scholarly journals Pengaruh Penambahan Mikroorganisme Terhadap Sifat Fisik dan Kuat Geser Tanah Gambut Palembang

2021 ◽  
Vol 28 (3) ◽  
pp. 269-280
Author(s):  
Erza Rismantojo ◽  
Niar Nauri Ningsih
Keyword(s):  

Makalah ini berisi hasil penelitian yang mempelajari pengaruh penambahan 5, 10, dan 15% larutan mikroorganisme terhadap sifat fisik dan kuat geser tanah gambut dari Palembang, Sumatera Selatan. Pengujian dilakukan pada tanah gambut yang dikeringkan kemudian dipadatkan setelah dicampur air tanpa/dan larutan mikroorganisme pada kondisi tanpa masa peram dan setelah pemeraman selama tujuh hari. Sifat fisik yang diamati adalah specific gravity, nilai pH, kadar abu, kadar organik, dan kadar serat tanah gambut sebelum dan setelah dicampur dengan larutan mikroorganisme. Sifat mekanik yang dipelajari adalah kuat geser niralir dan efektif benda uji tanah gambut saja dan gambut yang dicampur dengan larutan mikroorganisme. Benda uji dibuat dengan cara pemadatan manual dan diuji dengan cara triaxial consolidated-undrained. Hasil penelitian menunjukkan bahwa penambahan larutan mikroorganisme menaikkan nilai specific gravity, pH, kadar abu, kohesi efektif, sudut geser dalam efektif,kuat geser niralir, dan mengurangi kadar organik dan serat. Benda uji untuk pengujian triaksial dijenuhkan dan dikonsolidasikan dengan tegangan efektif isotropik 50, 100, dan 200kPa. Hasil pengujian triaxial memperlihatkan bahwa kekuatan geser niralir tanah gambut Palembang yang dipadatkan ini dapat dinormalisasi dengan faktor normalisasi yang mirip dengan yang digunakan untuk tanah berbutir kasar.

Author(s):  
A. Howie ◽  
D.W. McComb

The bulk loss function Im(-l/ε (ω)), a well established tool for the interpretation of valence loss spectra, is being progressively adapted to the wide variety of inhomogeneous samples of interest to the electron microscopist. Proportionality between n, the local valence electron density, and ε-1 (Sellmeyer's equation) has sometimes been assumed but may not be valid even in homogeneous samples. Figs. 1 and 2 show the experimentally measured bulk loss functions for three pure silicates of different specific gravity ρ - quartz (ρ = 2.66), coesite (ρ = 2.93) and a zeolite (ρ = 1.79). Clearly, despite the substantial differences in density, the shift of the prominent loss peak is very small and far less than that predicted by scaling e for quartz with Sellmeyer's equation or even the somewhat smaller shift given by the Clausius-Mossotti (CM) relation which assumes proportionality between n (or ρ in this case) and (ε - 1)/(ε + 2). Both theories overestimate the rise in the peak height for coesite and underestimate the increase at high energies.


1895 ◽  
Vol 39 (1011supp) ◽  
pp. 16162-16162
Author(s):  
T. Lohnstein
Keyword(s):  

Author(s):  
Masahiro Ito ◽  
Yuitch Iwagaki ◽  
Hiroshi Murakami ◽  
Kenji Nemoto ◽  
Masato Yamamoto ◽  
...  

2020 ◽  
Vol 9 (4) ◽  
pp. e31942727
Author(s):  
João Gabriel Missia da Silva ◽  
Pedro Nicó de Medeiros ◽  
Denise Ransolin Soranso ◽  
Vinicius Peixoto Tinti ◽  
José Tarcísio da Silva Oliveira ◽  
...  

The aim of this study was to evaluate the influence of anatomical characteristics on the adhesion performance of Vatairea sp., Paulownia sp., Aspidosperma populifolium and Tectona grandis wood. Specimens for anatomical, physical and mechanical analyzes were produced from tangentially oriented boards. The treatments were joint glued from pieces of the same anatomical orientation (radial and tangential), evaluated for shear strength and glue line failure. The Vatairea sp wood had the highest specific gravity (0.74 g cm-3) and the Paulownia sp (0.34 g cm-3) wood was smaller. Aspidosperma populifolium species showed the highest shear strength in the glue line in the tangential and radial faces. The anatomical variables with higher influence on the wood adhesion process were pith ray cells and especially fibers that exhibit the greatest correlation with the shear strength of the glue line.


1955 ◽  
Vol 5 (1) ◽  
pp. 47-54
Author(s):  
J. Hammes
Keyword(s):  

2014 ◽  
Vol 6 (1) ◽  
pp. 35 ◽  
Author(s):  
Rizka Karima

There’s so many pal solid waste or palm empty fruit bunches, but the utilization is not maximized, this research its to optimized utilization of palm solid waste to be wood vinegar and want to know the composition physical properties and chemical properties of wood vinegar from palm empty fruit bunches. Total yield of wood vinegar from palm empty fruit bunches its 15,94 % and total yield of charcoal its 64,58 %. GCMS result showing chemical properties from wood vinegar of burning < 100oC its obtained 19 compound and burning >100 oC its obtained 6 compound. The result physichal properties testing from crued wood vinegar its obtained specific gravity 1,0005 and 1,0010, pH value are 3,233 and 3,186, TAT content are 9,36 % and 11,12 %, phenol content its 0,44 %. The result physical properties testing from wood vinegar which has decolorizatin by activated carbon its obtained specific gravity are 0,9987 and 0,999, pH value are 3,036 and 3,012, TAT content are 8,29 % and 9,27 % and phenol content its 0,01 %.Keywords: palm bunches, wood vinegar, liquid smoke


2014 ◽  
Vol 11 (1) ◽  
pp. 51
Author(s):  
Mohd Helmy Ibrahim ◽  
Mohd Nazip Suratman ◽  
Razali Abd Kader

Trees planted from agroforestry practices can become valuable resources in meeting the wood requirements of many nations. Gliricidia sepium is an exotic species introduced to the agricultural sector in Malaysia mainly for providing shade for cocoa and coffee plantations. This study investigates its wood physical properties (specific gravity and moisture content) and fibre morphology (length, lumen diameter and cell wall thickness) of G. sepium at three intervals according to age groups ( three, five and seven years of ages). Specific gravity (0.72) was significantly higher at seven years ofage as compared to five (0.41) and three (0.35) years age group with a mean of 0.43 (p<0.05). Mean moisture content was 58.3% with no significant difference existing between the tree age groups. Fibre diameter (22.4 mm) was significantly lower (p<0.05) for the trees which were three years of age when compared to five and seven years age groups (26.6 mm and 24. 7 mm), respectively. Means of fibre length, lumen diameter and cell wall thickness were 0.83 mm, 18.3 mm, and 6.2 mm, respectively, with no significant differences detected between trees in all age groups. Further calculation on the coefficient of suppleness and runkel ratio suggest that wood from G.sepium may have the potential for insulation board manufacturing and paper making. However, future studies should experiment the utilisation of this species for these products to determine its full potential.


Sign in / Sign up

Export Citation Format

Share Document