Design of Dual-Power Supply Automatic Switching Device without Disturbance

2013 ◽  
Vol 394 ◽  
pp. 284-288
Author(s):  
Zhi Qiang Du ◽  
Xiao Fei Zhang ◽  
Tong Fang Ma ◽  
Li Juan Feng
Keyword(s):  
Power Supply ◽  
Power Supply System ◽  
Reactive Power ◽  
Voltage Drop ◽  
Voltage Fluctuations ◽  
Switching Device ◽  
Instantaneous Reactive Power Theory ◽  
Instantaneous Switching ◽  
Automatic Switching ◽  
Dual Power

The dual power supply system is widely used in our daily life. When power instantaneously switched between the main power and the stand-by power supply, the voltage fluctuations had the varying degree influence on machines. Based on the principle of correlation coefficient of two waveforms and instantaneous reactive power theory, the dual-power supply automatic and instantaneous switching device without disturbance is provided in this paper. The equipment could identify and isolate the broken-down power source in 5ms. At the same time, power supply keeps continuous meeting the requirements of power quality without voltage drop.

scholarly journals MODERN METHODS OF REACTIVE POWER COMPENSATION IN PETROCHEMICAL PRODUCTION

2022 ◽  
Vol 1 (15) ◽  
pp. 22-28
Author(s):  
Igor' Golovanov ◽  
Alena Alekseeva ◽  
Vladimir Proskuryakov ◽  
Roman Samchuk
Keyword(s):  
Power Supply ◽  
Power Supply System ◽  
Reactive Power ◽  
Reactive Power Compensation ◽  
Supply System ◽  
Petrochemical Production ◽  
Oil Refineries ◽  
Compensation Systems ◽  
Thyristor Control ◽  
Control Circuits

Electrical circuits of reactive power compensation on the basis of thyristor control circuits in the power supply system of oil refineries are considered. The main advantages, advantages over traditional reactive power compensation systems and directions of introduction into the power supply system of modern production are formulated.

scholarly journals Development and simulation of the Institute of ionosphere measuring complex energy consumption

2020 ◽  
Vol 2 (58) ◽  
pp. 28-32
Author(s):  
A. Gapon ◽  
O. Grib ◽  
S. Kozlov ◽  
O. Yevseienko ◽  
O. Levon
Keyword(s):  
Energy Consumption ◽  
Power Supply ◽  
Power Supply System ◽  
Reactive Power ◽  
Supply System ◽  
Stable Operation ◽  
Ministry Of Education ◽  
National Academy Of Sciences ◽  
Measuring Complex ◽  
Consumption System

The work is devoted to solving an urgent problem - the development of a computer model of the energy consumption system of the Institute of the ionosphere of the National Academy of Sciences and the Ministry of Education and Science of Ukraine in order to solve the problem of increasing the energy efficiency of the measuring complex. The power supply system of the complex is described, a generalized structural diagram of the loads - powerful consumers of electricity is presented. The graphs characterizing the energy consumption of individual powerful loads are presented, the problem of compensating the reactive power of loads is shown. The adequacy of the developed model is confirmed by the coincidence of the shape and values of the experimentally obtained characteristics on loads with the characteristics of the model. The model adequacy was assessed by the variance of feedback deviations from the system mean. The results obtained confirmed the possibility of using the developed Matlab-model of the energy consumption system of the measuring complex for creating and testing on the model of an energy-efficient power supply system, which will ensure the stable operation of scientific equipment for the implementation of research programs of the NAS of Ukraine.

Research on the SVC Auto-Compensating Method Based on the Variable Reactor

2013 ◽  
Vol 321-324 ◽  
pp. 1414-1417 ◽  
Author(s):  
Jing Chen ◽  
Qi Jian Cheng ◽  
You Xin Yuan ◽  
Wei Yang
Keyword(s):  
Working Conditions ◽  
Power Supply ◽  
Power Supply System ◽  
Reactive Power ◽  
Theoretical Foundation ◽  
Industrial Applications ◽  
Reactive Power Compensation ◽  
Supply System ◽  
Compensation Method ◽  
Secondary Side

The objective of this work is to research on a SVC auto-compensation method to improve the power factor of the power supply system. Firstly, the principles of the reactive power compensation of FC+TCR are analyzed qualitatively. According to the deficiencies of this compensator, a novel SVC auto-compensating method based on the variable reactor is presented. The reactor controlled by anti-parallel thyristors is namely as the variable reactor in this method. The secondary-side equivalent inductance of the variable reactor is varied by adjusting the SCR firing angles. And then, the equivalent inductance of the variable reactor of the compensator branch is adjusted indirectly for compensating the corresponding reactive power after the working conditions of the load are changed. Therefore, the auto-compensating of this var compensator is realized. The auto-compensating principles of this compensator have been analyzed, and a research on the compensating parameters of this compensator is given emphatically in this paper. Finally, the essential operation steps of this SVC compensation method are given. The research of this paper has laid a theoretical foundation for this compensator in industrial applications.

Comparative Study and Analysis of the Capacity of TCR Type SVC and Chain SVG to Suppress Transient Voltage Drop

2014 ◽  
Vol 651-653 ◽  
pp. 1033-1036
Author(s):  
Hui Hao ◽  
Jin Ning Shan ◽  
Qing Ye ◽  
Xin Liang Bu ◽  
Meng Nan Wang ◽  
...  
Keyword(s):  
High Speed ◽  
Reactive Power ◽  
Electronic Device ◽  
Voltage Drop ◽  
Response Speed ◽  
Power Electronic ◽  
Instantaneous Reactive Power Theory ◽  
Transformation Ratio ◽  
Transient Voltage ◽  
Short Time

Traditional voltage regulating means, for example, change the transformation ratio of on-load tap-changing transformer, switch on/off parallel compensation capacitor etc, could not solve transient voltage drop effectively due to slow response speed and inaccurate control. SVC and SVG adopt power electronic device that may be turned on/off at high speed and instantaneous reactive power theory, could output huge reactive power within very short time smoothly, so they are capable to suppress transient voltage drop.This paper analyzes the principles of SVC and SVG to suppress transient voltage drop theoretically, studies their characteristics in this respect through simulation, puts forward precautions for both devices to further suppress transient voltage drop according to the simulation result.

scholarly journals An Efficient Hybrid AC Metro Power Supply System Integrating PV With Grid

2019 ◽  
pp. 314-321
Author(s):  
J. Prince Joshua Gladson ◽  
A. Ravielango
Keyword(s):  
Power Supply ◽  
Power Supply System ◽  
Reactive Power ◽  
Control Method ◽  
Electrical Energy ◽  
Supply System ◽  
Urban Rail Transit ◽  
Traction Power Supply System ◽  
Traction Power Supply ◽  
Photovoltaic Plants

Metro is integral to the urban rail transit with the expansion of the city. Due to the tremendous power consuming of the traction load which is generally considered to be megawatt class, the attendant problems concerning energy-saving and emission-reduction cannot be neglected. An approach wherein the photovoltaic plants are connected into the metro traction power supply system to provide electrical energy is proposed in this paper. Given the deterioration of power quality brought about by PV connection, the photovoltaic inverter adopts output reactive power control method.

scholarly journals Swarm algorithms in dynamic optimization problem of reactive power compensation units control

2019 ◽  
Vol 9 (5) ◽  
pp. 3967
Author(s):  
V.Z Manusov ◽  
P.V. Matrenin ◽  
N. Khasanzoda
Keyword(s):  
Dynamic Optimization ◽  
Power Supply ◽  
Optimization Problem ◽  
Power Supply System ◽  
Reactive Power ◽  
Reactive Power Compensation ◽  
Supply System ◽  
Bees Algorithm ◽  
Dynamic Optimization Problem ◽  
Engineering Research

Optimization of a power supply system is one of the main directions in power engineering research. The reactive power compensation reduces active power losses in transmission lines. In general, researches devoted to allocation and control of the compensation units consider this issue as a static optimization problem. However, it is dynamic and stochastic optimization problem that requires a real-time solution. To solve the dynamic optimization NP-hard problem, it is advisable to use Swarm Intelligence. This research deals with the problem of the compensation units power control as a dynamic optimization problem, considering the possible stochastic failures of the compensation units. The Particle Swarm Optimization and the Bees Algorithm were applied to solve it to compare the effectiveness of these algorithms in the dynamic optimization of a power supply system.

Experience in Reactive Power Compensation in the Power Supply System of Industrial Facilities

2021 ◽  
pp. 110-118
Author(s):  
Elena Ivanovna Gracheva ◽  
Muhayo Islomovna Toshkhodzhaeva ◽  
Okhunbobo Saifidinovich Rakhimov ◽  
Ayubjon Jumaevich Vohidov ◽  
Ismoiljon Ilkhomovich Ismoilov
Keyword(s):  
Power Supply ◽  
Power Supply System ◽  
Reactive Power ◽  
Reactive Power Compensation ◽  
Supply System ◽  
Industrial Facilities
Sign in / Sign up

Export Citation Format

Share Document