Preparation and Characterization of Magnetic Coal-Based Activated Carbon in the Presence of Fe3O4

2011 ◽  
Vol 393-395 ◽  
pp. 1355-1358 ◽  
Author(s):  
Jun Zhang
Keyword(s):  
Magnetic Properties ◽  
Activated Carbon ◽  
Surface Area ◽  
Pore Volume ◽  
High Surface ◽  
High Surface Area ◽  
Vibrating Sample Magnetometer ◽  
N2 Adsorption ◽  
Magnetic Activated Carbon

Magnetic coal-based activated carbon was prepared from Taixi anthracitic coal in the presence of magnetite (Fe3O4). The magnetic activated carbon samples were characterized by N2 adsorption, XRD, FTIR and vibrating sample magnetometer (VSM). It was found that the magnetic activated carbon had a high surface area of 993.5 m2/g with 4% Fe3O4 and a saturation magnetization of 2.4158 emu/g for magnetic separability. The results showed that the magnetic properties of MAC are provided by Fe3O4 and Fe. In the presence of Fe3O4, the rate of carbonization and activation increase to form a large surface area and a high pore volume. Moreover, the addition of Fe3O4 can greatly promote the number of both micro-pores and meso-pores in activated carbon.

scholarly journals Preparation and characterization of activated carbons from albizia saman pod

2017 ◽  
Vol 36 (3) ◽  
pp. 44-53
Author(s):  
G. D. Akpen ◽  
M. I. Aho ◽  
N. Baba
Keyword(s):  
Activated Carbon ◽  
Surface Area ◽  
Activated Carbons ◽  
High Surface ◽  
High Surface Area ◽  
Volatile Matter ◽  
Sieve Analysis ◽  
Albizia Saman ◽  
Temperature Surface

Activated carbon was prepared from the pods of Albizia saman for the purpose of converting the waste to wealth. The pods were thoroughly washed with water to remove any dirt, air- dried and cut into sizes of 2-4 cm. The prepared pods were then carbonised in a muffle furnace at temperatures of 4000C, 5000C, 6000C ,7000C and 8000C for 30 minutes. The same procedure was repeated for 60, 90, 120 and 150 minutes respectively. Activation was done using impregnationratios of 1:12, 1:6, 1:4, 1:3, and 1:2 respectively of ZnCl2 to carbonised Albizia saman pods by weight. The activated carbon was then dried in an oven at 1050C before crushing for sieve analysis. The following properties of the produced Albizia saman pod activated carbon (ASPAC) were determined: bulk density, carbon yield, surface area and ash, volatile matter and moisture contents. The highest surface area of 1479.29 m2/g was obtained at the optimum impregnation ratio, carbonization time and temperature of 1:6, 60 minutes and 5000C respectively. It was recommended that activated carbon should be prepared from Albizia saman pod with high potential for adsorption of pollutants given the high surface area obtained.Keywords: Albizia saman pod, activated carbon, carbonization, temperature, surface area

Effect of Activating Agent on the Preparation of Bamboo-Based High Surface Area Activated Carbon by Microwave Heating

2016 ◽  
Vol 35 (6) ◽  
pp. 535-541 ◽  
Author(s):  
Hongying Xia ◽  
Jian Wu ◽  
Chandrasekar Srinivasakannan ◽  
Jinhui Peng ◽  
Libo Zhang
Keyword(s):  
Activated Carbon ◽  
Microwave Heating ◽  
Surface Area ◽  
Pore Volume ◽  
Activated Carbons ◽  
High Surface ◽  
High Surface Area ◽  
Significant Proportion ◽  
Mixture Ratio ◽  
Activating Agent

AbstractThe present work attempts to convert bamboo into a high surface area activated carbon via microwave heating. Different chemical activating agents such as KOH, NaOH, K2CO3 and Na2CO3 were utilized to identify a most suitable activating agent. Among the activating agents tested KOH was found to generate carbon with the highest porosity and surface area. The effect of KOH/C ratio on the porous nature of the activated carbon has been assessed. An optimal KOH/C ratio of 4 was identified, beyond which the surface area as well as the pore volume were found to decrease. At the optimized KOH/C ratio the surface area and the pore volume were estimated to be 3,441 m2/g and 2.093 ml/g, respectively, with the significant proportion of which being microporous (62.3%). Activated carbon prepared under the optimum conditions was further characterized using Fourier transform infrared spectroscopy (FTIR) and scanning electron microscope (SEM). Activated carbons with so high surface area and pore volume are very rarely reported, which could be owed to the nature of the precursor and the optimal conditions of mixture ratio adopted in the present work.

Chromium Removal from Industrial Water Through Functionallized Nanoparticles

2008 ◽  
Vol 8 (11) ◽  
pp. 5733-5738 ◽  
Author(s):  
Xicoténcatl López ◽  
Victor M. Castaño
Keyword(s):  
Activated Carbon ◽  
Surface Area ◽  
Surface Functionalization ◽  
High Surface ◽  
High Surface Area ◽  
Chromium Removal ◽  
Industrial Water ◽  
Hazardous Metal ◽  
High Surface Area Materials

Cr ion-polluted industrial water was treated with commercial activated carbon and with either mercaptane- and amine-functionallized silica nanoparticles, revealing that the use of relatively low surface area materials can advantageously compete with high surface area materials, traditionally utilized for removing hazardous metal ions, provided a proper surface functionalization of the nanoparticles is in place. FTIR and SEM characterization of the different materials and stages of the experiments are provided, as well.

scholarly journals Karakteristik luas permukaan karbon aktif dari ampas tebu dengan aktivasi kimia

2018 ◽  
Vol 10 (3) ◽  
pp. 149
Author(s):  
Mahmud Sudibandriyo ◽  
L Lydia
Keyword(s):  
Activated Carbon ◽  
Surface Area ◽  
Sugarcane Bagasse ◽  
Chemical Activation ◽  
High Surface ◽  
High Surface Area ◽  
Physical Activation ◽  
Mass Ratio ◽  
Characterization Of Activated Carbon

Surface area characterization of activated carbon from sugarcane baggase by chemical activationAdsorption is one the process with many applications in the industries such as in a separation or in gas storage. In this adsorption, adsorbent selection is the most important thing. One of the adsorbent most suitable for this process is activated carbon. Previous studies show that high surface area of activated carbon can be produced from sugarcane bagasse using activator ZnCl2. The research’s goal is to produce activated carbon from sugarcane bagasse and determine the effects of activator on the surface area of activated carbon produced. Activators used in this research are KOH and ZnCl2 with the mass ratio of activator/carbon are 1/1, 2/1 and 3/1. The results show that The highest surface area, 938,2 m2/g, is obtained by activation using KOH with mass ratio of activator/carbon 3/1, whereas the highest surface area by activation using ZnCl2 is 632 m2/g with mass ratio of activator/carbon 2/1. For comparison, preparation of activated carbon by physical activation is also done and the surface area is 293 m2/g.Keywords: Activated carbon, chemical activation, sugarcane bagasse, KOH, ZnCl2 Abstrak Adsorpsi merupakan salah satu proses yang banyak digunakan dalam industri baik dalam pemisahan maupun untuk penyimpanan gas. Pada proses adsorpsi ini, pemilihan adsorben merupakan hal yang sangat penting. Salah satu jenis adsorben yang sangat cocok untuk proses ini adalah karbon aktif. Penelusuran studi sebelumnya menunjukkan bahwa karbon aktif dengan luas permukaan yang cukup tinggi dapat dibuat dari ampas tebu dengan menggunakan aktivator ZnCl2. Penelitian ini bertujuan untuk menghasilkan karbon aktif dari ampas tebu dengan aktivasi kimia serta mengetahui pengaruh aktivator terhadap luas permukaan karbon aktif yang dihasilkan. Aktivator yang digunakan dalam penelitian ini adalah KOH dan ZnCl2 dengan rasio massa aktivator/massa karbon 1/1, 2/1, dan 3/1. Aktivasi dilakukan pada temperatur 700 oC selama 1 jam. Hasil penelitian menunjukkan bahwa luas permukaan tertinggi sebesar 938,2 m2/g diperoleh dengan aktivasi menggunakan KOH dengan rasio massa aktivator/massa arang 3/1, sedangkan aktivasi dengan menggunakan ZnCl2 diperoleh luas permukaan tertinggi sebesar 632 m2/g dengan rasio massa aktivator/massa arang 2/1. Sebagai pembanding, pada penelitian ini juga dilakukan pembuatan karbon aktif dengan metode aktivasi fisika dan diperoleh luas permukaan karbon aktif sebesar 293 m2/g.Kata kunci: Aktivasi kimia, ampas tebu, karbon aktif, KOH, ZnCl2

scholarly journals Synthesis and Characterization of Calcium Derivative Combined with High-Surface-Area Activated Carbon Composites for Fine Toxic Gas Removal

2018 ◽  
Vol 55 (5) ◽  
pp. 473-479 ◽  
Author(s):  
Yonrapach Areerob ◽  
Dinh Cung Tien Nguyen ◽  
Biswas Md Rokon Dowla ◽  
Hyuk Kim ◽  
Je-Woo Cha ◽  
...  
Keyword(s):  
Activated Carbon ◽  
Surface Area ◽  
High Surface ◽  
High Surface Area ◽  
Synthesis And Characterization ◽  
Carbon Composites ◽  
Gas Removal ◽  
Toxic Gas
Sign in / Sign up

Export Citation Format

Share Document