Comparison of Methods for the Sulfur Compounds and Elemental Sulfur Analysis in High-Sulfur Natural Gas

2013 ◽  
Vol 712-715 ◽  
pp. 688-700
Author(s):  
Qin Luo ◽  
Zhen Quan Tu ◽  
Zhong Li Ji ◽  
Xue Lan Xiao ◽  
Hong Gang Chang ◽  
...  

Some gas fields with high hydrogen sulfide content, such as Luojiazhai, Dukouhe and Puguang Gas Fields, are found in Northeast Sichuan. For exploring and utilizing high sulfur natural gas reservoirs, it is essential to quantificational analysis of sulfur compounds and elemental sulfur in high sulfur natural gas. Determination of hydrogen sulfide content in natural gas with a laser method has many advantages, including on-site measurement, fast response, wide application scope, high accuracy, high reliability, and low maintenance. When the hydrogen sulfide concentration is 1% to 20%, the relative deviation of the analysis value to the standard value is less than 3% with repeatability of less than 1%. Determination of sulfur compounds in natural gas by gas chromatograph with sulfur chemiluminescence detector (SCD) also has many advantages, such as it is simple, fast, accurate and free from interference of most sample matrixes. The analysis method has good repeatability with lower limit of detection. Since SCD has liner equimolar response to sulfur atom, only one reference gas mixture of sulfur compound is used as external standard calibration. Determination of total sulfur content in natural gas with oxidative microcoulometry method has good repeatability and high accuracy. Determination of elemental sulfur by liquid chromatography has repeatability better than 3%, the detection limit is 10mg/m3, and recovery rate of over 90%, and is applicable for determination of elemental sulfur content in high sulfur natural gas.

2021 ◽  
pp. 35-40
Author(s):  
Denis Y. Kutovoy ◽  
Igor A. Yatsenko ◽  
Vladimir B. Yavkin ◽  
Aydar N. Mukhametov ◽  
Petr V. Lovtsov ◽  
...  

The actual problem of the possibility of using the equations of state for the gas phase of natural gas at temperatures below 250 K is considered. To solve it, the compressibility coefficients of natural gas obtained experimentally with high accuracy are required. The technique was developed and experimental study was carried out of compressibility factor aiming expanding temperature range of the state equations GERG-2004 and AGA8-DC92. The proposed technique is based on the fact that to assess the applicability of the equation of state, it is sufficient to obtain the relative value of the compressibility coefficient and not to determine its absolute value. The technique does not require complex equipment and provides high accuracy. The technique was tested on nitrogen, argon, air and methane. Uncertainty of determination of the compressibility factor is not greater than 0.1 %. For two different compositions of natural gas, obtained experimental data were demonstrated that the equations of state GERG-2004 and AGA8-92DC provide uncertainty of the calculation of the compressibility coefficient within 0.1 % in the temperature range from 220 K to 250 K and pressure below 5 MPa.


2021 ◽  
Vol 66 (7) ◽  
pp. 396-400
Author(s):  
Irina Gennadievna Popova ◽  
O. G. Sitnikova ◽  
S. B. Nazarov ◽  
R. I. Sadov ◽  
I. A. Panova ◽  
...  

We examined 70 women who were 22-40 weeks pregnant and their newborns. Of these, 15 women with moderate PE made up group 1, 22 women with severe PE-group 2, and 55 women with uncomplicated pregnancy without hypertensive disorders - the control group. Blood was collected from women when they were admitted to the clinic, and blood was taken from newborns for 3-5 days of life. The concentration of hydrogen sulfide was determined by the method of K. Qu et al [17]. There was a decrease in the level of hydrogen sulfide in the blood serum of women whose pregnancy was complicated by severe preeclampsia. In newborns born to mothers with preeclampsia, an increase in the concentration of hydrogen sulfide was detected in the blood, which is probably a compensatory reaction aimed at restoring vascular homeostasis during early postnatal adaptation.


2014 ◽  
Vol 962-965 ◽  
pp. 736-740
Author(s):  
Feng Yan

This project carries out the research on influence factors of wells producing hydrogen sulfide in connection with the actual situation of producing hydrogen sulfide in Qi-40 steam drive process. Experimental studies have shown that: A. temperature is the main external factors of produce hydrogen sulfide, It will produce hydrogen sulfide when temperature is above 100°C, hydrogen sulfide content increase about 300ppm in average when the temperature increase per 20°C; hydrogen sulfide content will be in the greatest increase when temperature at the range of 160°C~180°C; the rate of increase in the levels of hydrogen sulfide will significantly reduce when temperature above 180 °C.B. Adding Chemical agent with surface activity can inhibit the release of hydrogen sulfide. C. Adding acid chemical agent will make the content of hydrogen sulfide increase. The experimental study also investigated hydrogen sulfide prevention measures.


Sign in / Sign up

Export Citation Format

Share Document