scholarly journals Blood Platelet’s Behavior on Nanostructured Superhydrophobic Surface

2008 ◽  
Vol 2 ◽  
pp. 129-136 ◽  
Author(s):  
Ming Zhou ◽  
Jia Hong Yang ◽  
Xia Ye ◽  
Ao Ran Zheng ◽  
Gang Li ◽  
...  

Regular arrays of micro-pillars and nano-grooves structures on the silicon wafer are fabricated by using soft lithography, and the three dimension morphology of textured surface is observed by using scanning electron microscopy (SEM) and atomic force microscope (AFM). The static water contact angles are measured by using contact angle meter to characterize the wettabilities of these surfaces. To investigate how the presence of topography and the variations of wettability affect the haemocompatibility of textured surface contacted with blood, different patterned surfaces are designed and fabricated, and blood platelet adhesion test is carried out on these surfaces. The adhesion and coagulation of platelets are inspected by scanning electron microscopy (SEM). Experimental data presented in this paper indicate that different surface roughness and wettability are the important factors for blood platelet adhesion. The amount of adsorbed blood platelet is low on textured surfaces, compared with that on the flat surface. Especially, there is no coagulation and activation on the surface with nanometer grooves. That is to say, the superhydrophobic surface is apt to decrease blood platelet adhesion. The study suggests that surface with suitable wettabililty and textured structures exhibits superior blood compatibility.

2018 ◽  
Vol 33 (6) ◽  
pp. 573-584 ◽  
Author(s):  
Mohan Prasath Mani ◽  
Saravana Kumar Jaganathan ◽  
Ahmad Zahran Khudzari ◽  
Rajasekar Rathanasamy ◽  
Praseetha Prabhakaran

Wound healing is a complex process and it requires proper scaffolding for regeneration. An ideal scaffold should provide optimal environmental conditions in order to assist cellular attachment, proliferation and differentiation. In this work, a new composite based on polyurethane and neem oil was fabricated using one-step electrospinning technique. Fabricated composite patch along with the pristine polyurethane was characterized through scanning electron microscopy, Fourier transform and infrared spectroscopy, thermogravimetric analysis, contact angle measurement and atomic force microscopy. Moreover, the blood compatibility was evaluated using activated partial thromboplastin time, partial thromboplastin time and haemolysis assay. Scanning electron microscopy studies of composites revealed the existence of fibres with a smaller diameter (635  ± 105 nm) compared to the pristine polyurethane (969 ± 217 nm). Fourier transform and infrared analysis revealed the formation of hydrogen bond and peak shifting characteristics confirming the interaction of the neem oil with the polyurethane. Contact angle analysis showed the decrease in contact angle indicating the hydrophilic nature of the fabricated patch compared to pristine polyurethane. Thermal gravimetric analysis depicted the better thermal stability of the novel composite patch due to the existence of neem oil in the pristine polyurethane. The presence of neem oil in polyurethane matrix also resulted in an increase in the surface roughness as observed in the AFM analysis. The novel composite patch showed an ability to reduce the thrombogenicity and promoting the anticoagulant nature signified by blood compatibility assays like activated partial thromboplastin time and partial thromboplastin time. Finally, the haemolytic percentage of the fabricated composite (1%) was found to be reduced compared to control (2.733%) indicating better blood compatibility and safety with the red blood cells. Following the results, the fabricated patches offered enhanced physicochemical and blood compatible nature making it as a promising candidate for wound healing application.


2021 ◽  
Vol 41 (03) ◽  
pp. 393-399
Author(s):  
Parwin Jalal Jalil

Spillage of protoscoleces within hydatid fluid during surgery for hydatid cyst is the main reason for its recurrence. Therefore, to inactivate the protoscoleces, various scolicidal substances have been tested. However, novel and more efficient agents are needed owing to several associated complications. This study focused on the effects of green synthetic Silver Nanoparticles (AgNPs) from Zizyphus spina- christi leaves on Echinococcus granulosus protoscoleces. Also, to evaluate the blood compatibility of Ag NPs. The Ag NPs were identified by ultraviolet-visible (UV-Visible) spectrophotometer, X-ray diffraction (XRD), Scanning electron microscopy imaging, and Energy-dispersive X-ray spectroscopy (EDX). Hydatid fluid was aspirated aseptically from cysts of infected sheep liver. The protoscoleces were exposed to Ag NPs at several concentrations. Also, scanning electron microscopy for ultrastructural changes and in vitro erythrocytes lysis was performed. The Ag NPs were spherical; the particles' size reached 50 nm, and presented a surface plasmon peak around 460 nm. The current study's findings indicated the powerful in vitro scolicidal efficacy of the green biosynthesized AgNPs. Several morphological alterations were observed on the protoscoleces by optical and scanning electron microscopy. Lysis of RBCs at different doses of Ag NPs was significantly (P≤0.05) less than the positive control value, thus proposing its biocompatibility. This work suggests that chemicals like polyphenols present in the extract of Z. spina- christi act as reducing and stabilizers agents to create Ag NPs Nevertheless, further investigations are needed to investigate the Ag NPs scolicidial effects in animal models.


Blood ◽  
2012 ◽  
Vol 120 (21) ◽  
pp. 105-105 ◽  
Author(s):  
Vivian Xiaoyan Du ◽  
Philip G de Groot ◽  
Richard van Wijk ◽  
Zaverio M. Ruggeri ◽  
Bas De Laat

Abstract Abstract 105 Erythrocytes are the major cellular component of blood and they have been shown to contribute to primary hemostasis, predominantly due to their rheological properties. Direct platelet-erythrocyte interaction has been published but no information is available on the mechanism of interaction and the physiological function. Our aim was to characterize platelet-erythrocyte interactions under near physiological conditions in-vitro. At first we studied whether erythrocytes are able to bind to platelets adhered to surfaces coated with different adhesive proteins at different flow-rates. For this purpose, an in vitro perfusion system connected to a light microscope and a digital camera was used. Erythrocytes bind to platelets both in buffer (washed platelets and erythrocytes) and in whole blood. Erythrocytes were attached to platelets with a sort of “focal adhesion point”, resulting in a tear-drop shape (Fig 1a, b, erythrocyte binding to platelets under flow). Erythrocyte-platelet adhesion was inversely correlated with flow rate and predominately occurred at shear rates lower than 300S−1. The addition of platelet agonists, i.e collagen related peptide (CRP), adenosine diphosphate (ADP), thrombin and arachidonic acid increased erythrocyte binding to platelets 3 to 6 folds indicating that platelet activation is involved in capturing erythrocytes from the circulation. An Arg-Gly-Asp (RGD) containing peptide (d-RGDW), known to inhibit αIIbβ3 mediated platelet aggregation inhibited erythrocyte-platelet adhesion with 29% to 72%, depending on the agonist used (p<0.05, n=4). As erythrocyte ICAM-4 has been reported to be a ligand for platelet activated αIIbβ3(Hermand P. et al, J.Biol.Chem, 2003,), we tested whether ICAM-4 and platelet αIIbβ3 are the ligand/receptor pair responsible for the erythrocyte-platelet adhesion. Experiments with inhibitory antibodies revealed that the erythrocyte-platelet adhesion under conditions of flow was inhibited with both anti-ICAM-4 (40%, p<0.01, n=8) and anti- integrin β3 (CD61) (46%, p<0.001, n=8). In addition, an ICAM-4 peptide resembling the extracellular domain of human ICAM-4 demonstrated a significant inhibitory effect on erythrocyte-platelet adhesion. To further characterize the binding between ICAM-4 and αIIbβ3, flow cytometry analysis was performed. We found a decreased fibrinogen binding to platelets (43% at ADP concentration of 125μM, p<0.05, n=5) and an increased P-selectin expression (60%, p<0.01, n=5) on platelets upon ADP stimulation in the presence of ICAM-4 peptide. This finding suggests that ICAM-4 peptide compete with fibrinogen for binding to activated αIIbβ3. The increase of P-selectin expression in the presence of ICAM-4 peptide suggests that binding of ICAM peptide to αIIbβ3 results in outside-in signalling and further platelet activation. In conclusion, we found direct erythrocyte-platelet interaction under conditions of low shear stresses. This interaction is partly mediated via erythrocyte receptor ICAM-4 and platelet activated integrin αIIbβ3. In addition we found an indication that interaction with erythrocytes further enhances platelet activation. Direct erythrocyte-platelet adhesion seems to play a role in platelet depending thrombus formation. Fig 1a: Erythrocyte binding to platelets under flow Fig 1a:. Erythrocyte binding to platelets under flow Fig 1b: Scanning electron microscopy picture of erythrocyte-platelet interaction under flow Fig 1b:. Scanning electron microscopy picture of erythrocyte-platelet interaction under flow Disclosures: No relevant conflicts of interest to declare.


HortScience ◽  
2000 ◽  
Vol 35 (3) ◽  
pp. 422F-423
Author(s):  
Vladimir Orbovic ◽  
John L. Jifon ◽  
James P. Syvertsen

Urea solutions, with or without non-ionic (X-77) and organosilicone (L-77) surfactant, were applied to Citrus leaves and isolated cuticles to examine adjuvant effects on urea uptake and leaf net gas exchange. When compared to X-77, L-77 exhibited superior features as a surfactant, resulting in smaller contact angles of droplets deposited on teflon slide. Both L-77 and X-77 had a strong effect on penetration rate of urea within first 20 min of experiment. Effect of L-77 on urea penetration rate decreased quickly within next 20 min, whereas the effect of X-77 was sustained over a 24-h period following application. When compared to solution of urea alone, addition of X-77 to urea resulted in significant increase of the total amount of urea that penetrated the cuticles. The effect of L-77 was smaller, although the total amount of urea that penetrated the cuticles within a 4-day period was similar for both surfactants. Solutions of either urea alone, urea+L-77 and urea+X-77, or L-77 alone, induced a negative effect on net CO2 assimilation (ACO2) for 4 to 24 h after they were sprayed onto leaves. X-77, when applied alone, had no effect on ACO2. Scanning electron microscopy revealed that 1 h after application, leaf surfaces treated with X-77 appeared to be heavily coated, as opposed to those treated with L-77, which appeared similar to untreated control leaves.


2009 ◽  
Vol 79-82 ◽  
pp. 1123-1126 ◽  
Author(s):  
Tong Liu ◽  
Yan Sheng Yin ◽  
Lan Li

A superhydrophobic film with an anti-corrosive propertyhas been fabricated on the anodized aluminium foil by myristic acid (CH3(CH2)12COOH, mya) chemically adsorbed. The surface structure and composition were then characterized by means of scanning electron microscopy (SEM) The static contact angle (CA) for seawater is measured to be larger than 150°. The fluoroscope and scanning electron microscopy (SEM) show the samples with the superhydrophobic film which is immersed into nature seawater for 24h significantly decrease adhesion of microorganisms. The appearance of the microorganisms is characterized by transmission electron microscopy (TEM). The study suggests the superhydrophobic film dose not only decrease the corrosion currents densities (icorr), but also microbially influencing corrosion acceleration inhibition (MICI) due to preventing colonization of microorganisms. A hypothesis is indicated that aluminums whit the superhydrophobic film could be used as a kind of excellent marine materials.


2015 ◽  
Vol 2015 ◽  
pp. 1-5 ◽  
Author(s):  
Mengnan Qu ◽  
Jinmei He ◽  
Sun Zhe ◽  
Kanshe Li ◽  
Xiangrong Liu ◽  
...  

A mechanical durable polysiloxane superhydrophobic surface was successfully prepared by means of polymerization of silanes blending with particles. The as-prepared polysiloxane surface showed stable superhydrophobicity even after the surface underwent a long distance friction. The superhydrophobicity of the polysiloxane materials can be even slightly enhanced by the surface abrasion. The scanning electron microscopy demonstrated that the micro- and nanometer structures distributed through the whole materials thickness are responsible for the mechanical durable superhydrophobicity.


Materials ◽  
2018 ◽  
Vol 11 (11) ◽  
pp. 2210 ◽  
Author(s):  
Zhiru Yang ◽  
Chongchong Zhu ◽  
Nan Zheng ◽  
Dezheng Le ◽  
Jianzhong Zhou

Microstructures are applied to various hydrophobic/hydrophilic surfaces due to the role of adjusting the surface wettability. In this paper, a 1064 nm pulsed picosecond laser was applied to prepare a micro/nano hierarchical structure on the surface of the titanium alloy (Ti-6Al-4V). The microstructures consist of dimple arrays with various diameters, depths, and areal densities. They are obtained by controlling the pulse energy and the number of pulses. The nanostructures are periodic ripples, which are defined as laser-induced periodic surface structure (LIPSS), and the dimensional parameter of LIPSS can be adjusted by changing the laser energy density and scanning speed. The contact angles of various laser textured surfaces were measured. It is found that the contact angle increases with the density of micro-textured surface increases, and the wetting state of textured surfaces conforms to the Cassie model. Some laser processed samples were subjected to low-temperature annealing treatment. It is observed that the low-temperature annealing process can accelerate the surface wettability transition significantly, which is attributed to the change of the hydroxyl groups on the surface. Finally, a superhydrophobic surface with the maximum contact angle of 144.58° is obtained.


Author(s):  
P.S. Porter ◽  
T. Aoyagi ◽  
R. Matta

Using standard techniques of scanning electron microscopy (SEM), over 1000 human hair defects have been studied. In several of the defects, the pathogenesis of the abnormality has been clarified using these techniques. It is the purpose of this paper to present several distinct morphologic abnormalities of hair and to discuss their pathogenesis as elucidated through techniques of scanning electron microscopy.


Sign in / Sign up

Export Citation Format

Share Document