First order derivative spectrophotometric method for the determination of benidipine hydrochloride pharmaceutical preparations and forced degradation study

2015 ◽  
Vol 118 (6) ◽  
pp. 1036-1039
Author(s):  
Ayзa Karasakal
2008 ◽  
Vol 68 (9-10) ◽  
pp. 843-847 ◽  
Author(s):  
A. B. Thomas ◽  
N. G. Dumbre ◽  
R. K. Nanda ◽  
L. P. Kothapalli ◽  
A. A. Chaudhari ◽  
...  

INDIAN DRUGS ◽  
2019 ◽  
Vol 56 (01) ◽  
pp. 87-90
Author(s):  
S Raghu ◽  
S. Muneer. ◽  
K.B. Chandra sekhar ◽  
kiran B. Siva Sai ◽  

The present study was carried out to develop a simple and reliable derivative spectrophotometric method for the determination of bromofenac sodium in pharmaceutical dosage forms .The solutions of standard and the sample were prepared in distilled water The quantitative determination of the drug was carried out with zero order derivative (method A) values measured at 268 nm and first order (method B) derivative values measured at 258 nm , and two wavelengths 262nm and 274nm were selected for the determination AUC (method C) of integrated areas. Calibration graphs constructed at their wavelengths of determination, were linear within the concentration range of 2-12 μg/mL (r2 = 0.999) for zero order and (r2 = 0.997) first order derivative spectrophotometric method. No significant difference between the performance of the proposed methods regarding the mean values and standard deviations and is suitable for the routine quality control application of bromofenac sodium in its pharmaceutical formulations.


INDIAN DRUGS ◽  
2012 ◽  
Vol 49 (09) ◽  
pp. 40-43
Author(s):  
R. E Mutha ◽  
◽  
D. M Dhumal ◽  
P. H. Patil ◽  
A. A. Shirkhedkar ◽  
...  

Raloxifene hydrochloride (RLF) is a non-steroidal, selective estrogen receptor modulator used in the treatment and prevention of osteoporosis in postmenopausal women. Two simple, rapid and economical 'zero order UV-spectrophotometric (method I)' and first order derivative spectrophotometric (method II) using area under curve (AUC) technique have been developed for estimation of RLF in bulk and tablets. In 0.1N NaOH, RLF showed maximum absorbance at 303.5 nm. In method I, AUC between two wavelengths 275.0 nm & 350.0 nm were selected. In method II, UV-spectrum of RLF was derivatized into first order and two wavelengths 303.0 nm and 385.0 nm were selected for determination of AUC. In both these methods, RLF obeyed linearity in the concentration range of 2-10 mcg/mL (r2>0.99). Proposed methods were applied for tablet formulations and amounts of RLF estimated by method I and method II were found to be 100.08±0.68 and 99.78±0.94, respectively. Both these methods were validated statistically and by recovery experiments.


2012 ◽  
Vol 11 (1) ◽  
pp. 15-30
Author(s):  
Anitha Varghese ◽  
A M A Khadar

A simple, selective and sensitive spectrophotometric method has been developed for the determination of trace amounts of thorium using a newly synthesised reagent diacetylmonoximep-hydroxybenzoylhydrazone (DMPHBH) in the presence of Triton X-100. The molar absorptivity and Sandell’s sensitivity of the coloured species at pH 4.4 were found to be 4.20 x 104 L mol-1 cm-1 and 5.5 ng cm-2, respectively. Beer’s law is obeyed in the range 0.35 -3.8 mg mL-1 of thorium(IV) at 410 nm. The stoichiometry of the complex was found to be 1:2 (Th(IV): DMPHBH). A highly selective first order derivative spectrophotometric method for the determination of thorium in the presence of uranium is also reported. The detection limit and quantitation limit of first order derivative spectrophotometry were found to be 0.03 and 0.11 mg mL-1, respectively. The developed procedure has been successfully applied for the trace level determination of thorium in rock samples and synthetic mixtures.


2012 ◽  
Vol 77 (7) ◽  
pp. 911-917 ◽  
Author(s):  
Valéria Guzsvány ◽  
Sanja Lazic ◽  
Natasa Vidakovic ◽  
Zsigmond Papp

A simple first-order derivative spectrophotometric method was developed for the simultaneous determination of acetamiprid and 6-chloronicotinic acid (6-CNA) at pH 7.0. By using the zero-crossing approach, acetamiprid was determined at 269.0 nm and 6-CNA at 216.0 nm with the detection limits of 7.19x10-7 and 8.25x10-7 mol dm-3, respectively and relative standard deviations not exceeding 1.2% in the case of model systems.


Sign in / Sign up

Export Citation Format

Share Document