Systematic Development of Generic Skills to Enhance Innovation Capacity of Eastern and Southeastern European Universities

The level of innovativeness within the higher education systems of east and southeast Europe and their graduates is still assessed as modest or moderate. Besides the general socio–economic context and the inherited institutional management types, this deficiency stems from a lack of generic skills crucial for increasing the innovation capacity of the universities. TrainESEE v.2 project suggests that significant changes should be already put in place within the applied teaching methodology, but also highlights the importance of developing project development and management skills, innovation, entrepreneurial skills, and finally competences needed to strengthen science to business cooperation.

Health Condition of European Beech (Fagus sylvatica L.) According to Provenances in International Provenance Trial

The performance of European beech ( Fagus sylvatica L.) is severely threatened by abiotic and biotic stresses, but the resilience of its provenances from distinct geographic areas has not been sufficiently studied. Therefore, the performance of European beech was investigated in an international provenance trial consisting of twenty-one natural populations originating from Central Europe and Southeast Europe located on Medvednica Mountain (Croatia). The performance of European beech was investigated by characterizing I) damage types, II) crown damage intensity, III) damage frequency, and IV) clustering of provenances based on damage types. Anthracnose, galls, chewing damages, and aphids were recorded on leaves, and canker on the trunk and branches. The crown damage intensity was minute (less than 10%) for all types of disease. Anthracnose was the most common damage, followed in descending order by galls, canker, chewing damages and aphids. When the types of damage were analysed using descriptive statistics (frequency analysis and clustering), significant differences were recorded between provenances (χ2=322.19, p<0.0001). European beech provenances were classified into four clusters. Aphids and galls caused the least and the highest damage, respectively, in each cluster, except for Cluster 4, where anthracnose caused the highest damage. The results of this study showed generally good health condition of European beech provenances originating from Central and Southeast Europe in the period of the investigation.

Ex Occidente Lux. From Phenomenology of Myth to Geopolitics and Ontology and Vice Versa in the Late Works of Janko Janeff

Janko Janeff’s book Southeast Europe and the German Spirit (1938) is analyzed through the lens of a fundamental Thracian-Dionysian- Orphic myth, i.e. the birth of being or of light from non-being/nothing/ darkness. It is shown how its geopolitical and ontological/theological consequences are to be drawn accordingly to that purely phenomenological premise concerning the supposed Indo-European Renaissance on the Old Continent as per the views expressed by the author.

Model calculations of non-cloud radiative forcing due to anthropogenic sulphate aerosol

Anthropogenic sulphate aerosol particles scatter incoming solar radiation thereby perturbing the radiative budget, hence climate. We have used a three dimensional radiative transfer model together with the sulphate concentration fields simulated by two independent chemistry-transport models to calculate the annual cycle of the radiative forcing due to anthropogenic sulphate aerosol. The calculated forcing pattern shows large peaks over the eastern United States, southeast Europe and eastern China. The calculated annual global-mean radiative forcing is -0.50 Wm-2 for Langner and Rodhe (1991) data and -0.49 Wm-2 for Penner et el. [1994 (a&b)] data. The forcing was found to vary with season, with a larger forcing during northern hemispheric summer than winter. Sulphate aerosol also appreciably perturbs the lower tropospheric heating rates over northern hemispheric mid-latitudes. The forcing was also found to be sensitive to the global cloud cover and to the optical properties of the aerosol. The possible sources of the differences in magnitude with previous estimates are discussed. Over northern hemispheric mid-latitudes, the negative radiative forcing due to the direct effect of aerosols appreciably offsets the positive forcing due to increase in greenhouse gases. A 26-layer radiative-convective model (RCM) was also used to examine the equilibrium temperature profiles due to sulphate aerosols and increase in greenhouse gases. It was found that the effect of sulphate aerosols is the cooling of surface-troposphere system. Sulphate aerosols reduce the tropospheric warming and enhance the stratospheric cooling caused by increase in greenhouse gases.

Chemical and sensorial characteristics of traditional fruit spirits from Southeast Europe

Spirits have proliferated and become an indispensable part of most gastronomic cultures around the world. The production and consumption of fruit brandies, especially plum and grape brandies as well as pear and apple brandies, have a long tradition in the countries of Southeast Europe. The aim of this study was to evaluate 47 fruit brandies produced in small distilleries and industrial plants from five countries. The content of the most common volatile compounds (methanol, higher alcohols and fatty acid esters) and the sensory quality of the fruit brandies were analysed. Principal component analysis (PCA) was performed using theconcentrations of the main volatile compounds in the spirit samples and sensory evaluation to identify similarities or differences between the spirit samples based on distillery size. The methanol concentration in all samples was below the EU legal limit. Methanol concentration was highest in Williams pear spiritsand lowest in grape pomace spirits. The PCA sample distribution confirms the good quality of samples from both small distilleries (SD) and industrial plants (IP), with some exceptions - samples with identified defects produced in some small distilleries. The results of the sensory evaluation show high sensory quality of fruit spirits from this part of Europe.

Innovating (a Lot) With a Little: High-Tech Innovation in Southeast Europe

Motivation: According to the European Innovation Scoreboard (EIS, 2020), Southeast-European countries are either modest or moderate innovators because they consistently innovate below the EU average. Given that innovation is a key driver of economic growth (Hasan & Tucci, 2010), this implies that Southeast Europe has been economically falling back while simultaneously politically integrating with the EU. However, the EIS categorizes countries according to the inconclusive arithmetic mean of indicators for firm-level innovation (bottom-up) and indicators for inputs and enablers of innovation at the national level (top-down). Besides, it does not separately assess innovation performance of high-technology industries although these are crucial for international competitiveness (Schwab, 2019). Consequently, this paper answers the following research question: What is innovation performance of high and medium-high technology industries in Southeast Europe in comparison to the EU average? Idea: In contrast to the EIS which merges top-down with bottom-up innovation indicators, the core idea of this paper has been to analyse only bottom-up data on comparative innovation performance of high and medium-high technology industries in Southeast Europe. Method and data: The paper methodologically draws on guidelines for collecting, reporting, and using data on innovation by Oslo Manual (OECD & Eurostat, 2018), and uses secondary data from 2010-2016 Community Innovation Surveys of enterprises to compile an own set of 140 data points. Innovation activity within an industry is defined as the ratio of innovative enterprises to the total population of enterprises while innovation performance is the ratio of innovation activity in the respective country to innovation activity of this industry in the whole EU. Tools: All data points have been arranged country-wise as unbalanced contingency panels and plotted to draw conclusions on innovation performance of high and medium-high technology industries in Southeast Europe. Findings: Although all top-down innovation inputs and enablers at the national level are far below the EU average throughout Southeast Europe, several industries in the region reach or surpass the average EU innovation performance: the pharmaceutical industry in Croatia, all medium-high technology industries in Turkey, manufacture of machinery in North Macedonia and Serbia, as well as manufacture of motor vehicles in all countries except for Romania. Contributions and limitations: This is the first known paper to benchmark innovation performance of high and medium-high technology industries throughout Southeast Europe. In addition, the paper reveals the shortcomings of the whole-country method employed by the EIS since it clearly points out that innovation performance of national industries should be assessed instead. Limitations of the paper are the exclusive focus on innovation as a process and partly restricted data availability.

Southeast Europe

This chapter charts the religious landscape of Southeast Europe and considers its religious specificities in their historical and geographical context. To this purpose, it discusses the significance of the Orthodox Christian heritage of Byzantium; the cleavage between Eastern and Western Christianity (both Roman Catholicism and Protestantism) and inter-confessional dynamics; the presence of Islam and the long period of Ottoman rule; the existence of other religions in the region; the role of Russia in Southeast European affairs; ethno-religious identities and the rise of nationalism; the communist and the post-communist periods; and finally, the negative discourse about the Balkans in the context of Southeast European distinctiveness, the modernization process, and the potential for religion in this.