Study on Lateral Dynamic Response of Pile Foundation in Liquefiable Soil by Using FBG Method

2012 ◽  
Vol 238 ◽  
pp. 337-340 ◽  
Author(s):  
Yu Run Li ◽  
Yan Liang ◽  
Xing Wei ◽  
Yun Long Wang ◽  
Zhen Zhong Cao

The study on lateral dynamic response of pile foundation in liquefiable soil is a significant part about seismic damage. In this paper, a new data acquisition system of FBG and calculation methods is used in the small shaking table test. The results show that FBG method used in this test is proved to be efficient and acceptable in both time characteristics and precision characteristics, it may be widely applied in the future doubtlessly. What’s more, the characteristics of p-y curves in different peak accelerations are discussed. And varying of maximum stress and displacement by corresponding acceleration is discussed. A contrast about p-y curve between dry sand and saturate sand is related, which provides a new direction in research about p-y curve.

2012 ◽  
Vol 226-228 ◽  
pp. 1089-1093
Author(s):  
Yu Run Li ◽  
Yan Liang ◽  
Xing Wei ◽  
Yun Long Wang

Lateral dynamic response of pile foundation in liquefiable soil has been one of the focal problems of the geotechnical engineering field and varieties of test methods are put forward by experts and scholars. In the dissertation, a shaking table test is based on and a new calculation method is involved too. It’s the first time that using Fiber Prague Grating (FBG) technology in the method of study on lateral dynamic response of pile foundation in liquefiable soil. Experimental results indicate that calculation by method of FBG is more accurate than that by acceleration integral method. Data processing shows that p-y curve of pile foundation in liquefiable soil can be better to indicate the actual dynamic constitutive relation, and it establishes the theoretical basis of experimental study and engineer application of pile foundation in liquefiable soil


2021 ◽  
Author(s):  
Cong Zhang ◽  
Zhong Ju Feng ◽  
Yuan Yuan Kong ◽  
Yun Hui Guan ◽  
Yun Xiu Dong ◽  
...  

Abstract Taking Puqian bridge as the prototype, a 1:30-scale pile-soil-fault interaction model was established. Through the shaking table test, the difference of dynamic response of pile foundation on both sides of fault under 0.15~0.60g ground motion intensity was studied. The pile acceleration, pile top relative displacement, and pile bending moment on both sides of the fault are compared respectively. Research results showed that under the action of a strong earthquake, the pile foundation on the hanging wall was greatly affected by ground motion, and “the hanging wall effect” was significant. As the ground motion intensity increased, the “hanging wall effect” of the pile foundation was more obvious. Combined with the fundamental frequency response and the test phenomenon, when ground motions intensity was strong, cracks appeared near the joint of pile top and platform, soil interface, and bedrock surface. When building a bridge pile foundation near the fault, the seismic design of the pile foundation on the hanging wall of the fault is mainly considered.


2019 ◽  
Vol 2019 ◽  
pp. 1-16 ◽  
Author(s):  
Yunxiu Dong ◽  
Zhongju Feng ◽  
Jingbin He ◽  
Huiyun Chen ◽  
Guan Jiang ◽  
...  

Puqian Bridge is located in a quake-prone area in an 8-degree seismic fortification intensity zone, and the design of the peak ground motion is the highest grade worldwide. Nevertheless, the seismic design of the pile foundation has not been evaluated with regard to earthquake damage and the seismic issues of the pile foundation are particularly noticeable. We conducted a large-scale shaking table test (STT) to determine the dynamic characteristic of the bridge pile foundation. An artificial mass model was used to determine the mechanism of the bridge pile-soil interaction, and the peak ground acceleration range of 0.15 g–0.60 g (g is gravity acceleration) was selected as the input seismic intensity. The results indicated that the peak acceleration decreased from the top to the bottom of the bridge pile and the acceleration amplification factor decreased with the increase in seismic intensity. When the seismic intensity is greater than 0.50 g, the acceleration amplification factor at the top of the pile stabilizes at 1.32. The bedrock surface had a relatively small influence on the amplification of the seismic wave, whereas the overburden had a marked influence on the amplification of the seismic wave and filtering effect. Damage to the pile foundation was observed at 0.50 g seismic intensity. When the seismic intensity was greater than 0.50 g, the fundamental frequency of the pile foundation decreased slowly and tended to stabilize at 0.87 Hz. The bending moment was larger at the junction of the pile and cap, the soft-hard soil interface, and the bedrock surface, where cracks easily occurred. These positions should be focused on during the design of pile foundations in meizoseismal areas.


2012 ◽  
Vol 52 (6) ◽  
pp. 1043-1061 ◽  
Author(s):  
Xiaohua Bao ◽  
Yukihiro Morikawa ◽  
Yoshimitsu Kondo ◽  
Keisuke Nakamura ◽  
Feng Zhang

2021 ◽  
Vol 2021 ◽  
pp. 1-19
Author(s):  
Honggang Wu ◽  
Hao Lei ◽  
Tianwen Lai

This paper presents the seismic dynamic response and spectrum characteristics of an orthogonal overlapped tunnel by shaking table tests. First, a prototype of the engineering and shaking table test device, which was used to design details of the experiment, was developed. Then, the sensors used in the test were selected, and the measurement points were arranged. Subsequently, the Wenchuan seismic wave with horizontal direction in different peak ground accelerations was inputted into the model, followed by a short analysis of the seismic response of the overlapped tunnel in the shaking table test as well as the distribution of the peak acceleration. Throughout the studies, the model exhibited obvious deformation stages during the seismic wave loading process, which can be divided into elastic, plastic, plastic enhancement, and failure stage. In particular, the time- and frequency-domain characteristics of the key parts of the tunnel were discussed in detail by using the continuous wavelet transform (CWT) based on the Morlet wavelet as the basis function. We found that the acceleration response was more intense within 25–60 s after the seismic wave was inputted. Furthermore, owing to “the superposition effect,” the seismic response at the crown of the under-crossing tunnel was stronger than that at the invert of the upper-span tunnel. The low and medium frequencies in the transformation of small scales (5–20) significantly affected the overlapped tunnel. These results elucidate the seismic dynamic response of the overlapped tunnel and provide guidance for the design of stabilizing structures for reinforcing tunnels against earthquakes.


2021 ◽  
Vol 2 (2) ◽  
Author(s):  
Kan Han ◽  
Chunxiao Xue

In order to reduce the damage of liquefaction of aeolian sand along the Sichuan-Tibet railway, the dynamic response characteristics of saturated aeolian sand in the study area were discussed by using shaking table test. The results show that the macroscopic characteristics of saturated aeolian sand in the study area are subsidence, water flow and fracture. The displacement time history shows that the surface displacement increases with increasing the input ground motion acceleration. When the acceleration is small (0.1g), the vibration in the soil layer has an obvious tendency to enlarge continuously from bottom to top. With the increase of the acceleration (0.2g), the amplification trend basically disappeared. When the acceleration increases to 0.3g, the ground motion increases first and then decreases.


Sign in / Sign up

Export Citation Format

Share Document