Seismic Vulnerability Analysis of Mid-Story Isolation and Reduction Structures Based Stochastic Vibration

2011 ◽  
Vol 243-249 ◽  
pp. 3988-3991 ◽  
Author(s):  
Pei Ju Chang ◽  
Jian Zhu
Keyword(s):  
Ground Motion ◽  
Random Sample ◽  
Seismic Vulnerability ◽  
Fragility Curves ◽  
Response Spectrum ◽  
Time History ◽  
Time History Analysis ◽  
Good Effect ◽  
History Analysis ◽  
Reduction Effect

This study focus on derivation of such fragility curves using classic mid-story isolation and reduction structures (MIRS) in China metropolis. A set of stochastic earthquake waves compatible with the response spectrum of China seismic code selected to represent the variability in ground motion. Dynamic inelastic time history analysis was used to analyze the random sample of structures. The result reveal that good effect for superstructure and reduction effect for substructure of MIRS is favorable and obvious under major earthquake, Weak position of MIRS was be pointed out and fragility curves of typical MIRS of China was obtained finally.

Seismic Vulnerability Analysis of Reinforced Concrete Frames with Mild Steel Dampers

2011 ◽  
Vol 368-373 ◽  
pp. 1526-1530 ◽  
Author(s):  
Jian Zhu ◽  
Ping Tan
Keyword(s):  
Reinforced Concrete ◽  
Mild Steel ◽  
Seismic Vulnerability ◽  
Fragility Curves ◽  
Response Spectrum ◽  
Time History ◽  
Concrete Frames ◽  
Rc Frames ◽  
History Analysis ◽  
Reduction Effect

This study focus on derivation of such fragility curves using conventional old reinforced concrete (RC) frames with Mild Steel Damper (MSD) of flexural energy dissipation braces. A set of stochastic earthquake waves compatible with the response spectrum of China seismic code selected to represent the variability in ground motion. Dynamic inelastic time history analysis was used to analyze the random sample of structures. Weak position was be pointed out, The result reveal that excellent reduction effect for structure of MSD is favorable and obvious under major earthquake.

Building Seismic Vulnerability Study for China High Rises

2013 ◽  
Vol 353-356 ◽  
pp. 2301-2304
Author(s):  
Fan Wu ◽  
Ming Wang ◽  
Xin Yuan Yang
Keyword(s):  
Ground Motion ◽  
Structural Damage ◽  
Seismic Vulnerability ◽  
Fragility Curves ◽  
Response Spectrum ◽  
Earthquake Ground Motion ◽  
Published Data ◽  
Rapid Urbanization ◽  
High Rise ◽  
Story Drift

High-rise buildings, as a result of rapid urbanization in China, become one of popular structure kind. However, there have been few seismic vulnerability studies on high-rise buildings, and few fragility curves have been developed for the buildings. Based on the published data of more than 50 high rises and super high rises, the structural information such as building heights, mode periods, locations and sites, the maximum design story drift ratios, are collected and analyzed. The vulnerability analysis for high rises uses response spectrum displacement as seismic ground motion input, since the structures have comparatively long natural period. Using statistics and regression analysis, the relationship between the maximum story drift ratio and response spectrum displacement is established. Based on height groups and earthquake design codes, the fragility curves of different performance levels can be developed. These curves can provide good loss estimation of high rise structural damage under earthquake ground motion.

Direct Displacement Procedure for Performance-Based Seismic Design of Mid-Rise Wood-Framed Structures

2009 ◽  
Vol 25 (3) ◽  
pp. 583-605 ◽  
Author(s):  
Wei Chiang Pang ◽  
David V. Rosowsky
Keyword(s):  
Seismic Design ◽  
Response Spectrum ◽  
Design Procedure ◽  
Time History ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
Framed Structures ◽  
History Analysis ◽  
Performance Based Seismic Design ◽  
Nonlinear Time History

This paper presents a direct displacement design (DDD) procedure that can be used for seismic design of multistory wood-framed structures. The proposed procedure is applicable to any pure shear deforming system. The design procedure is a promising design tool for performance-based seismic design since it allows consideration of multiple performance objectives (e.g., damage limitation, safety requirements) without requiring the engineer to perform a complex finite element or nonlinear time-history analysis of the complete structure. A simple procedure based on normalized modal analysis is used to convert the code-specified acceleration response spectrum into a set of interstory drift spectra. These spectra can be used to determine the minimum stiffness required for each floor based on the drift limit requirements. Specific shear walls can then be directly selected from a database of backbone curves. The procedure is illustrated on the design of two three-story ATC-63 archetype buildings, and the results are validated using nonlinear time-history analysis.

Study on Seismic Performance of Reinforced Concrete Masonry High-Rise Building

2012 ◽  
Vol 166-169 ◽  
pp. 2164-2170
Author(s):  
Xu Jie Sun ◽  
Hou Zhang ◽  
Da Gang Lu ◽  
Feng Lai Wang
Keyword(s):  
Reinforced Concrete ◽  
Response Spectrum ◽  
Pushover Analysis ◽  
Time History ◽  
Time History Analysis ◽  
Masonry Building ◽  
Analysis Method ◽  
Concrete Masonry ◽  
History Analysis ◽  
Earthquake Action

The design process of the 100 m high reinforced concrete masonry building in China was firstly presented, deformation check calculation under earthquake action by mode-superposition response spectrum method and time-history analysis method were detailed and deformation under wind load was also checked. Then elastic-plastic deformation under earthquake action was checked by time-history analysis method and pushover analysis method with both under uniform load and reverse triangle load. The conclusion is construct 100 m high office building built in Fortification intensity 6 by reinforced concrete masonry is feasible. Then the building was redesigned as built in fortification 7, the same check was performed as that have been done in fortification 6, it is feasible too.

Passive Control of Seismic Response of Piping Systems

2005 ◽  
Vol 128 (3) ◽  
pp. 364-369 ◽  
Author(s):  
Y. M. Parulekar ◽  
G. R. Reddy ◽  
K. K. Vaze ◽  
K. Muthumani
Keyword(s):  
Passive Control ◽  
Response Spectrum ◽  
Time History ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
Equivalent Linearization ◽  
Piping System ◽  
Equivalent Damping ◽  
History Analysis ◽  
Piping Systems

Passive energy dissipating devices, such as elastoplastic dampers (EPDs) can be used for eliminating snubbers and reducing the response of piping systems subjected to seismic loads. Cantilever and three-dimensional piping systems were tested with and without EPD on shaker table. Using a finite element model of the piping systems, linear and nonlinear time-history analysis is carried out using Newmark’s time integration technique. Equivalent linearization technique, such as Caughey method, is used to evaluate the equivalent damping of the piping systems supported on elastoplastic damper. An iterative response spectrum method is used for evaluating response of the piping system using this equivalent damping. The analytical maximum response displacement obtained at the elastoplastic damper support for the two piping systems is compared with experimental values and time history analysis values. It has been concluded that the iterative response spectrum technique using Caughey equivalent damping is simple and results in reasonably acceptable response of the piping systems supported on EPD.

The Comparative Analysis on Calculation Methods of Vertical Seismic Response to Suspended-Dome Structure

2013 ◽  
Vol 351-352 ◽  
pp. 849-853
Author(s):  
Lan Chen ◽  
De Long Lu ◽  
Xiao Gang Yin
Keyword(s):  
Response Spectrum ◽  
Time History ◽  
Seismic Effect ◽  
Time History Analysis ◽  
Vertical Acceleration ◽  
Analysis Method ◽  
Calculation Methods ◽  
Acceleration Response ◽  
History Analysis ◽  
Acceleration Response Spectrum

Based on the vertical seismic information, the vertical seismic response spectrum was calculated by Matlab Lsim function. The seismic effect of Kiewitt-Lamella suspended-dome was measured by dynamic to static ratio. According to the EL-Centro seismic wave, it analyzed and compared the dynamic to static ratios which were calculated by the following four vertical seismic calculation methods respectively: the simplified method of specification, the mode-superposition response spectrum methods based on the horizontal earthquake affecting coefficients and the vertical acceleration response spectrum respectively, and the time history analysis method. Analysis shows that: For the seismic effect, the time history analysis method is larger than the other three methods, and the method based on the vertical acceleration response spectrum is closer to the time history analysis method. Owing to large difference of the four methods for seismic effect, various methods should be adopted to ensure the safety of vertical seismic design.

Seismic Fragility Analysis of Mid-Story Isolation and Reduction Structures Based Two Directions

2013 ◽  
Vol 739 ◽  
pp. 309-313 ◽  
Author(s):  
Pei Ju Chang
Keyword(s):  
Fragility Curves ◽  
Response Spectrum ◽  
Time History ◽  
Longitudinal Axis ◽  
Seismic Intensity ◽  
Seismic Fragility ◽  
Infill Wall ◽  
Intensity Index ◽  
History Analysis ◽  
Masonry Infill Wall

This study focus on derivation of such fragility curves using classic mid-story isolation and reduction structures (MIRS) in China metropolis. This study focus on derivation of such fragility curves using conventional industrial frames with masonry infill wall. A set of stochastic earthquake waves compatible with the response spectrum of China seismic code selected to represent the variability in ground motion. Dynamic inelastic time history analysis was used to analyze the random sample of structures. MIRS seismic capability of longitudinal and transversal orientation is different. Stochastic damage scatter diagrams based different seismic intensity index are obtained. Seismic fragility of longitudinal axis (Y axis) is larger than transversal axis (X axis) of frames under major earthquake obviously.

Seismic Response Spectrum in Lieu of Time History Analysis for Subsea Structure Design

2017 ◽  
Author(s):  
George Wang ◽  
Michelle Loh ◽  
Yen-Tun Peng ◽  
Joanne Shen ◽  
P. E. Genesis ◽  
...  
Keyword(s):  
Seismic Response ◽  
Response Spectrum ◽  
Time History ◽  
Time History Analysis ◽  
Structure Design ◽  
History Analysis
Sign in / Sign up

Export Citation Format

Share Document