Design of the Half-Bridge Switching and Regulated Power Supply Based on PWM

2012 ◽  
Vol 546-547 ◽  
pp. 352-356
Author(s):  
Jian Wei Liang ◽  
Yin Feng Wu ◽  
Ling Liang

The article introduces the design of the half-bridge switching and regulated power supply system which is based on PWM. The design mainly consists of regulated power supply’s structure of basic hardware circuit, its working principles and the process of modeling simulation and software design. The control circuit controls SG3525 chip to output PWM wave through the Microprocessor Control Unit (MCU) of AT89C51 and drives IGBT through the chip of EXB841 as well. The MCU is also used to realize the keyboard process and controls of the pulse width and frequency. Taking advantage of Simulink (dynamic simulation Toolbox) and SimPowerSysterm (power simulation Toolbox) of MATLAB, it simulates the designed regulated power supply. According to the simulation result of this design, the system has high stability and good output waveform. The operation of the design is simple and clear with less software operation and higher speed.

2019 ◽  
Vol 9 (19) ◽  
pp. 3953 ◽  
Author(s):  
Yan Chen ◽  
Chunyan Ma ◽  
Xiangnan Hou ◽  
Yinke Dou ◽  
Rui Chen

Based on the preliminary study of the distribution of wind and light resources in the Zhongshan Station of Antarctica, and the conclusion that the scenery and resources of the station area are sufficient and complementary, this paper proposes to adapt to the power supply problem of the aeroponic, stereoscopic cultivation device in the Controlled Micro-environment applied to the polar regions. The overall architecture of the power supply system is designed. Based on the STC8A8K64S4A12 single-chip microcomputer, the hardware circuit and software program of the wind and solar hybrid power supply system controller are also designed. Finally, the debugging experiment is carried out.


2014 ◽  
Vol 1030-1032 ◽  
pp. 485-488
Author(s):  
Kai Xuan Han ◽  
Shao Fei Wang

This paper presented a kind of design principle and method of the adaptive solar power supply system, and draw out the lighting system, hardware circuit and software flow charts of the system. Using MCU control solar lighting system to track the sun direction, the system collects the sun angle information through optical sensor in order to use solar energy in high efficiency. The device not only can provide reliable electric energy for the highway cameras, visibility detectors and other dispersion equipment, but has the advantages of low carbon, environmental protection, intelligence, etc.


2019 ◽  
Vol 2 (1) ◽  
pp. 8-16 ◽  
Author(s):  
P. A. Khlyupin ◽  
G. N. Ispulaeva

Introduction: The co-authors provide an overview of the main types of wind turbines and power generators installed into wind energy devices, as well as advanced technological solutions. The co-authors have identified the principal strengths and weaknesses of existing wind power generators, if applied as alternative energy sources. The co-authors have proven the need to develop an algorithm for the selection of a wind generator-based autonomous power supply system in the course of designing windmill farms in Russia. Methods: The co-authors have analyzed several types of wind turbines and power generators. Results and discussions: The algorithm for the selection of a wind generator-based autonomous power supply system is presented as a first approximation. Conclusion: The emerging algorithm enables designers to develop an effective wind generator-based autonomous power supply system.


2019 ◽  
Vol 139 (12) ◽  
pp. 810-813
Author(s):  
Katsuhiro SHIMADA ◽  
Kunihito YAMAUCHI ◽  
Shinichi MORIYAMA

2013 ◽  
Vol 133 (12) ◽  
pp. 961-966
Author(s):  
Hitoshi Hayashiya ◽  
Kazushi Matsuura ◽  
Norio Koguchi ◽  
Hiroshi Yamamoto ◽  
Tetsuo Fujita

Sign in / Sign up

Export Citation Format

Share Document