Judgement Method for Surrounding Rock Stability of Guanjiao Tunnel Based on Catastrophe Theory

2011 ◽  
Vol 90-93 ◽  
pp. 2307-2312 ◽  
Author(s):  
Wen Jiang Li ◽  
Su Min Zhang ◽  
Xian Min Han
Keyword(s):  
Plastic Strain ◽  
Catastrophe Theory ◽  
Soft Rock ◽  
Surrounding Rock ◽  
In Situ Monitoring ◽  
Engineering Practice ◽  
Stability Of Surrounding Rock ◽  
The Stability ◽  
Rock Tunnel

The stability judgement of surrounding rock is one of the key jobs in tunnel engineering. Taking the Erlongdong fault bundle section of Guanjiao Tunnel as the background, the stability of surrounding rock during construction of soft rock tunnel was discussed preliminarily. Based on plastic strain catastrophe theory, and combining numerical results and in-situ data, the limit displacements for stability of surrounding rock were analyzed and obtained corresponding to the in-situ monitoring technology. It shows that the limit displacements obtained corresponds to engineering practice primarily. The plastic strain catastrophe theory under unloading condition provides new thought for ground stability of deep soft rock tunnel and can be good guidance and valuable reference to construction decision making and deformation managing of similar tunnels.

Application of Long Anchor in Support Optimization of Soft Rock Tunnel

2013 ◽  
Vol 368-370 ◽  
pp. 1614-1624
Author(s):  
Yang Sun ◽  
Jian Ping Chen ◽  
Wei Zheng ◽  
Li Yu
Keyword(s):  
Soft Rock ◽  
Surrounding Rock ◽  
Parameters Optimization ◽  
In Situ Monitoring ◽  
Rock Deformation ◽  
New Thought ◽  
Supporting Structure ◽  
Rock Tunnel ◽  
Surrounding Rock Deformation

supporting structure parameters optimization is always a research focus in soft rock tunnel. Combined with Youfangping tunnel in Guzhu highway, the scheme of long anchor supporting has been provided. Usually the length of systematic anchor was determined according to experience, it often not reasonable. In order to determine the length of anchor, in-situ wave velocity test and theoretical calculation was used, and with the consideration of safety and economy, the length of anchor was determined as 4.5m finally; At the same time combined with in-situ monitoring measurement, two test sections was selected, and with the comparison of the designed supporting scheme and the original strong supporting scheme, it can be found that: no matter from the sight of surrounding rock deformation, stress applied on surrounding rock or force pattern of supporting structure, the supporting form by lengthening anchor can control surrounding rock deformation more effectively, can improve the bearing capacity of surrounding rock fully and improve the effect of supporting structure. And the supporting scheme of long anchor was more reasonable than the strong supporting scheme. This long anchor supporting scheme can provided new thought to supporting design of soft rock tunnel in Guzhu highway.

scholarly journals Analysis of Surrounding Rock Creep Effect on the Long-Term Stability of Tunnel Secondary Lining

2021 ◽  
Vol 2021 ◽  
pp. 1-8
Author(s):  
Xiaoqian Zhang ◽  
Chengmin Wei ◽  
Heng Zhang
Keyword(s):  
Stress Measurement ◽  
Soft Rock ◽  
In Situ Stress ◽  
Calculation Model ◽  
Surrounding Rock ◽  
In Situ Stress Measurement ◽  
Rock Creep ◽  
Secondary Lining ◽  
Rock Tunnel

The secondary lining failure of deep buried soft rock tunnel often occurs, which is obviously related to the time factor. The formation mechanism of this phenomenon is studied in this paper. Therefore, the combination of in situ stress measurement and neural network inversion is used to analyze the distribution characteristics of in situ stress. At the same time, the creep characteristics of surrounding rock are tested in laboratory, and the key parameters are obtained. Combined with the characteristics of surrounding rock, the calculation model is established by using discrete element simulation technology and considering the joints of surrounding rock. According to the above multiple information, the stress characteristics of the secondary lining in different time periods are analyzed creatively. Finally, the method of setting arch and adding anchor bolt in key parts is proposed, and significant effect results are obtained.

scholarly journals Application of Modified Hoek–Brown Strength Criterion in Water-Rich Soft Rock Tunnel

Geofluids ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-12
Author(s):  
Xianghui Deng ◽  
Yuncai Wang ◽  
Rui Wang ◽  
Daohong Xia ◽  
Zhiqing Zhao
Keyword(s):  
Soft Rock ◽  
Strength Criterion ◽  
Surrounding Rock ◽  
Calculation Formula ◽  
Rock Stratum ◽  
Rock Stability ◽  
Deformation Limit ◽  
Disturbance Factor ◽  
The Stability ◽  
Rock Tunnel

When a tunnel is excavated in the water-rich soft rock stratum, the strength of the soft rock is greatly reduced due to the seepage of groundwater. The condition may result in engineering accidents, such as large deformation, limit invasion, and even local collapse of the tunnel. Therefore, it is very important to research the stability of the surrounding rock in the water-rich soft rock tunnel. The water-rich disturbance factor considering the seepage influence of groundwater and blasting disturbance is proposed, and the generalized Hoek–Brown strength criterion is modified on the basis of the immersion softening test of soft rock. In accordance with the classical elastic–plastic mechanics theory, the stress, strain, and displacement calculation formulas of the tunnel surrounding rock are derived. The displacement of tunnel surrounding rock is analyzed using the derived formula and the modified Hoek–Brown strength criterion and then compared with the measured value. Results show that the displacement of surrounding rock, which is calculated by modified Hoek–Brown strength criterion considering water-rich disturbance factor and the displacement calculation formula, is close to the measured deformation of surrounding rock in water-rich soft rock tunnel, and the error is small. Therefore, the modified Hoek–Brown strength criterion can be applied to the water-rich soft rock tunnel, and the derived displacement calculation formula can accurately calculate the deformation of tunnel surrounding rock. It is of great significance to the study of surrounding rock stability of water-rich soft rock tunnel.

scholarly journals In Situ Needle Penetration Test and Its Application in a Sericite Schist Railway Tunnel, Southwest of China

Lithosphere ◽  
2021 ◽  
Vol 2021 (Special 4) ◽  
Author(s):  
Jiaxing Dong ◽  
Runxue Yang ◽  
Chenggang Guo ◽  
Meiqian Wang ◽  
Yonghong Wu ◽  
...  
Keyword(s):  
Large Deformation ◽  
Soft Rock ◽  
Reference Value ◽  
Surrounding Rock ◽  
Mechanical Parameters ◽  
Penetration Index ◽  
Needle Penetration ◽  
Joint Direction ◽  
Rock Tunnel

Abstract The sericite schist is a typical metamorphic soft rock. Large deformation of surrounding rock often occurs in the construction of a tunnel in this stratum. Due to the broken rock mass structure and poor mechanical strength in Baishitou tunnel project of Dalin line of Southwest railway, it is impossible to prepare standard samples for a traditional rock mechanical test. Therefore, we chose penetrometer (SH-70) for an in situ test. Firstly, we monitored the deformation of typical sections and analyzed the characteristics of large deformation of soft rock in the tunnel. Secondly, we tested the needle penetration index of fresh excavation face and side wall. Then, we estimated some mechanical parameters of sericite schist by a needle penetrometer and Hoek-brown criterion and discussed the acquisition of mechanical parameters of soft rock. The results show the following: (1) the characteristics of extrusion rock tunnel are summarized as large deformation, fast deformation rate, and obvious construction disturbance. (2) The reference value of penetration index of sericite schist (the vertical joint direction) is 3.90~7.77 N/mm, and the parallel joint direction is 1.27~2.99 N/mm. (3) The uniaxial compressive strength estimated by a penetrometer is 0.78~8.53 MPa, and the strength of the surrounding rock is negatively correlated with the amount of deformation. Therefore, it can be considered that the insufficient strength of surrounding rock is the fundamental reason for large deformation. (4) The reference value of cohesion of sericite schist estimated by a penetrometer is 0.203 MPa, and the reference value of internal friction angle is 18.224°. Compared with the common estimation methods, the penetrometer is more convenient and economical, which can provide a new idea for obtaining the mechanical parameters of sericite schist soft rock tunnel.

Hydro-Mechanical Coupled Analysis of the Stability of Surrounding Rock Mass of Underground Water-Sealed Oil Storage

2013 ◽  
Vol 405-408 ◽  
pp. 402-405 ◽  
Author(s):  
Yun Jie Zhang ◽  
Tao Xu ◽  
Qiang Xu ◽  
Lin Bu
Keyword(s):  
Rock Mass ◽  
Underground Water ◽  
Surrounding Rock ◽  
Comsol Multiphysics ◽  
Coupled Analysis ◽  
Coupling Theory ◽  
Oil Storage ◽  
Stability Of Surrounding Rock ◽  
Straight Wall ◽  
The Stability

Based on the fluid-solid coupling theory, we study the stability of surrounding rock mass around underground oil storage in Huangdao, Shandong province, analyze the stress of the surrounding rock mass around three chambers and the displacement change of several key monitoring points after excavation and evaluate the stability of surrounding rock mass using COMSOL Multiphysics software. Research results show that the stress at both sides of the straight wall of cavern increases, especially obvious stress concentration forms at the corners of the cavern, and the surrounding rock mass moves towards the cavern after excavation. The stress and displacement of the surrounding rock mass will increase accordingly after setting the water curtains, but the change does not have a substantive impact on the stability of surrounding rock mass.

scholarly journals Analysis of suspension bridge tunnel-type anchorage construction on the stability of surrounding rock

2020 ◽  
Vol 198 ◽  
pp. 02006
Author(s):  
Nana Li ◽  
Yongqiang Zhou ◽  
Yanqiang Zhao ◽  
Guiju Li
Keyword(s):  
Suspension Bridge ◽  
Surrounding Rock ◽  
Construction Process ◽  
Analysis Model ◽  
Stability Of Surrounding Rock ◽  
Numerical Software ◽  
Left And Right ◽  
Simulation Results ◽  
The Stability ◽  
The Right

In order to study the interaction between the left and right tunnels of suspension bridge tunnel-type anchorage, the finite difference numerical software is used to analyze the mechanical properties of the surrounding rock during the construction process. A numerical analysis model based on FLAC3D is established to analyze the stress, displacement and plastic zone changes of the surrounding rock of right tunnel anchor cavern during the construction of left tunnel anchor cavern. The right tunnel anchor cavern is excavated firstly, and then the left tunnel anchor cavern is excavated. The numerical simulation results show that the main displacement of the right tunnel occurs in the construction stage of the anchor plug body and the rear anchor cavern of the left tunnel. During the excavation of the left tunnel, the plastic zones of the left and right tunnel anchor caverns are only connected above the middle of the waist wall. Therefore, it is suggested that during the construction process, especially in the excavation stage of the anchor plug body and the rear anchor cavern, the area above the middle of the tunnel waist wall should be strengthened in time to ensure the construction safety.

scholarly journals Analysis on Loose Circle of Surrounding Rock of Large Deformation Soft-Rock Tunnel

2020 ◽  
Vol 2020 ◽  
pp. 1-11
Author(s):  
Rui Wang ◽  
Yiyuan Liu ◽  
Xianghui Deng ◽  
Yu Zhang ◽  
Xiaodong Huang ◽  
...  
Keyword(s):  
Large Deformation ◽  
Theoretical Calculations ◽  
Rapid Development ◽  
Field Tests ◽  
Soft Rock ◽  
Strength Criterion ◽  
Surrounding Rock ◽  
Distribution Law ◽  
Geological Conditions ◽  
Rock Tunnel

With the rapid development of tunnel construction in China, deep buried and long tunnel projects are emerging in areas with complex engineering geological conditions and harsh environment, and thus large deformation of tunnels under conditions of high in situ stress and soft rock becomes increasingly prominent and endangers engineering safety. Therefore, it is of great significance to control the deformation and improve the stability of surrounding rock by analyzing the thickness and distribution law of loose circle according to the unique mechanical properties and failure mechanism of surrounding rock of large deformation soft-rock tunnel. Based on unified strength theory, this paper deduces the radius calculation formula of the loose circle by considering the influence of intermediate principal stress. Furthermore, the theoretical calculations and field tests of the loose circle in the typical sections of grade II and III deformation of Yuntunbao tunnel are carried out, and the thickness and distribution law of loose circle of surrounding rock of large deformation soft-rock tunnel is revealed. The results show that the formula based on the unified strength criterion is applicable for a large deformation tunnel in soft rock.

Sign in / Sign up

Export Citation Format

Share Document