Microstructure and Properties of Atmospheric Plasma Sprayed (Al,Cr)2O3–TiO2 Coatings from Blends

Coatings prepared from chromia-rich (Al,Cr)2O3 solid solution (ss) feedstock powders are intended to improve the properties of Cr2O3 coatings, but are rarely studied so far. In this work, the processability of a commercial (Al,Cr)2O3 solid solution (ss) powder containing 78 wt.% Cr2O3 by atmospheric plasma spraying (APS), the corresponding coating microstructures and properties were investigated. Possible further improvements were expected by blending with 2, 23 and 54 wt.% TiOx powder. For comparison, plain Cr2O3 and TiOx coatings were studied as well. The microstructures were analyzed using SEM, EDS and XRD measurements. Hardness (HV0.3) was measured, as well as the dry unidirectional sliding wear resistance and the abrasion wear resistance (ASTM G65). Moreover, the corrosion and electrical insulating properties were measured. The (Al,Cr)2O3 ss showed only a small change of the composition, and the formation of γ-Al2O3, as found for alumina-rich (Al,Cr)2O3 ss powders, was avoided. Compared to the plain chromia coating, some improvements of the processability and coating properties for the ss (Al,Cr)2O3 coating were found. The most balanced coating performance was achieved by blending the ss (Al,Cr)2O3 with 2 wt.% TiOx, as this coating showed both a high sliding and abrasion wear resistance, in combination with a high corrosion resistance.

Synthesis of Mono (Ethylene Glycol)-Based Polyurethane and Effect of Chain Extender on Its Associated Properties

This study depicts the investigations of the effect of composition of aromatic polyester polyol produced from terephthalic acid (TPA) and different concentrations of monoethylene glycol (mEG) as a chain extender on the mechanical properties of polyurethane (PU) elastomer. Aromatic polyester polyols are prepared via the poly-esterification of adipic acid, terephthalic acid, catalyst, and mono ethylene glycol; while a polyurethane elastomer is formulated via the pre-polymerization of polyol with pure monomeric Methylene diphenyl diisocyanate (MDI.) Mechanical properties of polyurethane elastomers are examined, such as hardness via shore A hardness, apparent density via ASTM (American Society for Testing and Materials) D1622–08, and abrasion wear resistance via a Deutches Institut fur Normung (DIN) abrasion wear resistance tester. Structural properties are investigated through Fourier-transform infrared spectroscopy (FTIR) analysis. Results reveal that the shore A hardness of the PU elastomer increases with an increasing concentration of mEG from 4g to 12g. Nevertheless, the elastomer’s density depicts a reduction with an increasing extender content. The abrasion wear resistance of polyurethane, however, increases with an increasing concentration of glycol. A structural analysis through FTIR confirms the formation of polyurethane elastomer through the characteristic peaks demonstrated.