vol 66 (15) ◽  
pp. 2755-2769 ◽  
Author(s):  
Robert F Dias ◽  
Katherine H Freeman ◽  
Michael D Lewan ◽  
Stephen G Franks

1994 ◽  
Vol 131 (2) ◽  
pp. 181-190 ◽  
Author(s):  
John Parnell ◽  
Geng Ansong ◽  
Fu Jiamo ◽  
Sheng Guoying

AbstractVeins of solid bitumen occur in Cretaceous sandstones at the northwest margin of the Junggar Basin, China. The bitumen has a low aromaticity and a composition comparable to gilsonite. The bitumen contains abundant steranes and terpanes, and β-carotane, although most n- and i- alkanes have been removed, which is characteristic of the local crude oil. The sterane and triterpane maturity parameters show that the bitumen, local crude oil, and source rocks are all mature. Bitumen–wallrock relationships suggest that the host sandstone was not completely consolidated at the time of emplacement of the bitumen veins, although bitumen emplacement was a relatively late diagenetic event. The burial history for the northwest Junggar Basin shows that hydrocarbon generation from the assumed upper Permian source rocks commenced in late Triassic/early Jurassic times and suggests that rapid hydrocarbon generation may have resulted in overpressure contributing to the bitumen emplacement.


2005 ◽  
Vol 23 (4) ◽  
pp. 257-265 ◽  
Author(s):  
Sun Yuzhuang ◽  
Wang Jinxi ◽  
Liu Luofu ◽  
Chen Jianping

Source rocks in the Baise Basin have been studied more than 20 yr. However, its maturity is still a problem under debate. In this project, 32 samples of source rocks from the Baise Basin were analysed by geochemical methods in order to study the maturity of the source rocks. For this article the samples were analysed for 16 different maturity parameters. Based on their quality as maturity indicators these parameters were divided into three groups: reliable, accessorial, and unsuitable maturity parameters. According to the values from the reliable and accessorial maturity groups, a source rock in two wells was classified with respect to its maturity level. The source rock in the Nadu 1 well is assessed to be in the lower mature stage, whereas the source rock in the Nadu 2 well was assessed to be in the mature stage.


2015 ◽  
Vol 3 (3) ◽  
pp. SV1-SV7
Author(s):  
Gary H. Isaksen

Oils and condensates with high concentrations of gasoline-range hydrocarbons typically lack adequate quantities of [Formula: see text] biomarkers used for thermal maturity and organic facies evaluations. I attempted a calibration of rock-based thermal maturity parameters between gasoline-range molecular parameters and nonmolecular maturity parameters such as Rock-Eval Tmax, vitrinite reflectance, and downhole temperatures. This enables maturity evaluation of volatile oils and condensates whose biomarker concentrations are at low or trace levels. The rock-based calibration data were used to assess thermal maturity of nonvolatile oils, volatile oils, and condensates from the Central Graben area of the UK North Sea and includes samples from high-pressure (gradients [Formula: see text]) and high-temperature ([Formula: see text]) hydrocarbon systems. Source rocks for theses North Sea oils and condensates are the Upper Jurassic Kimmeridge Clay and Heather shales, with a predominance of marine, algal type II organic matter.


Sign in / Sign up

Export Citation Format

Share Document