Cold-Start WHTC and WHSC Testing Results on Multi-Cylinder Opposed-Piston Engine Demonstrating Low CO2 Emissions while Meeting BS-VI Emissions and Enabling Aftertreatment Downsizing

Author(s):  
Samrat Patil ◽  
Abhishek Sahasrabudhe ◽  
David Youngren ◽  
Fabien Redon ◽  
David Johnson ◽  
...  
2021 ◽  
Vol 13 (15) ◽  
pp. 8237
Author(s):  
István Árpád ◽  
Judit T. Kiss ◽  
Gábor Bellér ◽  
Dénes Kocsis

The regulation of vehicular CO2 emissions determines the permissible emissions of vehicles in units of g CO2/km. However, these values only partially provide adequate information because they characterize only the vehicle but not the emission of the associated energy supply technology system. The energy needed for the motion of vehicles is generated in several ways by the energy industry, depending on how the vehicles are driven. These methods of energy generation consist of different series of energy source conversions, where the last technological step is the vehicle itself, and the result is the motion. In addition, sustainability characterization of vehicles cannot be determined by the vehicle’s CO2 emissions alone because it is a more complex notion. The new approach investigates the entire energy technology system associated with the generation of motion, which of course includes the vehicle. The total CO2 emissions and the resulting energy efficiency have been determined. For this, it was necessary to systematize (collect) the energy supply technology lines of the vehicles. The emission results are not given in g CO2/km but in g CO2/J, which is defined in the paper. This new method is complementary to the European Union regulative one, but it allows more complex evaluations of sustainability. The calculations were performed based on Hungarian data. Finally, using the resulting energy efficiency values, the emission results were evaluated by constructing a sustainability matrix similar to the risk matrix. If only the vehicle is investigated, low CO2 emissions can be achieved with vehicles using internal combustion engines. However, taking into consideration present technologies, in terms of sustainability, the spread of electric-only vehicles using renewable energies can result in improvement in the future. This proposal was supported by the combined analysis of the energy-specific CO2 emissions and the energy efficiency of vehicles with different power-driven systems.


Energy ◽  
2009 ◽  
Vol 34 (12) ◽  
pp. 2144-2150 ◽  
Author(s):  
Franco Donatini ◽  
Gianluca Gigliucci ◽  
Juri Riccardi ◽  
Massimo Schiavetti ◽  
Roberto Gabbrielli ◽  
...  

2019 ◽  
Vol 11 (12) ◽  
pp. 3394 ◽  
Author(s):  
Xiao-Yong Wang

Fly ash and slag have been widely used to produce low-CO2 concrete. However, previous studies have not paid enough attention to the lower carbonation resistance of fly-ash-and-slag-blended concrete and the aggravations of carbonation due to climate change. This study proposes a technique for the design of fly-ash-and-slag-blended concrete considering carbonation durability coupled with various climate change scenarios. First, CO2 emissions are evaluated from concrete mixtures. Concrete strength and carbonation depth are evaluated using efficiency factors of fly ash and slag. A genetic algorithm (GA) is used to find the optimal mixture with the lowest CO2 emissions considering the requirements of strength, carbonation durability, and workability. Second, we clarify the effect of cost on the mixture design of low-CO2 concrete. A genetic algorithm is also used to find the optimal mixture with the lowest cost. We found that the optimal mixture with the lowest cost is different from that with the lowest CO2 emissions. Third, by adding the additional constraint of cost, Pareto optimal mixtures are determined, which consider both lower CO2 emissions and lower material cost. The analysis results show that carbonation durability is the control factor of mixture design of fly ash-slag blended concrete. To mitigate the challenge of climate change, the binder content of blended concrete should be increased.


ATZ worldwide ◽  
2013 ◽  
Vol 115 (9) ◽  
pp. 50-55
Author(s):  
Wolfgang Fritz ◽  
Dietmar Hofer ◽  
Bruno Götzinger

Energy ◽  
2013 ◽  
Vol 58 ◽  
pp. 36-44 ◽  
Author(s):  
Yuanyuan Li ◽  
Na Zhang ◽  
Ruixian Cai

2009 ◽  
Vol 12 (2) ◽  
pp. 171-175 ◽  
Author(s):  
Rodrigo Rivera-Tinoco ◽  
Chakib Bouallou
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document