Sports safety matting diminishes cardiopulmonary resuscitation quality and increases rescuer perceived exertion

Objectives Compliant surfaces beneath a casualty diminish the quality of cardiopulmonary resuscitation (CPR) in clinical environments. To examine this issue in a sporting environment, we assessed chest compression quality and rescuer exertion upon compliant sports safety matting. Methods Twenty-seven advanced life support providers volunteered (13 male/14 female; mass = 79.0 ± 12.5 kg; stature = 1.77 ± 0.09 m). Participants performed 5 × 2 min, randomized bouts of continuous chest compressions on a mannequin, upon five surfaces: solid floor; low-compliance matting; low-compliance matting with a backboard; high-compliance matting; high-compliance matting with a backboard. Measures included chest compression depth and rate, percentage of adequate compressions, and rescuer heart rate and perceived exertion. Results Chest compression depth and rate were significantly lower upon high-compliance matting relative to other surfaces (p<0.05). The percentage of adequate compressions (depth ≥50 mm) was lowest upon high-compliance matting (40 ± 39%) versus low-compliance matting (60 ± 36%) and low-compliance matting with a backboard (59 ± 39%). Perceived exertion was significantly greater upon high-compliance matting versus floor, low-compliance matting, and low-compliance matting with a backboard (p<0.05). Conclusion Providers of CPR should be alerted to the detrimental effects of compliant safety matting in a sporting environment and prepare to alter the targeted compression depth and rescuer rotation intervals accordingly.

The effects of mechanical noise bandwidth on balance across flat and compliant surfaces

Although the application of sub-sensory mechanical noise to the soles of the feet has been shown to enhance balance, there has been no study on how the bandwidth of the noise affects balance. Here, we report a single-blind randomized controlled study on the effects of a narrow and wide bandwidth mechanical noise on healthy young subjects’ sway during quiet standing on firm and compliant surfaces. For the firm surface, there was no improvement in balance for both bandwidths—this may be because the young subjects could already balance near-optimally or optimally on the surface by themselves. For the compliant surface, balance improved with the introduction of wide but not narrow bandwidth noise, and balance is improved for wide compared to narrow bandwidth noise. This could be explained using a simple model, which suggests that adding noise to a sub-threshold pressure stimulus results in markedly different frequency of nerve impulse transmitted to the brain for the narrow and wide bandwidth noise—the frequency is negligible for the former but significantly higher for the latter. Our results suggest that if a person’s standing balance is not optimal (for example, due to aging), it could be improved by applying a wide bandwidth noise to the feet.

Neuromechanical adaptations of foot function to changes in surface stiffness during hopping

Humans choose work-minimizing movement strategies when interacting with compliant surfaces. Our ankles are credited with stiffening our lower limbs and maintaining the excursion of our body's center of mass on a range of surface stiffnesses. We may also be able to stiffen our feet through an active contribution from our plantar intrinsic muscles (PIMs) on such surfaces. However, traditional modelling of the ankle joint has masked this contribution. We compared foot and ankle mechanics and muscle activation on Low, Medium and High stiffness surfaces during bilateral hopping using a traditional and anatomical ankle model. The traditional ankle model overestimated work and underestimated quasi-stiffness compared to the anatomical model. Hopping on a low stiffness surface resulted in less longitudinal arch compression with respect to the high stiffness surface. However, because midfoot torque was also reduced, midfoot quasi-stiffness remained unchanged. We observed lower activation of the PIMs, soleus and tibialis anterior on the low and medium stiffness conditions, which paralleled the pattern we saw in the work performed by the foot and ankle. Rather than performing unnecessary work, participants altered their landing posture to harness the energy stored by the sprung surface in the low and medium conditions. These findings highlight our preference to minimize mechanical work when transitioning to compliant surfaces and highlight the importance of considering the foot as an active, multi-articular, part of the human leg.

Control Modification of Grasp Force Covaries Agency and Performance on Rigid and Compliant Surfaces

This study investigated how modifications in the display of a computer trace under user control of grasp forces can co-modulate agency (perception of control) and performance of grasp on rigid and compliant surfaces. We observed positive correlation (p &lt; 0.01) between implicit agency, measured from time-interval estimation for intentional binding, and grasp performance, measured by force-tracking error, across varying control modes for each surface type. The implications of this work are design directives for cognition-centered device interfaces for rehabilitation of grasp after neurotraumas such as spinal cord and brain injuries while considering if grasp interaction is rigid or compliant. These device interfaces should increase user integration to virtual reality training and powered assistive devices such as exoskeletons and prostheses. The modifications in control modes for this study included changes in force magnitude, addition of mild noise, and a measure of automation. Significant differences (p &lt; 0.001) were observed for each surface type across control modes with metrics for implicit agency, performance, and grasp control efficiency. Explicit agency, measured from user survey responses, did not exhibit significant variations in this study, suggesting implicit measures of agency are needed for identifying co-modulation with grasp performance. Grasp on the compliant surface resulted in greater dependence of performance on agency and increases in agency and performance with the addition of mild noise. Noise in conjunction with perceived freedom at a flexible surface may have amplified visual feedback responses. Introducing automation in control decreased agency and performance for both surfaces, suggesting the value in continuous user control of grasp. In conclusion, agency and performance of grasp can be co-modulated across varying modes of control, especially for compliant grasp actions. Future studies should consider reliable measures of implicit agency, including physiological recordings, to automatically adapt rehabilitation interfaces for better cognitive engagement and to accelerate functional outcomes.

Surface textures suppress viscoelastic braking on soft substrates

A gravity-driven droplet will rapidly flow down an inclined substrate, resisted only by stresses inside the liquid. If the substrate is compliant, with an elastic modulusG< 100 kPa, the droplet will markedly slow as a consequence of viscoelastic braking. This phenomenon arises due to deformations of the solid at the moving contact line, enhancing dissipation in the solid phase. Here, we pattern compliant surfaces with textures and probe their interaction with droplets. We show that the superhydrophobic Cassie state, where a droplet is supported atop air-immersed textures, is preserved on soft textured substrates. Confocal microscopy reveals that every texture in contact with the liquid is deformed by capillary stresses. This deformation is coupled to liquid pinning induced by the orientation of contact lines atop soft textures. Thus, compared to flat substrates, greater forcing is required for the onset of drop motion when the soft solid is textured. Surprisingly, droplet velocities down inclined soft or hard textured substrates are indistinguishable; the textures thus suppress viscoelastic braking despite substantial fluid–solid contact. High-speed microscopy shows that contact line velocities atop the pillars vastly exceed those associated with viscoelastic braking. This velocity regime involves less deformation, thus less dissipation, in the solid phase. Such rapid motions are only possible because the textures introduce a new scale and contact-line geometry. The contact-line orientation atop soft pillars induces significant deflections of the pillars on the receding edge of the droplet; calculations confirm that this does not slow down the droplet.

Hydro Energy Harvesting by Using Compliant Surfaces: Preliminary Experimental Assessment

In this work consideration is given for hydro energy harvesting contained in residual water streams. The idea lies in the bifurcation of the stream into two channels separated by a compliant surface or membrane which, albeit with equalized static pressure at both sides, nevertheless with a relative velocity. As a result of the differential dynamic pressure, a steady-state harmonic motion is established which might be transformed into an electrical output. A first experimental assessment of this idea constitutes the core of this presentation.

Could a Compliant Foam Anvil Characterize the Biofidelic Impact Response of Equestrian Helmets?

The performance of equestrian helmets to protect against brain injuries caused by fall impacts against compliant surfaces such as turf has not been studied widely. We characterize the kinematic response of simulated fall impacts to turf through field tests on horse racetracks and laboratory experiments. The kinematic response characteristics and ground stiffness at different going ratings (GRs) (standard measurement of racetrack condition) were obtained from 1 m and 2 m drop tests of an instrumented hemispherical impactor onto a turf racetrack. The “Hard” rating resulted in higher peak linear accelerations and stiffness, and shorter impact durations than the “Soft” and “Heavy” ratings. Insignificant differences were found among the other GRs, but a strong overall relationship was evident between the “going rating” and the kinematic response. This relationship was used to propose a series of three synthetic foam anvils as turf surrogates in equestrian falls corresponding to ranges of GRs of (i) heavy-soft (H-S), (ii) good-firm (G-F), and (iii) firm-hard (F-H). Laboratory experiments consisted of a helmeted headform being dropped onto natural turf and the turf surrogate anvils using a monorail drop rig. These experiments revealed that the magnitudes and durations of the linear and rotational accelerations for helmeted impacts to turf/turf surrogates were similar to those in concussive sports falls and collisions. Since the compliance of an impacted surface influences the dynamic response of a jockey's head during a fall impact against the ground, it is important that this is considered during both accident reconstructions and helmet certification tests.