Characterization of Annealed HPSI 4H-SiC for Photoconductive Semiconductor Switches

2012 ◽  
Vol 717-720 ◽  
pp. 301-304 ◽  
Author(s):  
Cameron Hettler ◽  
William W. Sullivan III ◽  
James Dickens

Annealing of high purity semi-insulating (HPSI) 4H-SiC is investigated as a method to improve bulk photoconductive semiconductor switches through recombination lifetime modification. Five samples of HPSI 4H-SiC were annealed at 1810 °C for lengths of time ranging from 3 to 300 minutes. The recombination lifetime of the unannealed and annealed samples was measured using a contactless microwave photoconductivity decay (MPCD) system. The MPCD system consists of a 35 GHz continuous microwave probe and a tripled Nd:YAG pulsed laser. The recombination lifetime was increased from 6 ns, as received, up to 185 ns by annealing for 300 minutes. To experimentally verify switch improvements, identical switches from unannealed and annealed material were fabricated and tested at low voltage. The unannealed device generated a 15 ns pulse with a 2 ns rise-time. The annealed device conducted for upwards of 300 ns with a comparable 2 ns rise-time. The increased recombination lifetime resulted in lower on-state resistance and increased energy transfer.

2005 ◽  
Vol 483-485 ◽  
pp. 405-408 ◽  
Author(s):  
R.J. Kumar ◽  
Peter A. Losee ◽  
Can Hua Li ◽  
Joseph Seiler ◽  
I. Bhat ◽  
...  

A Microwave Photoconductivity Decay (M-PCD) technique which senses changes insample conductivity as carriers recombine following excitation by a laser pulse, has been used to determine the minority carrier recombination lifetime from the decay rate of carriers in 4H-SiC epitaxial layers. Decay times varying from 60 ns to 500 ns have been measured, with the decay increasing with thickness. Device simulations show that I-V characteristics of pin diodes fabricated with these epitaxial layers are compatible with the observed decay times.


2021 ◽  
Vol 127 ◽  
pp. 105716
Author(s):  
Tianzhen Guo ◽  
Dan Wang ◽  
Yajun Yang ◽  
Xiaoyong Xiong ◽  
Kelin Li ◽  
...  

1991 ◽  
Author(s):  
Fred J. Zutavern ◽  
Guillermo M. Loubriel ◽  
Marty W. O'Malley ◽  
Dan L. McLaughlin ◽  
Wesley D. Helgeson

2010 ◽  
Vol 75 ◽  
pp. 202-207
Author(s):  
Victor Ríos ◽  
Elvia Díaz-Valdés ◽  
Jorge Ricardo Aguilar ◽  
T.G. Kryshtab ◽  
Ciro Falcony

Bi-Pb-Sr-Ca-Cu-O (BPSCCO) and Bi-Pb-Sb-Sr-Ca-Cu-O (BPSSCCO) thin films were grown on MgO single crystal substrates by pulsed laser deposition. The deposition was carried out at room temperature during 90 minutes. A Nd:YAG excimer laser ( = 355 nm) with a 2 J/pulse energy density operated at 30 Hz was used. The distance between the target and substrate was kept constant at 4,5 cm. Nominal composition of the targets was Bi1,6Pb0,4Sr2Ca2Cu3O and Bi1,6Pb0,4Sb0,1Sr2Ca2Cu3OSuperconducting targets were prepared following a state solid reaction. As-grown films were annealed at different conditions. As-grown and annealed films were characterized by XRD, FTIR, and SEM. The films were prepared applying an experimental design. The relationship among deposition parameters and their effect on the formation of superconducting Bi-system crystalline phases was studied.


2016 ◽  
Vol 367 ◽  
pp. 480-484 ◽  
Author(s):  
Xiaoyan Yang ◽  
Bo Liu ◽  
Bing Li ◽  
Jingquan Zhang ◽  
Wei Li ◽  
...  

1994 ◽  
Vol 76 (10) ◽  
pp. 6287-6289 ◽  
Author(s):  
B. M. Simion ◽  
R. Ramesh ◽  
V. G. Keramidas ◽  
G. Thomas ◽  
E. Marinero ◽  
...  

2001 ◽  
Vol 14 (3) ◽  
pp. 160-167 ◽  
Author(s):  
G A Farnan ◽  
M P McCurry ◽  
D G Walmsley ◽  
Z Z Li ◽  
H Raffy

Sign in / Sign up

Export Citation Format

Share Document