Two Dimensional Numerical Analysis of Piston Ring Lubrication of an Internal Combustion Engine

Author(s):  
ZHANG Yong ◽  
CHEN Guohua ◽  
LI Bing
Author(s):  
James R MacDonald ◽  
Claudia Fajardo

Abstract The assumption of isotropic turbulence is commonly incorporated into models of internal combustion engine (ICE) in-cylinder flows. While preliminary analysis with two-dimensional velocity data indicates that the turbulence may tend to isotropy as the piston approaches TDC, the validity of this assumption has not been fully investigated, partially due to lack of three-component velocity data in ICEs. In this work, the velocity was measured using two-dimensional, three-component (2D-3C) particle image velocimetry in a single-cylinder, motored, research engine to investigate the evolution of turbulence anisotropy throughout the compression stroke. Invariants of the Reynolds stress anisotropy tensor were calculated and visualized, through the Lumley triangle, to investigate turbulence states. Results showed the turbulence to be mostly anisotropic, with preferential tendency toward 2D axisymmetry at the beginning of the compression stroke and approaching isotropy near top-dead-center. Findings provide new insights into turbulence in dynamic, bounded flows to assist with the development of physics-based, quantitative models.


2019 ◽  
Vol 71 (4) ◽  
pp. 515-524 ◽  
Author(s):  
Venkateswara Babu P. ◽  
Ismail Syed ◽  
Satish Ben Beera

Purpose In an internal combustion engine, piston ring-cylinder liner tribo pair is one among the most critical rubbing pairs. Most of the energy produced by an internal combustion engine is dissipated as frictional losses of which major portion is contributed by the piston ring-cylinder liner tribo pair. Hence, proper design of tribological parameters of piston ring-cylinder liner pair is essential and can effectively reduce the friction and wear, thereby improving the tribological performance of the engine. This paper aims to use surface texturing, an effective and feasible method, to improve the tribological performance of piston ring-cylinder liner tribo pair. Design/methodology/approach In this paper, influence of positive texturing (protruding) on friction reduction and wear resistance of piston ring surfaces was studied. The square-shaped positive textures were fabricated on piston ring surface by chemical etching method, and the experiments were conducted with textured piston ring surfaces against un-textured cylinder liner surface on pin-on-disc apparatus by continuous supply of lubricant at the inlet of contact zone. The parameters varied in this study are area density and normal load at a constant sliding speed. A comparison was made between the tribological properties of textured and un-textured piston ring surfaces. Findings From the experimental results, the tribological performance of the textured piston ring-cylinder liner tribo pair was significantly improved over a un-textured tribo pair. A maximum friction reduction of 67.6 per cent and wear resistance of 81.6 per cent were observed with textured ring surfaces as compared to un-textured ring surfaces. Originality/value This experimental study is helpful for better understanding of the potency of positive texturing on friction reduction and wear resistance of piston ring-cylinder liner tribo pair under lubricated sliding conditions.


Sign in / Sign up

Export Citation Format

Share Document