Head Instability Detection for Testing Process in Perpendicular Magnetic Recording System

2013 ◽  
Vol 770 ◽  
pp. 319-322 ◽  
Author(s):  
Piya Kovintavewat ◽  
Santi Koonkarnkhai ◽  
Aimamorn Suvichakorn
Keyword(s):  
Magnetic Recording ◽  
Signal To Noise Ratio ◽  
Disk Drive ◽  
Detection Algorithm ◽  
Recording System ◽  
High Signal ◽  
Signal To Noise ◽  
Perpendicular Magnetic Recording ◽  
Read Head ◽  
Pass Through

During hard disk drive (HDD) testing process, the magneto-resistive read (MR) head is analyzed and checked if the head is defective or not. Baseline popping (BLP) is one of the crucial problems caused by head instability, whose effect can distort the readback signal to the extent of causing possible sector read failure. Without BLP detection algorithm, the defective read head might pass through HDD assembling process, thus producing an unreliable HDD. This situation must be prevented so as to retain customer satisfaction. This paper proposes a simple (but efficient) BLP detection algorithm for perpendicular magnetic recording systems. Results show that the proposed algorithm outperforms the conventional one in terms of both the percentage of detection and the percentage of false alarm, when operating at high signal-to-noise ratio.

Coupled Granular/Continuous Media – Results and Challenges

MRS Advances ◽  
2017 ◽  
Vol 2 (49) ◽  
pp. 2661-2668
Author(s):  
Horia Gavrila ◽  
Doina Elena Gavrila
Keyword(s):  
Thermal Stability ◽  
Grain Size ◽  
Magnetic Recording ◽  
Granular Media ◽  
Signal To Noise Ratio ◽  
Signal To Noise ◽  
Theoretical Limit ◽  
Perpendicular Recording ◽  
Perpendicular Magnetic Recording ◽  
Longitudinal Recording

ABSTRACTWhile the most promising longitudinal recording systems cannot surpass the theoretical limit of about 200 Gb/in2 for areal recording density and the demand for higher densities is permanently increasing, the perpendicular magnetic recording constitutes the realistic issue to the longitudinal one. The perpendicular magnetic recording offers significant advantages, the most important being stronger write and read fields, and therefore the use of media of higher anisotropy, smaller grain size, higher signal-to-noise ratio, and a better thermal stability. Unfortunately, the perpendicular recording has to cope some important physical and technological difficulties. To overcome them, many ingenious solutions were proposed. In this paper the coupled granular/continuous (CGC) media, a subtle association of the continuous and, respectively, granular media, are analysed from the viewpoint of their magnetic and recording properties. The challenges and possible improvements of CGC media are discussed.

A compact guided-wave EMAT with pulsed electromagnet for ferromagnetic tube inspection

2020 ◽  
Vol 64 (1-4) ◽  
pp. 951-958
Author(s):  
Tianhao Liu ◽  
Yu Jin ◽  
Cuixiang Pei ◽  
Jie Han ◽  
Zhenmao Chen
Keyword(s):  
Power Plants ◽  
Signal To Noise Ratio ◽  
Small Diameter ◽  
Performance Testing ◽  
Guided Wave ◽  
High Signal ◽  
Receiver Coil ◽  
Signal To Noise ◽  
Corrosion Defects

Small-diameter tubes that are widely used in petroleum industries and power plants experience corrosion during long-term services. In this paper, a compact inserted guided-wave EMAT with a pulsed electromagnet is proposed for small-diameter tube inspection. The proposed transducer is noncontact, compact with high signal-to-noise ratio and unattractive to ferromagnetic tubes. The proposed EMAT is designed with coils-only configuration, which consists of a pulsed electromagnet and a meander pulser/receiver coil. Both the numerical simulation and experimental results validate its feasibility on generating and receiving L(0,2) mode guided wave. The parameters for driving the proposed EMAT are optimized by performance testing. Finally, feasibility on quantification evaluation for corrosion defects was verified by experiments.

Narrow-frequency sharp-angular filters using all-dielectric cascaded meta-gratings

Nanophotonics ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 3443-3450 ◽  
Author(s):  
Wei-Nan Liu ◽  
Rui Chen ◽  
Wei-Yi Shi ◽  
Ke-Bo Zeng ◽  
Fu-Li Zhao ◽  
...  
Keyword(s):  
Thin Film ◽  
Signal To Noise Ratio ◽  
Incident Angle ◽  
Design Strategy ◽  
Transmission Peak ◽  
High Signal ◽  
Waveguide Array ◽  
Signal To Noise ◽  
Center Wavelength ◽  
Noise Ratio

AbstractSelective transmission or filtering always responds to either frequency or incident angle, so as hardly to maximize signal-to-noise ratio in communication, detection and sensing. Here, we propose compact meta-filters of narrow-frequency sharp-angular transmission peak along with broad omnidirectional reflection sidebands, in all-dielectric cascaded subwavelength meta-gratings. The inherent collective resonance of waveguide-array modes and thin film approximation of meta-grating are employed as the design strategy. A unity transmission peak, locating at the incident angle of 44.4° and the center wavelength of 1550 nm, is demonstrated in a silicon meta-filter consisting of two-layer silicon rectangular meta-grating. These findings provide possibilities in cascaded meta-gratings spectroscopic design and alternative utilities for high signal-to-noise ratio applications in focus-free spatial filtering and anti-noise systems in telecommunications.

scholarly journals Low-dose, phase-contrast mammography with high signal-to-noise ratio

2016 ◽  
Vol 7 (2) ◽  
pp. 381 ◽  
Author(s):  
Lukas B. Gromann ◽  
Dirk Bequé ◽  
Kai Scherer ◽  
Konstantin Willer ◽  
Lorenz Birnbacher ◽  
...  
Keyword(s):  
Phase Contrast ◽  
Low Dose ◽  
Signal To Noise Ratio ◽  
High Signal ◽  
Signal To Noise ◽  
Noise Ratio
Sign in / Sign up

Export Citation Format

Share Document