Running Injuries

2006 ◽  
pp. 182-182
Author(s):  
Laila Das
Keyword(s):  
2008 ◽  
Vol 41 (6) ◽  
pp. 36
Author(s):  
TIMOTHY F. KIRN
Keyword(s):  

Sensors ◽  
2021 ◽  
Vol 21 (9) ◽  
pp. 3277
Author(s):  
Juan Luis Florenciano Restoy ◽  
Jordi Solé-Casals ◽  
Xantal Borràs-Boix

The objectives of this study were to determine the amplitude of movement differences and asymmetries between feet during the stance phase and to evaluate the effects of foot orthoses (FOs) on foot kinematics in the stance phase during running. In total, 40 males were recruited (age: 43.0 ± 13.8 years, weight: 72.0 ± 5.5 kg, height: 175.5 ± 7.0 cm). Participants ran on a running treadmill at 2.5 m/s using their own footwear, with and without the FOs. Two inertial sensors fixed on the instep of each of the participant’s footwear were used. Amplitude of movement along each axis, contact time and number of steps were considered in the analysis. The results indicate that the movement in the sagittal plane is symmetric, but that it is not in the frontal and transverse planes. The right foot displayed more degrees of movement amplitude than the left foot although these differences are only significant in the abduction case. When FOs are used, a decrease in amplitude of movement in the three axes is observed, except for the dorsi-plantar flexion in the left foot and both feet combined. The contact time and the total step time show a significant increase when FOs are used, but the number of steps is not altered, suggesting that FOs do not interfere in running technique. The reduction in the amplitude of movement would indicate that FOs could be used as a preventive tool. The FOs do not influence the asymmetry of the amplitude of movement observed between feet, and this risk factor is maintained. IMU devices are useful tools to detect risk factors related to running injuries. With its use, even more personalized FOs could be manufactured.


2021 ◽  
Vol 48 ◽  
pp. 83-90
Author(s):  
Joe P. Warne ◽  
Allison H. Gruber ◽  
Roy Cheung ◽  
Jason Bonacci

2018 ◽  
Vol 3 (3) ◽  
pp. 2473011418S0005
Author(s):  
Erin Futrell ◽  
Irene Davis

Category: Sports Introduction/Purpose: Vertical impact forces are highly influenced by the way the foot contacts the ground. These impact forces are associated with high loading rates which have been related to running injuries. As a result, clinicians have begun to use gait retraining interventions to reduce loadrates and prevent future impact-related injuries. Two types of gait retraining techniques have been promoted to reduce excessive running impacts. The first involves increasing cadence (CAD), or number of steps per minute, by 5-10%, thereby reducing stride length. The second type of gait retraining involves landing on the ball of the foot at ground contact, or using a forefoot strike (FFS). Both of these gait-retraining styles have been reported to reduce impacts, but they have not been compared with each other. Methods: 33 healthy runners (9M, 24F), running 5-15 mpw, with a rearfoot strike pattern with cadence < 170 steps/min were recruited. Subjects were randomly allocated to either FFS or CAD retraining. All subjects underwent an 8-session gait retraining program (over 2-3 wks) with auditory feedback on a treadmill. The CAD group ran to a digital metronome to increase cadence by 7.5%. The FFS group wore a wireless accelerometer that provided an auditory signal on footstrike pattern. A gait analysis was conducted at baseline, 1 wk, 1 month, and 6 months. Variables included vertical average and instantaneous load rates (VALR, VILR). A 2 x 4 repeated measures ANOVA was used to compare differences within and between the CAD and FFS groups at baseline, 1 week, 1 month and 6 months post retraining. For variables with significant interactions, simple main effects of group, as well as time were further explored using one-way ANOVA Results: There were significant interaction effects of time*group for VALR (p= 0.001), VILR (p=0.001) and foot angle (p< 0.001), but not cadence. For the simple main effects for the CAD group, VALR reduced by 14%, 7% and 16% at 1 week, 1 month, and 6 months post gait retraining respectively, compared with baseline (Figure 1). However, these reductions were not significant. For the FFS group, VALR was significantly reduced by 50%, 51% and 51% at 1 week, 1 month, and 6 months post gait retraining respectively. Interestingly, both the CAD and FFS groups increased cadence by similar amounts. Conclusion: Transitioning to a FFS pattern is significantly more effective than increasing CAD when reducing vertical loadrate (both VALR and VILR) is the goal. These changes persisted out to 6 months post gait retraining, suggesting permanence of the new pattern.


PeerJ ◽  
2020 ◽  
Vol 8 ◽  
pp. e9813
Author(s):  
Junqing Wang ◽  
Zhen Luo ◽  
Boyi Dai ◽  
Weijie Fu

Background Excessive impact peak forces and vertical load rates are associated with running injuries and have been targeted in gait retraining studies. This study aimed to determine the effects of 12-week cadence retraining on impact peak, vertical load rates and lower extremity biomechanics during running. Methods Twenty-four healthy male recreational runners were randomised into either a 12-week cadence retraining group (n = 12), which included those who ran with a 7.5% increase in preferred cadence, or a control group (n = 12), which included those who ran without any changes in cadence. Kinematics and ground reaction forces were recorded simultaneously to quantify impact force variables and lower extremity kinematics and kinetics. Results Significantly decreased impact peak (1.86 ± 0.30 BW vs. 1.67 ± 0.27 BW, P = 0.003), vertical average load rates (91.59 ± 18.91 BW/s vs. 77.31 ± 15.12 BW/s, P = 0.001) and vertical instantaneous load rates (108.8 ± 24.5 BW/s vs. 92.8 ± 18.5 BW/s, P = 0.001) were observed in the cadence retraining group, while no significant differences were observed in the control group. Foot angles (18.27° ± 5.59° vs. 13.74° ± 2.82°, P = 0.003) and vertical velocities of the centre of gravity (CoG) (0.706 ± 0.115 m/s vs. 0.652 ± 0.091 m/s, P = 0.002) significantly decreased in the cadence retraining group at initial contact, but not in the control group. In addition, vertical excursions of the CoG (0.077 ± 0.01 m vs. 0.069 ± 0.008 m, P = 0.002) and peak knee flexion angles (38.6° ± 5.0° vs. 36.5° ± 5.5°, P < 0.001) significantly decreased whilst lower extremity stiffness significantly increased (34.34 ± 7.08 kN/m vs. 38.61 ± 6.51 kN/m, P = 0.048) in the cadence retraining group. However, no significant differences were observed for those variables in the control group. Conclusion Twelve-week cadence retraining significantly increased the cadence of the cadence retraining group by 5.7%. This increased cadence effectively reduced impact peak and vertical average/instantaneous load rates. Given the close relationship between impact force variables and running injuries, increasing the cadence as a retraining method may potentially reduce the risk of impact-related running injuries.


Author(s):  
Michael Fredericson ◽  
Adam S. Tenforde
Keyword(s):  

2018 ◽  
Vol 3 (3) ◽  
pp. 2473011418S0048
Author(s):  
Adam Tenforde ◽  
Haylee Donaghe Borgstrom ◽  
Steve Jamison ◽  
Irene Davis

Category: Sports Introduction/Purpose: It is well established that elevated vertical loadrates on footstrike are a risk factor for developing running injuries. Overstriding, or increased foot and tibial angles at footstrike, has been theorized to increase loading rate. Thus, it is often suggested that runners shorten their stride to reduce their injury risk. However, the relationship between landing alignment and loadrates has not been well established in current literature. Thus, we aimed to investigate the relationship between sagittal plane foot angle (FA) and tibial angle (TA) with vertical loadrates in both healthy and injured forefoot (FFS) and rearfoot strike (RFS) runners. It was hypothesized that as FA and TA increased, loadrate would increase for all runners. Methods: This is an ongoing study with 52 healthy runners (35 RFS, 17 FFS) and 24 injured runners (14 RFS, 10 FFS) for a total of 76 runners (51 M, 25 F; age34.3±11.4 yrs). Vertical average loadrate (VALR) and vertical instantaneous loadrate (VILR) were obtained while running at 2.68 m/s on an instrumented treadmill. All runners reported 0/10 pain during the assessment. Sagittal plane FA and TA at footstrike were measured from video recording using an open-source program. Positive FA designated RFS. Positive TA was defined as ankle anterior to the knee. Between-group differences were evaluated using paired two-tailed t-tests. Correlation coefficients (r) were computed for FA and TA with VALR and VILR (p=0.05; trend: p =0.10). Results: Healthy RFS - FA and TA were negatively correlated with VALR and VILR. Injured RFS – There was a trend toward negative correlation between TA and both VALR and VILR. Healthy FFS – TA was negatively correlated with both loadrates. Injured FFS – There were no significant correlations. Correlation coefficients, slopes, and p values are presented in Table 1. VALR and VILR were higher in RFS vs FFS runners (56±20 vs 40±10, 69±25 vs 54±12 BW/s, p<0.01), but were not significantly different for healthy vs injured runners (52±19 vs 56±26, 63±21 vs 67±27 BW/s, p=0.4). Conclusion: In contrast to current thought, preliminary results suggest that increasing FA and TA at footstrike are associated with decreasing vertical loadrates. This relationship was strongest for FA in the healthy RFS runners and weakest for FA in both the healthy and injured FFS runners. With increased FA, load attenuation may be due to increased eccentric activity of the tibialis anterior as well as increased knee flexion excursion and eccentric quadriceps activity with increased TA.


Sign in / Sign up

Export Citation Format

Share Document