HEAT EXCHANGE OF THE COAL BED WITH ENCLOSING ROCKS DURING UNDERGROUND COAL GASIFICATION

2020 ◽  
Vol 2 (1) ◽  
pp. 301-308
Author(s):  
N.M. KACHURIN ◽  
◽  
E.I. ZAKHAROV ◽  
G.V. FRIDLENDER ◽  
M.P. GANIN ◽  
...  

It is shown that heat leaving the chemical reaction zone due to heat conduction is spent on thermal preparation of the coal seam and heating of the host rocks. It has been suggested that, with a sufficient degree of accuracy, we can assume that the heat fluxes are perpendicular to the surfaces that transfer heat. This made it possible, combining the origin of coordinate axes with these surfaces, to develop a mathematical model of heat transfer of a gasified coal seam with host rocks. It is noted that the model of the integrated use of the coalcoal complex of coal deposits allows reaching a new technological level using underground coal gasification.

2014 ◽  
Vol 931-932 ◽  
pp. 1020-1024
Author(s):  
Wan Rosli Wan Sulaiman ◽  
Norlia Azizan ◽  
Mohd Zaidi Jaafar ◽  
Abdul Razak Ismail ◽  
Mariani Abdul Hamid ◽  
...  

Methane gas obtained from coal sources can be classified into two categories i.e Coal Bed Methane (CBM) and Underground Coal Gasification (UCG) gases. The Industry today often neglects the importance of capturing the UCG as important source of methane potential besides the surface gasification potential. This research will evaluate on the new resource estimation of methane as reserves with application of new technological advances in exploitation. As an analysis, the UCG energy return is significantly higher than that of CBM. Both CBM and UCG output gas can be liquefied, or used as a direct feedstock to local power stations. The CO2 generated from UCG process may be used for Enhanced Coal Bed Methane (ECBM) process because of more adsorption capacity than methane, may lead to additional methane potential. Deeper coal seams may be targeted for CBM, followed by UCG for additional resources in the form of coal gas. A depleted CBM area may be targeted for UCG with some modification on the well profile. Developing an integrated and centrally controlled approach to exploit the coal resources in which, the appropriate extraction methodology should be identified for each particular target coal-seam or groups of coal seam. It is important to strategize the sequencing of energy extraction methods to provide an optimal balance between the energy delivery for sustainable future and its true socio-economic value. As from this analysis, with 245.6 acres of coal, estimated gas can be produced is 3.25 TSCF which is 101 BSCF is coming from CBM, 3.14 TSCF from UCG and another 14.45 BSCF is from ECBM.


2020 ◽  
Vol 2 (1) ◽  
pp. 309-318
Author(s):  
A.N. KACHURIN ◽  
◽  
A.B. KOPILOV ◽  
G.V. FRIDLENDER ◽  
M.P. GANIN ◽  
...  

A mathematical model of the temperature regime of a coal bed during underground coal gasification in a filtration channel for new geotechnologies of Tula State University is developed. It is proposed to describe the unsteady temperature field of the coal seam with the one-dimensional heat conduction equation with the heat sink that depends on the temperature of the coal bed. The equation is solved for semi-infinite space. The results of computational experiments have shown that the temperature front from the fire face moves deep into the coal bed. Consequently, in the process of underground gasification, pre-heating of coal in the gasified block and thermal preparation take place. Quite quickly, after the formation of stable combustion of coal in the fire face, a stationary temperature profile is established.


2018 ◽  
Vol 223 ◽  
pp. 82-92 ◽  
Author(s):  
Fa-qiang Su ◽  
Akihiro Hamanaka ◽  
Ken-ichi Itakura ◽  
Wenyan Zhang ◽  
Gota Deguchi ◽  
...  

2017 ◽  
Vol 25 ◽  
pp. 118-127
Author(s):  
Vasyl Lozynskyi

The purpose of this paper is substantiating of efficiency during application of borehole underground coal gasification technology based on target coal seam geology. Comprehensive methodology that included analytical calculation is implemented in the work. To determine the efficiency of coal seam gasification in faulting areas, an economic calculation method was developed. The obtained conditions of coal seam allow to provide rational order of mine workings. Conclusions regarding the implementation of the offered method are made on the basis of undertaken investigations. The obtained results with sufficient accuracy in practical application will allow consume coal reserves in the faulting zones using environmentally friendly conversion technology to obtain power and chemical generator gas, chemicals and heat.


2019 ◽  
Vol 291 ◽  
pp. 137-147
Author(s):  
Volodymyr Falshtynskyi ◽  
Roman Dychkovskyi ◽  
Pavlo Saik ◽  
Vasyl Lozynskyi ◽  
Victor Sulaiev ◽  
...  

The authors of the paper consider the concept of further prospective development of mining enterprises. The basis of this concept are scientific results obtained during the study of physical and chemical processes of solids conversion into the gaseous state: coal → gaseous fuels. It was established that the main base of development of mining regions is a mining power-chemical complex. The basic segment of which is a well underground coal gasification station. It is established that increase of indicators of efficient operation of the station from gasification is possible by synthesis of technical and technological decisions on the use of coal seam energy. When coal gasification is over, the gasifier passes into a mode of thermal generator with the use of alothermal technique to remove heat and thermic decomposition products from the degassed space of the gasifier. Generator gas at its initial temperature (1100 – 1300oС) around an underground gasifier creates a powerful heat boiler with a temperature regime of 200 – 300oС. It was established that at work of six gasifiers on a coal seam with thickness of 1.0 m with geometrical parameters each at a width of 30 m and at the length of 450 m energy-thermal power will be 237.8 MW. At the same time, additional energy resources can be obtained by involving segments of alternative forms of energy supply to the life cycle of the mining enterprise.


1975 ◽  
Vol 15 (05) ◽  
pp. 425-436 ◽  
Author(s):  
C.F. Magnani ◽  
S.M. Farouq Ali

Abstract This investigation focuses on mathematical modeling of the process of underground gasification of coal by the stream method. A one-dimensional, steady-state model consisting of five coupled differential equations was formulated, and the solution, extracted analytically, was used to develop closed-form expressions for the parameters influencing coal gasification. The model then was used for interpreting field performance curves, predicting the results of The performance curves, predicting the results of The field tests, and ascertaining the over-all process sensitivity to the input variables. The usefulness of the model was shown by establishing the parameters influencing the success or failure of parameters influencing the success or failure of an underground gasification project. Introduction One method of eliminating many of the technological and environmental difficulties encountered during the production of synthetic gas through aboveground coal gasification involves gasifying cod in situ. This process, known as underground coal gasification, was first proposed in 1868 by Sir William Siemens and is based on the controlled combustion of coal in situ. This in-situ combustion results in the production of an artificial or synthetic gas that is rich in carbon dioxide, carbon monoxide, hydrogen, and hydrocarbon gases. Despite the fact that reaction stoichiometry is a moot element of underground coal gasification, it is nonetheless believed thatcarbon dioxide is formed by the partial oxidation of coal,carbon monoxide is generated by the subsequent reduction of carbon dioxide, andthe hydrogen and hydrocarbon gases result from the water-gas reaction and carbonization of coal, respectively. To effect the controlled combustion of coal in situ, the coal seam first must be ignited and a means must be provided for supporting combustion (through injection of a suitable gasification agent) and producing the gases generated underground. Fig. 1 presents a schematic diagram of an underground gasification system that complies with these requirements. This approach to gasifying coal is known as the stream or channel method and necessitates drilling two parallel galleries, one serving as an injection gas inlet and the other as a producer gas outlet. These wells are then linked by a borehole drilled horizontally through the coal seam. Ignition occurs in the coal seam at the gas inlet and proceeds in the direction of flow. The combustion front thus generated moves essentially perpendicular to the direction of gas flow. perpendicular to the direction of gas flow.Since the technological inception of underground gasification, over 1,500 publications have appeared in the literature that bear testimony to the absence of a complete, legitimate, theoretical analysis of the underground gasification process. Given this observation, it is the basis of this paper that progress in underground coal-gasification research progress in underground coal-gasification research has suffered from the absence of "interpretative theory"; that is, it has suffered from a lack of logical, physical, and mathematical analysis of the governing and underlying aerothermochemical principles. The difficulties in formulating a principles. The difficulties in formulating a mathematical model adequately describing the numerous phenomena involved during coal gasification are indeed formidable. SPEJ P. 425


2013 ◽  
Vol 58 (2) ◽  
pp. 465-480 ◽  
Author(s):  
Piotr Małkowski ◽  
Zbigniew Niedbalski ◽  
Joanna Hydzik-Wiśniewska

Among the main directions of works on energy acquisition, there is the development and application of the technology of underground gasification of coal deposits (UCG). During the process of deposit burning and oxidation, there is also impact of temperatures exceeding 1000°C on rocks surrounding the deposit. As a result of subjecting carboniferous rocks to high temperatures for a prolonged period of time, their structure will change, which in turn will result in the change of their physical properties. Due to the project of underground coal gasification, as performed in Poland, laboratory tests are currently under way to a broad extent, including physical properties of carboniferous rocks subjected to high temperatures. The article presents results of laboratory tests of rocks surrounding the designed geo-reactor: changes to bulk density, specific density and porosity due to high temperature, and confronts the above results with the results of tests of thermal conductivity, specific heat and heat diffusivity (temperature conductivity) of the rocks. The mineralogical investigations were presented too.


2019 ◽  
Vol 27 (4) ◽  
pp. 227-235
Author(s):  
Erika Škvareková ◽  
Marianna Tomašková ◽  
Gabriel Wittenberger ◽  
Štefan Zelenák

AbstractThe purpose of this article is to determine the environmental impacts of underground gasification on the population and to analyze the risk of underground coal gasification (UCG) activities using selected risk assessment methods. Coal gas is a regular part of coal deposits and its extraction also allows the use of coal deposits that cannot be extracted by traditional methods. These technologies bring both positive and negative aspects. The paper points out the risk analysis, hazard identification and assessment during the operation of UCG technology using a risk graph and a risk matrix. Identified risks to workers that cannot be reduced should be taken into consideration and appropriate safeguard should be used. For each risk, it is necessary to inform employees about regular education and training. From worldwide experience with this technology, it is possible to analyze risks in Slovakia. Actual gasification produces polluting gases such as carbon dioxide, carbon monoxide, hydrogen sulphide, hydrogen sulphide, nitrogen oxides, tar and ash, and creates a risk that may occur on and under the surface of the site depending on the geological and hydrogeological structure of the deposits. Possible measures to mitigate the adverse effects are proposed for the implementation of this technology. Coal is still one of the main domestic primary energy sources. Currently, only 5 out of 19 deposits in the Slovak Republic are used. Underground gasification could increase the use of Slovak coal and brown coal deposits.


Energies ◽  
2021 ◽  
Vol 14 (17) ◽  
pp. 5444
Author(s):  
Milan Durdán ◽  
Marta Benková ◽  
Marek Laciak ◽  
Ján Kačur ◽  
Patrik Flegner

The underground coal gasification represents a technology capable of obtaining synthetic coal gas from hard-reached coal deposits and coal beds with tectonic faults. This technology is also less expensive than conventional coal mining. The cavity is formed in the coal seam by converting coal to synthetic gas during the underground coal gasification process. The cavity growth rate and the gasification queue’s moving velocity are affected by controllable variables, i.e., the operation pressure, the gasification agent, and the laboratory coal seam geometry. These variables can be continuously measured by standard measuring devices and techniques as opposed to the underground temperature. This paper researches the possibility of the regression models utilization for temperature data prediction for this reason. Several regression models were proposed that were differed in their structures, i.e., the number and type of selected controllable variables as independent variables. The goal was to find such a regression model structure, where the underground temperature is predicted with the greatest possible accuracy. The regression model structures’ proposal was realized on data obtained from two laboratory measurements realized in the ex situ reactor. The obtained temperature data can be used for visualization of the cavity growth in the gasified coal seam.


Sign in / Sign up

Export Citation Format

Share Document