Developed Transfer Function Allows Hydro Generators to Enter the Full Range of Ancillary Services Market

As the number of available renewable energy sources has increased annually, there has been a corresponding rise in the levels of pollution created by traditional electricity generation, ultimately contributing to breaking down the stability of the electrical system at large. Therefore, there is an increasing need to integrate the use of nonpolluting electricity sources, such as pumped storage hydropower plants (PSHP), to ensure the stability of the power system and to maintain the frequency of the system from year-to-year. This paper addresses the issue of PSHP being unsuitable for providing Frequency Containment Reserve (FCR) services and proposes real measurements of the aggregation approach to obtain different data arrays. Based on this, the proposed methodology is orientated toward obtaining transfer functions that were developed using the parametric identification models, and the efficiency of these functions was thoroughly investigated. The proposed transfer function in this paper, in combination with battery energy storage system (BESS) technologies, would allow PSHP technologies to occupy a space in the ancillary services market by providing FCR, Frequency Restoration Reserve (FRR), and Replacement Reserve (RR) services. The performance of the function activated in the BESS is positively validated using the Simulink modeling environment.

Ancillary Services Potential for Flexible Combined Cycles

Combined Cycle Gas Turbines, CCGTs, are often considered as the bridging technology to a decarbonized energy system thanks to their high exploitation rate of the fuel energetic potential. At present time in most European countries, however, revenues from the electricity market on their own are insufficient to operate existing CCGTs profitably, also discouraging new investments and compromising the future of the technology. In addition to their high efficiency, CCGTs offer ancillary services in support of the operation of the grid such as spinning reserve and frequency control, thus any potential risk of plant decommissioning or reduced investments could translate into a risk for the well-functioning of the network. To ensure the reliability of the electricity system in a transition towards a higher share of renewables, the economic sustainability of CCGTs must be preserved, for which it becomes relevant to monetize properly the ancillary services provided. In this paper, an accurate statistical analysis was performed on the day-ahead, intra-day, ancillary service, and balancing markets for the whole Italian power-oriented CCGT fleet. The profitability of 45 real production units, spread among 6 market zones, was assessed on an hourly basis considering local temperature, specific plant layouts, and off-design performance. The assessment revealed that net income from the ancillary service market doubled, on average, the one from the day-ahead energy market. It was observed that to be competitive in the ancillary services market CCGTs are required to be more flexible in terms of ramp rates, minimum environmental loads, and partial load efficiencies. This paper explores how integrating a Heat Pump and a Thermal Energy Storage within a CCGT could allow improving its competitiveness in the ancillary services market, and thus its profitability, by means of implementing a model of optimal dispatch operating on the ancillary services market.

E-Mobility Scheduling for the Provision of Ancillary Services to the Power System

In the present paper, the charging of an electric vehicles fleet is scheduled in order to provide power balance regulation to the electric grid. The starting of e-cars charging can be optimized according to predetermined limits set by users, in order to adjust the power exchange profile of the aggregated fleet. Ancillary services are sold on the Ancillary Services Market. Therefore, an analysis of the Italian Ancillary Services Market is provided to check the performance of the strategy proposed according to the actual market requirements. In this way, useful figures are provided to the reader in order to evaluate the technical and economic viability of the approach.