Preparation and High Temperature Thermoelectric Properties of [Ca2(Co0.65Cu0.35)2O4]0.624CoO2 Compound

2007 ◽  
Vol 336-338 ◽  
pp. 805-808 ◽  
Author(s):  
Xiao Ya Li ◽  
Yun Yu ◽  
Dong Li Wang ◽  
Li Dong Chen
Keyword(s):  
High Temperature ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Conduction Mechanism ◽  
Sol Gel ◽  
Hopping Conduction ◽  
Dimensionless Figure Of Merit ◽  
Plasma Sintering ◽  
Thermoelectric Energy ◽  
Spark Plasma

[Ca2(Co0.65Cu0.35)2O4]0.624CoO2 polycrystalline samples were prepared using sol-gel method followed by spark plasma sintering. Thermoelectric properties of the samples were examined from room temperature to 1000K. The temperature dependence of electrical conductivity shows that the hole hopping conduction mechanism is dominant for the samples. The activation energy of hopping conduction is 0.11 eV. At the temperature of about 1000K, the electrical resistivity is 7.1m cm, the thermopower is 160 μVK-1, the thermal conductivtity is 2.94Wm-1K-1 and dimensionless figure of merit reaches 0.12. These results indicate [Ca2(Co0.65Cu0.35)2O4]0.624CoO2 is a potential material for high temperature thermoelectric energy conversion.

Preparation and Thermoelectric Properties of Bi-Doped Mg2Si Nanocomposites

2009 ◽  
Vol 66 ◽  
pp. 17-20 ◽  
Author(s):  
Mei Jun Yang ◽  
Wei Jun Luo ◽  
Qiang Shen ◽  
Hong Yi Jiang ◽  
Lian Meng Zhang
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Seebeck Coefficient ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Dimensionless Figure Of Merit ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
Heavy Doping ◽  
Nanocomposite Structures

Nanocomposites and heavy doping both are regarded as effective way to improve materials’ thermoelectric properties. 0.7at% Bi-doped Mg2Si nanocomposites were prepared by spark plasma sintering. Results of thermoelectric properties tests show that the doping of Bi atom effectively improves the electrical conductivity of Mg2Si，and the nanocomposite structures are helpful to reduce thermal conductivity and increase Seebeck coefficient, hence improving the thermoelectric performance. A maximum dimensionless figure of merit of 0.8 is obtained for the Bi-doped Mg2Si nanocomposite with 50 wt % nanopowder inclusions at 823K, about 63% higher than that of Bi-doped Mg2Si sample without nanopowder inclusions and 119% higher than that of microsized Mg2Si sample without Bi-doped, respectively.

Thermoelectric Properties of La-doped BaSi2 and (Ba,Sr)Si2 Solid Solutions

2007 ◽  
Vol 1044 ◽  
Author(s):  
Kohsuke Hashimoto ◽  
Ken Kurosaki ◽  
Hiroaki Muta ◽  
Shinsuke Yamanaka
Keyword(s):  
Thermal Conductivity ◽  
Solid Solution ◽  
Electrical Resistivity ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Room Temperature ◽  
Dimensionless Figure Of Merit ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
La Doped

AbstractWe studied the thermoelectric properties of BaSi2 and SrSi2. The polycrystalline samples were prepared by spark plasma sintering (SPS). The electrical resistivity (ρ), Seebeck coefficient (S), and thermal conductivity (κ) were measured above room temperature. The maximum values of the dimensionless figure of merit (ZT) were 0.01 at 954 K for BaSi2 and 0.09 at 417 K for SrSi2. We tried to enhance the ZT values of BaSi2 and SrSi2 by prepareing and characterizing La-doped BaSi2 and (Ba,Sr)Si2 solid solution.

scholarly journals Fabrication and Thermoelectric Properties of Graphene/Bi2Te3Composite Materials

2013 ◽  
Vol 2013 ◽  
pp. 1-5 ◽  
Author(s):  
Beibei Liang ◽  
Zijun Song ◽  
Minghui Wang ◽  
Lianjun Wang ◽  
Wan Jiang
Keyword(s):  
Thermoelectric Properties ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Conductivity Measurement ◽  
Testing Temperature ◽  
X Ray Diffraction ◽  
X Ray ◽  
Dimensionless Figure Of Merit ◽  
Plasma Sintering ◽  
Spark Plasma

Graphene/Bi2Te3thermoelectric materials were prepared by spark plasma sintering (SPS) using hydrothermal synthesis of the powders as starting materials. The X-ray diffraction (XRD) and field emission scanning electron microscope (FE-SEM) were used to investigate the phase composition and microstructure of the as-prepared materials. Electrical resistivity, Seebeck coefficient, and thermal conductivity measurement were applied to analyze the thermoelectric properties. The effect of graphene on the performance of the thermoelectric materials was studied. The results showed that the maximum dimensionless figure of merit of the graphene/Bi2Te3composite with 0.2 vol.% graphene was obtained at testing temperature 475 K, 31% higher than the pure Bi2Te3.

Fabrication of Mg2Si from a Reused-silicon Source and its Thermoelectric Characteristics

2007 ◽  
Vol 1044 ◽  
Author(s):  
Masayasu Akasaka ◽  
Tsutomu Iida ◽  
Youhiko Mito ◽  
Takeru Omori ◽  
Yohei Oguni ◽  
...  
Keyword(s):  
Thermoelectric Properties ◽  
Power Factor ◽  
Figure Of Merit ◽  
Silicon Source ◽  
Figures Of Merit ◽  
Dimensionless Figure Of Merit ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
P Type ◽  
Type Sample

AbstractPolycrystalline Mg2Si was fabricated from a reused-Silicon source, based on Si sludge, using Spark Plasma Sintering technique. The n-type and p-type dopants, bismuth (Bi) and silver (Ag), respectively, were incorporated into the Mg2Si. The thermoelectric properties were estimated from 300 to 873K. The power factors of undoped and Bi-doped samples from the reused-Si source were comparable to those from a solar grade Si source (99.99999%). The power factor was estimated to be 2.5 × 10-5 W/cmK2 for the Bi-doped sample from the reused-Si source. However, the power factor of the Ag-doped, p-type sample from the reused-Si source was lower than that from solar grade Si source. The dimensionless figures of merit of samples from the resused-Si source were slightly lower than those from a solar grade Si source. The dimensionless figure of merit was estimated to be 0.53 at 812 K for Bi-doped sample from the reused-Si source.

Fabrication of Bi-Te Based Thermoelectric Semiconductors by Using Hybrid Powders

2005 ◽  
Vol 297-300 ◽  
pp. 875-880
Author(s):  
Cheol Ho Lim ◽  
Ki Tae Kim ◽  
Yong Hwan Kim ◽  
Dong Choul Cho ◽  
Young Sup Lee ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Single Crystals ◽  
Thermoelectric Properties ◽  
Thermoelectric Materials ◽  
Figure Of Merit ◽  
Bending Strength ◽  
Mixing Ratio ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
P Type

P-type Bi0.5Sb1.5Te3 compounds doped with 3wt% Te were fabricated by spark plasma sintering and their mechanical and thermoelectric properties were investigated. The sintered compounds with the bending strength of more than 50MPa and the figure-of-merit 2.9×10-3/K were obtained by controlling the mixing ratio of large powders (PL) and small powders (PS). Compared with the conventionally prepared single crystal thermoelectric materials, the bending strength was increased up to more than three times and the figure-of-merit Z was similar those of single crystals. It is expected that the mechanical properties could be improved by using hybrid powders without degradation of thermoelectric properties.

Enhanced Thermoelectric Properties of Mg2Si0.3Sn0.7 Compounds by Bi Doping

2014 ◽  
Vol 616 ◽  
pp. 174-177
Author(s):  
Mei Jun Yang ◽  
Qiang Shen ◽  
Lian Meng Zhang
Keyword(s):  
Thermal Conductivity ◽  
Thermoelectric Properties ◽  
Figure Of Merit ◽  
Doping Concentration ◽  
Single Phase ◽  
Doping Content ◽  
Maximum Value ◽  
Plasma Sintering ◽  
Bi Doping ◽  
Spark Plasma

The single phase of Bi-doped Mg2Si0.3Sn0.7compounds have been successfully fabricated by solid state reaction and spark plasma sintering (SPS). The effect of Bi doping concentration on the thermoelectric properties of Mg2Si0.3Sn0.7is investigated. The doping of Bi atom results in the increase of carrier concentrations and ensures the increase of electrical conductivity. Although the thermal conductivity and Seebeck coefficient shows a slight increase, the figure of merit of Mg2Si0.3Sn0.7compounds still increases with the increasing contents of Bi-doping. When Bi-doping content is 1.5at%, the Mg2Si0.3Sn0.7compound obtained the maximum value,ZT, is 1.03 at 640 K.

Study on Mechanisms of Rare Earth Elements on Improving Thermoelectric Properties of RExCo4Sb12

2011 ◽  
Vol 71-78 ◽  
pp. 3737-3740
Author(s):  
Ke Gao Liu ◽  
Jing Li
Keyword(s):  
Rare Earth ◽  
Rare Earth Elements ◽  
Mechanical Alloy ◽  
Spark Plasma Sintering ◽  
Thermoelectric Properties ◽  
Rare Earth Element ◽  
Figure Of Merit ◽  
Earth Element ◽  
Plasma Sintering ◽  
Spark Plasma

It is the important way to improve thermoelectric properties of skutterudite materials by doping with rare earth elements. The mechanisms of improving properties of bulk RExCo4Sb12materials prepared by mechanical alloy and spark plasma sintering (MA-SPS) at 650°C were investigated by analyzing the composition, microstructure and atomic occupying locations. According the results it can be considered that the mechanism to improve the thermoelectric properties of rare earth elements is that rare earth element Ce in the samples mainly plays the doping role in reducing the resistivity of the sample and improving the conductivity, so that it makes the figure of merit ZT of samples increase significantly.

Thermoelectrical properties of α phase and γ phase NaxCo2O4 ceramics prepared by spark plasma sintering method

2013 ◽  
Vol 1490 ◽  
pp. 57-62 ◽  
Author(s):  
Natsuko Mikami ◽  
Keishi Nishio ◽  
Koya Arai ◽  
Tatsuya Sakamoto ◽  
Masahiro Minowa ◽  
...  
Keyword(s):  
Thermal Conductivity ◽  
Electrical Conductivity ◽  
Spark Plasma Sintering ◽  
Figure Of Merit ◽  
Dimensionless Figure Of Merit ◽  
Α Phase ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
Sintering Method ◽  
Acid Compound

ABSTRACTThe thermoelectrical properties of α and γ phases of NaxCo2O4 having different amounts of Na were evaluated. The γ NaxCo2O4 samples were synthesized by thermal decomposition in a metal-citric acid compound, and the α NaxCo2O4 samples were synthesized by self-flux processing. Dense bulk ceramics were fabricated using spark plasma sintering (SPS), and the sintered samples were of high density and highly oriented. The thermoelectrical properties showed that γ NaxCo2O4 had higher electrical conductivity and lower thermal conductivity compared with α NaxCo2O4 and that α NaxCo2O4 had a larger Seebeck coefficient. These results show that γ NaxCo2O4 has a larger power factor and dimensionless figure of merit, ZT, than α NaxCo2O4.

Sign in / Sign up

Export Citation Format

Share Document